Question about 1999 Daewoo Lanos
Have just replaced head and we need to time it properly it is not a lanos but the model i need is not on your list it is a dewoo 1.5i 1994.
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2000 daewoo lanos head torque
the 2000 daewoo lanos 1.6L dohc head torque is as follows , step 1 = 18 ft. lbs. , step 2 = 70 degrees , step 3 = 70 degrees , step 4 = 30 degrees . sequence is as pictured .
there ya go , gears to the left , looking at the front of engine .
Posted on Jan 09, 2009
DTC 63 Will Set When
No voltage is supplied by the ECM through the EST “B” line while reference pulses are received by the ECM from the crankshaft position sensor
check white wire terminal B on ignition coil to ECM terminal C14 for open circuit or short to ground while disconnected if thats ok check for voltage signal at B while cranking no signal ECU faulty. voltage signal also on A terminal while cranking and check earth terminal C to body no higher than 5 Ohms
power is terminal D 12V
if getting power, earths good, and both signal voltages are going into coil pack, coil pack is faulty.
Posted on Jun 21, 2009
Tips for a great answer:
Nov 27, 2016 | 2000 Daewoo Lanos
Jul 20, 2014 | 1999 Daewoo Lanos
Sep 05, 2010 | 1999 Daewoo Lanos
Jun 05, 2009 | 1999 Daewoo Lanos
May 19, 2009 | 2000 Daewoo Lanos
May 19, 2008 | 1999 Daewoo Lanos
74 people viewed this question
Usually answered in minutes!