Question about 2000 Jaguar XJ

Open Question

Location of Crank Sensor on 2000 XJ8

Wont start - believe it could be sensor - where is it located???

Posted by on

6 Suggested Answers

  • 701 Answers

SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter

Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger

Posted on May 06, 2009

  • 50 Answers

SOURCE: crank position sensor location

you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!

Posted on Aug 18, 2008

  • 740 Answers

SOURCE: XJ8 Knock Sensor

Pretty Difficult you have to remove the complete intake and injector rail. You will need both side intake gaskets and the plenum gasket.

Posted on Dec 12, 2008

  • 1 Answer

SOURCE: Jaguar S type 4.2 V8

Map sensor is at the back of the intake manifold.

JMC Import Auto Repair
Tempe AZ

Posted on Dec 23, 2008

  • 2 Answers

SOURCE: knock sensor location

It's under the intake manifold. To access it you have to remove the manifold and injection rail.

Posted on Dec 30, 2008

  • 133 Answers

SOURCE: bad starting

Hi colin think you might have low compresions at this age of v8, try a search on: nickisil jag engines:  

Posted on Jan 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why 2000 jaguar xj8 wont start?. Had been sitting for a while but prior to that it did start but was running rough. I replaced spark plugs and knock sensors after pulling bunch of codes. Car cranks. F


Try this before you do anything else. Charge the battery up and then after you charge the battery connect a known good jumper battery to the battery in the car as though you are jumping off a car with a dead battery.

Oct 17, 2014 | 2000 Jaguar XJ8

1 Answer

Location of crank sensor 2000 jeep grand Cherokee 4.7 and how do you replace it


It's under the dash, go utube...type in location and repair of crank sensor for jeep, it will show you where and how to replace! All the best!

Sep 04, 2014 | Cars & Trucks

1 Answer

Engine diagram showing location of crank sensor on 2000 lincoln ls 3.9


Bottom of Transmission bellhousing
next to engine oil pan

Jan 22, 2013 | 2000 Lincoln LS

1 Answer

2000 v10 ford f350 wont start with out either


If the crank sensor circuit is malfunctioning, then that is your problem. The code does not mean that you must replace your crank sensor. (sometimes it means this, sometimes it does not) The code means that either the crank sensor CIRCUIT is out of range or the crank sensor cannot SYNCRONIZE with the cam sensor. There is a whole lot more to diagnosing a crank sensor circuit than simply replacing the crank sensor. Proper diagnostic procedures need to be followed to locate the exact cause of the problem.

Nov 18, 2011 | Cars & Trucks

1 Answer

Location of cam sensor


Cam Sensor is on the top of the Water pump located on the Front Timing cover. the Crank sensor is located rear the engine almost on the flywheel.

May 15, 2010 | 2000 Land Rover Range Rover

2 Answers

Where is the crankshaft position sensor located on a 2000 intrigu


Should be located around 11:00 on front of engine at crank pully.

Oct 28, 2009 | 2000 Oldsmobile Intrigue

1 Answer

Where ia the location of the crank sensor on my 2000 dakota 4.7


Hello max06197: My name is Roger and I will help. You will find the crankshaft position sensor mounted into the right rear side of the engine block. Just behind the freeze plug. Should you need further help please just ask. Please rate the quality of the answer. Thank You for using Fix Ya. Roger

Oct 26, 2009 | 2000 Dodge Durango

2 Answers

Car wont crank 1994 plymouth acclaim


Not sure what yor experiencing . Do you have crank no start or no crank no start? No crank no start is battery and cables issue. Crank no start is ignition , plugs, and fuel.

May 28, 2009 | 1991 Plymouth Acclaim

1 Answer

I NEED TO KNOW WHERE THE KNOCK SENSOR IS LOCATED IN A 2000 JAGUAR XJ8


hi,usual location is in the middle section of engine block,to sense which cylinder is knocking,ty

Mar 24, 2009 | 1995 Toyota Corolla

3 Answers

Wont start


crank sensor location

Oct 15, 2008 | 2002 Kia Optima

Not finding what you are looking for?
2000 Jaguar XJ Logo

Related Topics:

366 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...