Question about 1998 Chevrolet Cavalier

2 Answers

1998 cavaleir 1998 cav has no brake lights & no turn signal lights emergency flashers work as well as tail lights I haven't found any blown fuses either new bulbs on both sides of tail lights too

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 92' Chevy Cavalier and am having the same exact problem i've checked all the fuses and relays everything there is fine where do i need to look next someone please help.....

Posted on Mar 04, 2013

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Check relays and fuses under the hood............

Posted on Oct 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 S10. My rear turn signals work, emergency flashers work, and my 3rd brake light works, but my tail light brake lights don't work. What do I do?


Check for power and ground to the lamps. Most likely you have lost ground, since you replaced everything else.

Sep 09, 2014 | 2003 Chevrolet S-10

5 Answers

Signal And Brake lights


The flasher unit is located under the dash, near the steering column. This could also be caused by a faulty ground wire. Check the wiring for broken, bare, or loose wires or connections.

Jul 25, 2008 | 1998 Dodge Ram 3500 2WD

2 Answers

2000 jeep grand cherokee none of the rear lights work


Check BackUp Module, generally is located in the rear quarter panel (drivers side).

Dec 23, 2012 | 2000 Jeep Grand Cherokee

2 Answers

Need to replace the turn signal flasher. the dash lites & tail lights don't work.


It is located behind the fuse block on the driver's side. When you open the drivers door you can plainly see the fuse block. (marked "FUSES") Flasher is behind that. You have to get to it from under the dash. Take out panels under steering wheel. If you get your head down by the brake pedal you can see it.
When someone changed theirs, they took out the little bracket that holds it in and relocated it to a lower place - they clipped the flasher bracket onto the little access door closest to the emergency brake (on the panel that you have to take out). Luckily the wires were long enough to enable this, so if you have to change it again, it's a lot easier.

May 10, 2011 | 1995 Pontiac Grand Am

1 Answer

I have a 98 eclipse. I was putting new tail lights on and then the signals stopped working along with the brake lights. the fuse to the brake lights had burnt so I replaced it. The signals however are...


IF THE TURN SIGNALS STILL WORK IN THE FRONT, THAT MEANS THE FUSE & THE FLASHER ARE OK. IF THE SIGNALS DON'T WORK AT ALL CHECK TURN SIGNAL FUSE & STOP / BRAKE FUSE. ARE YOU SURE THE CORRECT BULBS ARE BEING USED?

Jan 24, 2011 | 1998 Mitsubishi Eclipse

2 Answers

I have a 2001 chevy cav, and my turn signal are intermittent, the hazard lights work.. if its a relay switch were would be located?


Try the flasher unit inside the fuse box... I cant remember, but some cars have different unit for signals and hazard lights...

Jan 28, 2010 | 2001 Chevrolet Cavalier

2 Answers

Brake lights quit working on the driver and passenger sides but the top middle lighgt works.running light and back up lights work no blowns fuses good bulbs. very puzzeling!


I recently had this problem,it appears to be in the emergency flasher button.at first no brake lights but center one worked. the emergency button was stuck and hard to move but once i got it loose i had all brake lights, so thinking my problem was solved i checked all lights and then found i had no signal lights, i went bach to the flasher button because it was still very hard to move and pressed down further and all lights work now so i think this will cure most turn and brake signal problems. the flasher button is rarely used and collects dust so it starts to stick and when you dust your dash or bump the button it will stick between contacts and the lights stop working. hope this helps!!

Jul 27, 2009 | Pontiac Montana Cars & Trucks

Not finding what you are looking for?
1998 Chevrolet Cavalier Logo

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...