Question about Mitsubishi Galant

1 Answer

I went an got a diagnostic check on my car an the computer read P032 cylinder misfire on #2

Posted by on

  • yadayada
    yadayada May 11, 2010

    Then you need to figure out why #2 cylinder is mis-firing, do you agree? no magic bullet just tests

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

Check the #2 spark plug wire for corrosion and crakes. take it off the coil and off the spark plug and start from there. that is most likley your problem

Posted on Oct 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes misfires?


If the misfire is on one a particular cylinder or perhaps 2, these issues need to be addressed and checked...
1. Power to the spark plug.
2. Coils and spark plug condition.
3. Fuel supply to the cylinder
4. Air supply to the cylinder
5. Correct fuel/ air mixture to the cylinder
6. Cylinder compression. Low compression or a cylinder compression level below spec will result in a misfire. If the compression tester shows low compression in a cylinder the causes of the poor compression reading then need to be addressed.

The fault codes generated by the computer and read by an appropriate scanner will tell you which cylinder or cylinders are misfiring.

Nov 14, 2015 | Cars & Trucks

1 Answer

2008 mercury milan misfires


take it back to the dealer they didnt install the coil or electric distubutor properly because of the misfire its causes o2 sensor to give bad reading .

Apr 26, 2012 | Mercury Milan Cars & Trucks

1 Answer

Have misfire, code P0316, any ideals? 86,000 miles on


2004 Marauder and 2003-2004 Mustang vehicles built before 12/19/2004 equipped with 4.6L 4V/5.4 4V engine may exhibit a runs rough, lacks power, and engine misfire, prompted by a MIL light and DTC codes P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, and P0316.
ACTION
Diagnose engine for engine misfire concern. If diagnostics determine an engine misfire which is characterized by leakage through exhaust valve(s), only replace the affected cylinder head(s).
SERVICE PROCEDURE FOR VEHICLES WITH RUNS ROUGH/MISFIRE CONDITION:
1. Perform relative compression check on all cylinders. If abnormal, check cylinder leakage and actual compression for "low" cylinders refer to Workshop Manual (WSM), Section 303-00.
2. If leakage/compression check indicates a valve train concern, per valve train diagnostics in WSM, Section 303-00, replace cylinder head and cam assembly, pipe plugs and timing chain tensioner, per procedure outlined in WSM, Section 303-01.
3. If cylinder leakage and compression tests are inconclusive, perform misfire diagnostic, per TSB 05-22-8.

So

Feb 26, 2011 | 2004 Ford Freestar

1 Answer

I have a '03 Toyota Celica GT-S with a annoying mis-fire. Started small by replacing all spark plugs - nothing. Replaced the MAF sensor - nothing. Took it to a authorized toyota shop & checked...


Replaced the MAF sensor - nothing. Took it to a authorized toyota shop & checked compression which check out good and put the computer on. Computer read mis-fire on cylinder 1, and then multiple misfire (like it would jump around). We went ahead and replaced the fuel injector on cylnder 1 - did not solve problem as when we hook the computer up, misfire seemed tp stay at idle and seem better when running high RMP, but check engine light is on as it never went away. Went ahead and replaced the coil pack to cylinder 1 - nothing. what am i missing?

Feb 06, 2011 | 2003 Toyota Celica

1 Answer

How much will it cost to fix cylinder 2 misfire?


i don't know how match the cost, but it will he you, first change the position of the ignition coil to another coil also the spark plug, read the misfire code is it P032 or replace the code, if on cylinder 2 again appear the misfire check the compression, if ok go to electrical and check wires go and from to cylinder two coil to pcm, check the ground on #2 coil, if all this ok, see the difference reading by multi tester to coil reference if all good, reprogram your pcm, or replace if necessary

Aug 02, 2010 | 2006 Hummer H3

1 Answer

Error code cylinder 2 misfire also did a


It is most likely a valve not closing,check the valve springs on that cylinder.

Jul 30, 2010 | 1995 Ford Escort

1 Answer

My 2002 Lincoln LS engine light went off. So, I conducted a diagnostic check and it read a misfire of the piston...


Cahneg the plug and cable to that cylinder, if that does not help, get it in for a compression and injector test !

Dec 28, 2009 | 2002 Lincoln LS

2 Answers

1999 Chevrolet Suburban cylinder 3 misfiring?


P0300 is a multiple cylinder misfire and is used by all OBD2 vehicles on the road in the USA that is 1996 and newer, P0301 is cylinder number 1..P0302 is # 2 and so on...that tune up may have been needed and parts and labor are expensive..you have a cylinder that is misfiring and the cause must be located..possible causes are intake manifold air leaks..secondary ignition problems..fuel injectors..plugged EGR system if it has one..failed head gasket..burned or cracked valves..I have seen some crazy stuff..you need a tech on that one not a mechanic.

Sep 06, 2009 | Chevrolet Suburban Cars & Trucks

2 Answers

Misfires and codes PO316, PO306, & PO305 popped up on the diagnostics check. What needs to be fixed based on that?


You will need to replace no 5 and no 6 coil pack and spark plugs. P0316 is random missfire that computer could not detect the cylinder that was causing it,just knew one was missfiring.
Coil packs are common concern on these vehicles. Can get oil leak into the coil pack wells and may also even get moisture into them.
If yours is a 3.9L it may be involved in owner satisfaction program 07M07 or 07N09 in which they will cover them under the program for up to 10yrs or 100000 miles which ever comes first.

Mar 16, 2009 | 2003 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...