Question about 1986 Nissan King Cab

1 Answer

How can i pull trouble code without a scanner on my 86 nissan truck

Truck runs good but while travling at a coast or going down hills it boggs slightly..ive changed the fuel still does it..

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Nissan Master
  • 1,871 Answers

Hello! go to the link below for instructions on code reading for your vehicle...also has list of all codes for OBD 1...


Posted on Feb 25, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my car have trouble switching gears?

P0730 is your problem code for incorrect gear ratio, this is usually due to a bad clutch pack in the transmission, meaning it needs rebuilt or get a remanufactured one.

Jan 03, 2016 | 1998 Honda Accord

1 Answer

Need to clean throttle body

check the fuel pressure at the fuel manifold --pump--regulator --filter and that will affect the injector operation. run fault codes and check for canister purge valve problems .

Mar 23, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

No power uphills

Have you checked base fuel pressure with a gauge ?

Feb 23, 2014 | 1993 Nissan Pickup

1 Answer

I have a Nissan Sentra XE 2000 Ocasionally gets an overdrive light, the car boggs down, and won't move. When the light goes out it will run ok. but it comes and goes intermittently. More now than then....

start with scanning your system with CONSULT2. unfortunatelly this tool is only available at your friendly nissan dealer. generic scanners are not capable of retreiving codes from trans modules/components unless you have a more expensive scanner such as SNAP ON SOLUS or something similar. small scanner for $50 bucks from auto parts store usually doesnt read trans codes. engine codes only. if your O/D loght is flashing that means transmission issue. could be the solenoid pack on the valve body other elecrical component or convertor failure. have it scanned for codes first. then let mr know ehat the number is for the code.

Sep 19, 2011 | 2000 Nissan Sentra

1 Answer

No power when going up hills, tries to overheat when going up hill. air conditioner only works when on high. gas gauge says full when tank is empty.

Run scanner for trouble codes, some auto parts stores will do this for free,check coolant level, check fuel pump level,  you will probably have to pull it from tank.

Oct 02, 2009 | 2002 Chevrolet Impala

1 Answer

The engine boggs down at high rpm. For instance, hesitates and boggs down when going up a hill or highway speeds. Idles normally and runs fine at low speeds.

if the fuel filter hasn't been changed do so, if the fuel filter is ok and has been changed out due to this problem you will need to monitor the fuel pressure under a load and make sure it doesn't drop below 45 PSI, it it does you will need to replace the fuel pump and the fuel filter. U also do say if you have a check engine light or have had the system tested for trouble codes that may be triggered by this loss of power problem.

Sep 08, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

Won't start! Doesn't seem to register it's in PARK or Neutral.

Pull the starter and, have the starter solenoid checked

Jun 01, 2009 | 1993 Nissan Pickup

2 Answers

2003 Chrysler Sebring (59,000) miles bogging down

pull the code and see what the code in the computer says. when is the last time the fuel filter has been changed?

Apr 29, 2009 | 2003 Chrysler Sebring

1 Answer

Losing power/acceleration on hills

Change or clean the EGR valve and install a new catalytic converter.
This should take care of the problem.

Mar 20, 2009 | 2002 GMC Savana

Not finding what you are looking for?
Cars & Trucks Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

79024 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides