Question about 2006 Jeep Grand Cherokee

Open Question

How do I replace fuse for dash lights of 2006 jeep grand Cherokee

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 20 Answers

SOURCE: 2001 Jeep Grand Cherokee which fuse controls heated seats?

Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.

CLICK_HERE

Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.

Posted on Nov 20, 2008

  • 90 Answers

SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE

remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly

Posted on Jul 03, 2009

  • 5 Answers

SOURCE: my 1990 jeep cherokee dash lights fuse blows

it might not be that. check your headlamp relay. i know sounds weird but just do it. when i bought mine it had already been replaced with the wrong one so it kept blowing it and the radio. replaced with stock part and just like that no more problems. hope it helps

Posted on Aug 01, 2009

techbuster
  • 5081 Answers

SOURCE: shift indicator light 1999 Jeep Grand Cherokee

There are two parts to it, a voltage resistor, and the EL panel itself.

You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.

There are a total of 6 flat screws, and 3 self tapping screws you have removed.

Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.

Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.

Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.

Re-install everything in the opposite order.

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 jeep grand cherokee BCM problem


I HAD A 1996 JEEP GRAND CHEROKEE BUT SOLD IT. I NEVER HAD A PROBLEM WITH IT. I REPLACED IT WITH A 2006 JEEP LIBERTY AND WHILE DRIVING IT TO TAMPA ALL TROUBLE DASH WARNING LIGHTS CAME ON THE A.C. CLUCH DISENGUAGED AND BLEW HOT AIR. THE HEADLIGHTS WENT OUT AND I HAD TO TURN THEM OFF AND BACK ON EVERY 30 MINUTES. EVERYTHING I LOOKED UP ON THE INTERNET TOLD ME TO REPLACE THE BCM. BUT THEN I FOUND A POST THAT TOLD ME TO CHECK FUSE NUMBER 13 WHICH I DID AND IT WAS BLOWN FUSE. IT IS MY OPINION ITS A FUSE. SOMETHING DRASTIC HAS TO HAPPEN TO YOUR VEHICLE BEFORE YOU HAVE TO REPLACE A MAJOR PART. TRY THE FUSES FIRST. REFER TO YOUR OWNERS MANUAL TO FIND THE FUSE FOR THE BCM.

Jun 29, 2014 | 1995 Jeep Cherokee

1 Answer

97 jeep grand cherokee ltd 5.2l trans not going into gear


power and eco modes?
---

about lights out issue:
dash lights and all other interrior lights connected to fuses inside fuse box. fuse is blown.

please check fuses #7 #16 and #17 (cluster, courtesy lamp,radio illumination)

Nov 20, 2011 | 1997 Jeep Grand Cherokee

1 Answer

The rear parking sensor fuse is out, do you know location of fuse? 2006 jeep grand cherokee 5.7


The sensors are behind the rear bumper fascia, not sure about the fuse, the fuse box is under the dash left of the steering wheel, trying to sort through service manual now, you can grab one from promanuals.net for around 20 bucks though. Has complete component locations, over 7000 pages.

Sep 26, 2009 | 2006 Jeep Grand Cherokee

1 Answer

The lighter and dash lights on our jeep grand


u can use wire prob and tap back of fuses on metal contacts and whe it doesn't like on both side it is blown pull and replace

Jul 06, 2009 | 1995 Jeep Grand Cherokee

1 Answer

2006 Jeep Grand Cherokee Tailight


There is a seperate fuse for both the right side and left side lights. Check the 10 amp fuse under the hood.

Apr 28, 2009 | 2006 Jeep Grand Cherokee

2 Answers

2006 cherokee dash lights replacment?


Check the Fuse Panel with a Really good Flashlight. You will be able to Find the Blown Fuse Easier this way. There is also a Fuse Relay Panel Under the Hood, Check these Also. Please Rate My Response! Thanks!

Feb 07, 2009 | 2006 Jeep Grand Cherokee

1 Answer

Dash lights for Traction control, BAS, and EPS stay on for a Jeep


I ahve the same problem plus stalling. Dealer wants to replace 3 different modules and change me $800. what was your solution?

Nov 12, 2008 | 2006 Jeep Grand Cherokee

Not finding what you are looking for?
2006 Jeep Grand Cherokee Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...