Question about 1996 Ford Taurus

1 Answer

Fuel pump fuse was blown , replaced it still didnt work. replaced pump,still doesnt work,is there any other fuses in between the fusebox and the pump?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

No. In your trunk, on the driver side, there is a little Red button. This is your E.F.C.S, Emergency Fuel Cutoff Switch. Almost every Ford vehicle from 1990 on is equipped with one. Go to your trunk and locate the switch, then push it in. Hopefully this should solve your problem. Good Luck.

Posted on Nov 03, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I replaced the fuel pump on my 1998 ford f 150 and it is not getting any power to the fuel pump I checked the fuses but didnt see any blown fuses

Fuel pump relay , maybe . Inertia fuel shut off switch tripped .Does the vehicle have spark ? No signal from the Crankshaft position sensor ,the PCM - engine computer will not energize the fuel pump relay . Video's on youtube ,testing fuel pump electrical circuit from the relay base , where the relay plugs into .

Dec 26, 2017 | Ford Cars & Trucks

1 Answer

Why doesnt my fuel gauge work on my 2011 ford

check for blown fuse and if fuse is good you will have to replace the sensor whick is in the unit with the fuel pump (it is all one unit and will have to replaced as such

Sep 01, 2014 | 2011 Ford Fusion

1 Answer

1984 nissan pup - hihg beams work but not low beams, dash lights out, tail and brake lights out, fule pump works. what the heck is going on?

main power issues .. check battery connections.. check fuseable link wires under hood,..check fuses in fusebox for blown fuses and check wiring harnes ground connections especially by the headlights..

Feb 10, 2013 | 1984 Nissan Pickup

3 Answers

Fuel not getting to intake

check to verify there's fuel pressure at fuel pump, always check for blown fuses first. if the fuel pressure is not present at the fuel rail then the pump is bad, providing that all fuses are good.

Apr 26, 2010 | 1992 Chevrolet Camaro

1 Answer

My 87 blazer died, changed fuel pump,rebuilt tbi. I have 1.2 ohms resistance on each injector. I'm getting no power to injector, changed pcm and still no power. Don't know what to check next.

Before you start self repairing, you really should by a manual with proper diagrams to prevent heading in wrong directions.
The PCM doesnt control injector POWER. It controls injector GROUND. The POWER comes from the ignition switch and goes thru a fuse in teh fusebox probably marked ECM1 or ECMa. If you have power at both sides of that fuse with the ignition key in the ON position, then you have a broken wire between the fuse and the TBI. If you have no power to that fuse, you may have a broken wire, blown fuse, or defective ignition switch.

Oct 03, 2009 | 1987 Chevrolet S-10 Pickup

1 Answer

Both electric rear windows do not operate


Thanks for using FixYa!

If the rear power windows don't work. Its possible that you have a blown fuse for the rear side windows. Open up the fusebox usually located under the dashboard. Check the fusebox manual. Locate the fuse for the rear power windows. check if the fuse is blown. Replace the fuse. im 98% sure that its just a blown fuse.

Have a wonderful day.
- HotRatchet

Jul 29, 2009 | 1999 Toyota Land Cruiser

2 Answers

Washer fluid pump not working

just pull out fuses one at a time and see if any are blown, if so just replace.

Dec 15, 2008 | 1999 Ford Explorer

2 Answers

1996 mustang fuel pumpswitch/ relay

The pump could be bad but probably not. If you go to, for 14.95 you can get all the wiring diagrams and repair procedures for you car. I absolutly love it. It's 14.95 a year per car I think but well worth it. You can actually save all the info to your computer for future use. If you replaced the pump you should be able to follow the info on ALLDATA

Jul 14, 2008 | 1996 Ford Mustang

Not finding what you are looking for?
1996 Ford Taurus Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5636 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides