Question about 2007 Chevrolet Tahoe 5.3

Open Question

2007 chevy tahoe, replaced throttle body and did relearn procedure. The truck will idle at 2,000 RPM. what should i do next?

Any solutions? when in gear it idles normally

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 9 Answers

SOURCE: 2007 Chevy Suburban 1500LS

It will take a few miles of driving for the ECM to catch up to the new throttle body. Assuming it was an OEM replacement, its cleaner than the old one, so the air flow is different. 20 minutes of driving should do the trick...if it doesn't then you have a different problem.

Posted on Jul 03, 2009

Ad
csmock132
  • 4669 Answers

SOURCE: 87 chevy truck with TBI idles too fast

Spray the intake with carb cleaner to find the vacuum leak. Check where the EGR mounts and the throttle body gasket sense you had both off.

Posted on May 10, 2009

  • 532 Answers

SOURCE: vaccum hose diagram for 88 chevy truck

it may not be a vacumn leak from a line,check the throttle shaft for movement,for example,i had a 89 1 ton 350 and my throttle shaft was moving around a lot and in order to keep it from idling high,i had to kick the throttle pedal.But also check the idle air control valve,which is the round sensor on the side of the throttle body.

Posted on Sep 11, 2009

  • 12650 Answers

SOURCE: 2007 chevy tahoe driver side door handle will not open door

the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix

Posted on Mar 13, 2010

Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How to fix a dtc p0507?


A vacuum leak Leaking air intake after the throttle body EGR valve leaking vacuum A faulty positive crankcase ventilation (PCV) valve Damaged/failed/dirty throttle body Failed EVAP system Failed IAC (idle air controller) or faulty IAC circuit

Sep 28, 2015 | 2005 Nissan Altima

2 Answers

How do I adjust the throttle body


The throttle bodies on most newer cars are not adjustable for its idle speed. If the Check Engine Light is on, go to the nearest auto parts store and get them to pull the error codes from your car's computer. Post the codes back here and we can give you a better answer to your question

Mar 22, 2015 | 2007 Toyota Corolla

1 Answer

2004 chevy colorado throttlle body relearn


I haven't done a throttle relearn. All I have done are plug and play. Ecm controls the throttle thru the pedal position sensor. I've done up to 2010 so far, on various makes and models.

Oct 11, 2014 | 2004 Chevrolet Colorado

1 Answer

I have a 2007 Chevy Tahoe i cleaned the throttle body and when i start the car and press the gas the RPM goes really high and it takes a while to go down


Get a can of brake clean/carb cleaner and spray all of your vacuum lines if it revs up, you found the problem.

Dec 30, 2012 | 2007 Chevrolet Tahoe

1 Answer

2007 CHEVROLET SILVERADO 4.8 HIGH IDLE


You need to check for intake vacuum leaks. Also did you have the battery disconnected before repair, if not disconnect the neg cable for 10 minutes to reset system to base settings.

Oct 08, 2012 | 2007 Chevrolet Silverado 1500 2WD

2 Answers

Shifting from drive to neutral rpm remains high


Take it to a qualified repair shop , Thinking ??? Also was thinking the MAF sensor or Intake Air sensor might be faulty . TESTING IS THE WAY TO A PROPER FIX !!!!!

Apr 04, 2017 | 2006 Saturn Vue

1 Answer

P507 buick regal 1998


P0507 - Idle Air Control (IAC) System RPM Higher Than Expected

This P0507 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM. In the case of GM vehicles (and possibly others) if the idle speed is over 200 rpm higher than expected, this code will be set.

Potential Symptoms: Most likely you'll notice the idle speed is higher than normal. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0507 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* Leaking air intake after the throttle body
* EGR valve leaking vacuum
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Failed EVAP system
* Failed IAC (idle air controller) or faulty IAC circuit

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect the intake air system for air or vacuum leaks and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

If you have an advanced scan tool that can interact with the car, command the idle higher and lower to see if the engine responds appropriately. Also check the PCV valve to see if it's blocked and needs to be replaced. Check the IAC (idle air controller) if equipped, verify it's operation. If available, try swapping in a new throttle body to see if that fixes the problem. On Nissan Altimas and possibly other vehicles the problem may be fixed by having the dealer perform an idle air relearn procedure, or other relearn procedures.


Hope this helps; keep us updated.

Feb 04, 2011 | 1998 Buick Regal

1 Answer

05 FOCUS P0-507 CODE


P0507 - Idle Air Control (IAC) System RPM Higher Than Expected

This P0507 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM. In the case of GM vehicles (and possibly others) if the idle speed is over 200 rpm higher than expected, this code will be set.

Potential Symptoms: Most likely you'll notice the idle speed is higher than normal. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0507 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* Leaking air intake after the throttle body
* EGR valve leaking vacuum
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Failed EVAP system
* Failed IAC (idle air controller) or faulty IAC circuit

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect the intake air system for air or vacuum leaks and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

If you have an advanced scan tool that can interact with the car, command the idle higher and lower to see if the engine responds appropriately. Also check the PCV valve to see if it's blocked and needs to be replaced. Check the IAC (idle air controller) if equipped, verify it's operation. If available, try swapping in a new throttle body to see if that fixes the problem. On Nissan Altimas and possibly other vehicles the problem may be fixed by having the dealer perform an idle air relearn procedure, or other relearn procedures.

Hope helps (remember comment and rated this).

Aug 05, 2010 | 2004 Ford Focus

Not finding what you are looking for?
2007 Chevrolet Tahoe 5.3 Logo

Related Topics:

878 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...