Question about 2006 Ford Freestar

1 Answer

Started missing when i step on the gas peddle

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,431 Answers

This is what they call a stumble or hesitation under load.When you accelerate the vehicle there is a demand for more fuel more spark ,more air.The ignition system should be inspected especially the boot of the spark plug for wear causing spark to seek ground.

Posted on Feb 25, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It starts missing out and has dead spot in peddle


I don't know what you have but a jeep ,so did you check (TPS) throttle position sensor

Sep 21, 2014 | Cars & Trucks

5 Answers

Brake and gas peddle


U should pull the break strap it may balanced the height.

Jun 17, 2008 | 2008 Ford F-350

1 Answer

Why does the car raddle when i press the gas peddle on a 1999 chrysler sebring


check your exhaust system it might be the source of the noise

Jun 16, 2014 | 1999 Chrysler Sebring

1 Answer

2002 dodge ram won't start if you step on gas peddle before starting it. What causes this? If you wait a couple of hours it will then start


Fuel injected engines don't need to be pumped before starting, if you do flooding can occur. Make a conscious effort NOT to touch the pedal until after you turn the key to the start position and the engine actually starts.

Apr 04, 2014 | 2002 Dodge Ram Maxi

1 Answer

No power when stepping on gas peddle


I assume you mean the gas pedal?

Mar 07, 2014 | 1993 Lincoln Town Car

1 Answer

2006 chrysler sebring/check engine light stays on car jerks while driving


Sounds like a basic miss or fuel problem.
Have you had the computer scanned for trouble codes ?

Apr 09, 2013 | 2000 Mitsubishi Galant

1 Answer

How do i bleed clutch on 2000 trans am ws6 ram air


I\'m assuming this is the one with the 5.7L LS1 V8. Ok, bleeding the clutch is real no different than bleeding your brakes. Locate our slave cylinder.(Not the reservoir) In most cases, it\'s best to start with a gravity bleeding. Make sure the reservoir is full, loosen the bleeder on the slave cylinder, until you have a steady stream coming out. Then tighten the bleeder, and check the peddle.SUCKAUTION**** MAKE SURE THE BLEEDER VALVE IS TIGHTENED AND CAP IS ON THE RESERVOIR BEFORE YOU TOUCH THE CLUTCH PEDDLE!!! AS MISSING THIS STEP WILL **** UP AIR INTO THE LINE.Step 2, have a friend sit inside the car, and continuously pump the clutch(like bleeding brakes) about 10 pumps should do it. Have friend hold the peddle to the floor and announce that it is to the floor. ***They must hold the peddle to the floor*****while they are holding the peddle, loosen the bleeder valve until fluid comes out. repeat process until no micro bubbles come out, just clean fluid. Finally, remember to top off your fluids after bleeding, as you will naturally loose some in the process. Hope this helps. ^^

Mar 27, 2013 | Cars & Trucks

1 Answer

WHEN YOU STEP ON THE GAS IT STARTS MISSING UNTIL YOU LET UP AND APPLY THE GAS PEDDLE REAL SLOW AND EASY USING A LOT OF FUEL


BAD NEWS FOR YOU,BUT!!!,CAR NEEDS TO BE CHECKED FOR FUEL PRESSURE,ECT,NEEDS TO BE SCANNED,GOOD LUCK

Apr 05, 2010 | 2001 Pontiac Grand Am SE

1 Answer

Ford escort 1989 increases its speed without stepping on the gas


First guess is that a motor mount is broken and lifts one side of the motor just enough to pull on the throttle cable.
Second guess is that the cable return spring is broken or missing. It pulls the injector throttle body lever closed when the gas peddle is released.

Oct 15, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2006 Ford Freestar Logo

544 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...