How do you fix air injectors on a 1994 toyota corolla

images for AP number on Toyota corolla 1994

PDF]TOYOTA COROLLA 1994 MANUAL PDF

bestfilefinder.link/toyota-corolla-1994-manual.pdf

Free Download Toyota Corolla 1994 Manual At Our Library. TOYOTA COROLLA 1994... PDF, such as;. Title. Format. [Book] AP CALCULUS THIRD EDITION.

1.6 GLi COROLLA

DTC NUMBER TROUBLE AREA 12 RPM signal 13 RPM signal 14 IGN signal 16 ECT Signal 21 Oxygen sensor signal 22 Water temperature signal 24 Intake air temperature sensor 25 Air / Fuel ratio lean 31 Vacuum sensor signal 41 Throttle sensor 42 Vehicle speed sensor 43 Starter signal 52 Knock sensor 51 Switch COND

unplug and clean each of the injector plugs, blow them out with an air hose real good.

The reasons for poor acceleration could be as under:
1. Fuel pump control circuit.
2. Spark plug.
3. Ignition system.
4. Fuel Injectors.
5. MAP and IATsensor.
6. Electronic throttle control system.
7. Air induction system.
8. Cylinder compression.

try a simple fix of putting injector cleaner in the tank to clean the injectors
check for any loose body screws and panels

The following is from a Haynes manual for 1993-1996 toyota corolla and geo prism:

Code 14: ignition signal. No ignition signal to the ECM. Check igniter or circuit, ignition coil, ig. switch or circuit, ECM (engine control module or "computer")

Code 24: intake air temperature sensor. Open or short in the intake air temperature sensor circuit. Check intake air temp. sensor or wiring to ECM.

inlet manifold loose tighten all bolts, or air coming in , spray wd40 around the air intake if the revs go up, you have an air leak fix as required

Check the site glass for the AC refrigerant. If there are many big bubbles, you are low on refridgerant which could also mean there's a leak in the system

does it have a cold start injector seperate from the other injectors usually on the upper intake somewhere with a fuel line going to it

each injector has 2 wires, one should have positive when ignition on. the other wire goes to the ecu looking for a negative pulse. check the crank and cam angle sensors or distributor or wiring