Question about 2005 Ford Freestar

1 Answer

FUEL PUMP TO TO INSTALL A NEW FEUL PUMP FOR AN 2005, 3.9 FORD FREESTAR

Posted by on

  • Anonymous Mar 24, 2014

    car hesitates when driving, low milage output so want to relace feul regultor

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 21,949 Answers

Its in the fuel tank

Posted on Nov 18, 2008


Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codepo180 0n freestar


the fuel rail temperature sensor is actually part of the fuel rail pressure sensor, which is mounted on the fuel rail, on the intake manifold...it is a common problem on the Freestars and is easily acessible from under the hood, just to the left rear of the engine. The fuel rail pressure sensor costs about $75 from ford.


code po180

Read more: ford freestar sel: 4/2-------po180 fts error comes back after clearing - JustAnswer http://www.justanswer.com/ford/6lru6-05-ford-freestar-sel-4-2-po180-fts-error-comes-back.html#ixzz2EBsaZsPE

Dec 05, 2012 | 2005 Ford Freestar

1 Answer

What does a po180 code mean in a 2004 ford freestar van


the fuel rail temperature sensor is actually part of the fuel rail pressure sensor, which is mounted on the fuel rail, on the intake manifold...it is a common problem on the Freestars and is easily acessible from under the hood, just to the left rear of the engine. The fuel rail pressure sensor costs about $75 from ford.

Read more: ford freestar sel: 4/2-------po180 fts error comes back after clearing - JustAnswer http://www.justanswer.com/ford/6lru6-05-ford-freestar-sel-4-2-po180-fts-error-comes-back.html#ixzz2EBsaZsPE

Dec 05, 2012 | 2005 Ford Freestar

1 Answer

I am changing the fuel filter on a 2005 ford freestar, I want to know how to relieve the fuel pressure . do i just remove the fuel cap or is there a fuel pressure relief valve in the engine bay.


Please don't forget to rate! Thanks!

Relieving Fuel System Pressure

Locate the fuel pump relay in the engine compartment fuse block at location K4/C-1051. Remove the fuel pump relay. Start the engine and allow it to idle until it stalls. Crank the engine for 5 seconds to ensure fuel supply manifold pressure is released. When vehicle service is complete, reinstall the fuel pump relay and turn the ignition on to pressurize the fuel system. Start the vehicle and check the system for leaks.
// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 21; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]>

Jul 08, 2011 | 2005 Ford Freestar

1 Answer

2005 freestar, turn key on and fuel system won't pressurize. Spray a little starting fluid and van runs fine, system won't pressurize for initial start.


i would check the fuel filter if thats not it then it will most likely be the fuel pressure regulator make sure the vacuum line didnt fall off of it if that checks out then id say its your pump good luck i hope this helps

Jul 06, 2011 | 2005 Ford Freestar

1 Answer

2005 ford freestar serpinetine installation


You didnt specify the engine size, so this page shows exploded view of the 4.2 L engine.
http://www.justanswer.com/ford/0ch2v-install-new-drive-belt-2005-ford-freestar.html
Please rate this answer! Thanks, Mike

Jun 19, 2011 | Ford Freestar Cars & Trucks

1 Answer

2005 freestar driving down the road suddenly starts stumbling rpms drop and emission light comes on then dies. Scaned it but says nothing is wrong


The check engine light will always come on when the engine stalls.It could be your fuel filter needs replaced or your fuel pump is going out. The fuel pumps can heat up and stop working, then after they have a chance to cool off they will work just fine until they get hot again.

Sep 14, 2010 | 2005 Ford Freestar

1 Answer

04 ford freestar fuel pump remove


Support the fuel tank, loosen the clamps that hold the tank on, then lower the tank slow because you will have to unhook the fuel lines and the electrical connector before you can lower the tank down very far. Once the tank is removed you will find a lock ring that holds the whole assembly. carefully remove the ring and the pump should be able to be removed. When you put it back together be carefull with the large o ring seal when installing the new pump.

Jun 16, 2009 | 2004 Ford Freestar

1 Answer

2000 ford focus new feul pump new feul filter new feul pump relay car still want start


Try the crankshaft position sensor. Sometimes they get covered in clutch dust and the sensor cannot determine No1 cyl. and then it will refuse to start. Sometimes they go faulty as well.

Nov 22, 2008 | 2005 Ford Focus

Not finding what you are looking for?
2005 Ford Freestar Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...