Question about Mazda 323

1 Answer

In first gear not much power producing - 323 Mazda Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 243 Answers

Can you give alittle bit more information about the car. At cold/hot, what kind of engine/year?

Posted on Oct 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Volvo c30 cuts out if I accelerate to much in gear before changing it is a diesel


there is probably an over rev stopper in the system that is intended to stop engine destruction
It is poor driving practice to put the engine in this situation as it stresses the engine unnecessarily and really achieves nothing
diesel engine have a set torque range and under or over that range produces nothing in the terms of power and gear changing should be best kept to that range
If the transmission will not change gears at around 2500 rpms then have the fault codes read as there may be a problem electronically.

Jan 17, 2015 | Volvo Cars & Trucks

1 Answer

What causes engine vibration in 3rd and 4th gears?


When synchros go bad they will NOT cause a vibration. They will make a kerchunk noise when you try to shift to that gear. I know. I rebuilt my transmission (Type: W59) because of bad synchros in 2nd gear.

I would look for bad U-Joints, or a bad carrier bearing. This could also happen if you went to a tire size larger than 31x10.5. The 2.7L 3RZ doesn't produce enough HP to run 33's. It will bog down on a hill in 3rd. You could also have some bad half-shafts up front. If you keep the hubs locked they may be dragging you down.

Are your tires chopped?

May 05, 2014 | 1998 Toyota Tacoma

1 Answer

03 Kia Rio will not engage into drive when cold (Automatic)


This is a situation of low pressure,as you warm up the vehicle the transmission fluid is warmer which allow the torque convertor to produce pressure to collapse the clutch pack and transfer power for a shift gear,your solution is a torque convertor and a front pump

Mar 27, 2012 | 2003 Kia Rio

1 Answer

Loss of power and sputtering during acceleration until ready to shift into next gear. 2.2 engine. No check engine light. Seems to run fine until under power. Changed fuel filter but no help.


Sounds like you have a fuel pump problem, sometimes when they are defective it just does'nt quit it will not produce the pressure needed to get the fuel to the injection system when accelerating.

Mar 21, 2011 | 1996 GMC Sonoma

1 Answer

I have a 2001 trans am WS6 with 25,000 origiinal miles. I have a light whyning noise when car is warm. Changed transmission oil and gear oil. Noise still an issue. Could it be a power steering pump bearing...


If you believe that one of the "tins"(alternator, power steering, water pump etc) is defective use a stethoscope and place it on each item as the vehicle is ideling . The item that produces the noise is the culprit.

The other item that could make this noise is the oil pump inside of the torque converter. To test this place vehicle in all gears including park and neutral . If the noise is present in all gears regardless of speed its the pump.

Apr 17, 2010 | 2001 Pontiac Firebird

1 Answer

Power windows willl no longer work


if you press the button or switch and it makes a noise the window is off track or the little plastic gears are stripped. if you press the switch/button and no noise is produced, then its as simple as going down to the local hardware store and buying a fuse for it.
~Dan Herzberg~

Feb 19, 2010 | 1998 Mercury Mountaineer

2 Answers

The power light is on on the dash of a suzuki vitara v6 automatic. What does this indicate?


turn the power switch off for the transmission. It is not a warning light. It just indicates the power switch for the trans is on which lets the trans delay shifting in each gear so it allows the engine to get more RPM'S so it produces more HP and Torque.

Mar 06, 2009 | 1999 Suzuki Grand Vitara

1 Answer

Car starts then dies


I had the exact same problem with my vehicle...turned out to be a bad alternator. the car had been riding on pure battery power because alternator failed. Eventually the battery had 0 power left and produced the effect you are talking about where you push gas while in gear , and the transmission will slowly move the car but no power. I had alternator replaced and car is fine. Make sure you get battery fully charged with alternator(the battery charging should not cost anything)

Jul 25, 2008 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

The d4 light is flashing in myt 1996 honda accord and the car wont turn over??


HELP..HONDA ACCORD 2003 2.4 gear position indicator light is blinking ....rough idling,less power produce

Jul 23, 2008 | Honda Accord Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...