Question about 2003 Jeep Grand Cherokee

Open Question

2003 jeep grand cherokee, stalling\

My wifes jeep grand cherokee stalls on her as she is driving. the tach dottoms out and the jeep stalls.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1997 Jeep Grand Cherokee Stalling

Best thing to check is your fuel filter. After sitting for a little while, it will allow fuel through it but when you put a demand on the system, it cant supply enough and will sputter and die. Its easy to replace and very inexpensive. If it continues after that, you will at least know it was eliminated and can move from there.

Posted on Aug 24, 2008

  • 1 Answer

SOURCE: rough idle stalls at low rpm's

check your transmission fluid,the motor will stall when fluid is low

Posted on Mar 24, 2009

  • 7 Answers

SOURCE: where is the pcm on 1997 jeep grand cherokee 6 cyl?

I don't think the PCM is your problem, is the check engine light on? It could be you idle air control motor this is located on the throttle body, but because this happens while driving I am thinking you will need to replace your crank shaft position sensor it is located on the transmissinon bell housing it is very hard to replace without the correct tools. If the check engine light is on take it to a local auto parts store and ask if they can check the check engine codes for you they usally will do this for free.

Posted on Jun 03, 2009

  • 6982 Answers

SOURCE: 2005 jeep grand cherokee 4.7

Check and clean the idle control solenoid and passages, check the throttle position sensor and perhaps the crank sensor. Don't buy anything without testing or you will be spending money on stuff you don't need.
If stumped, get a chiltons or haynes manual and go through the test procedures they outline. Any good shop does this and you should too!
If it tends to stall that tells me that the iac is possibly opening late (sticking) but that can also happen if it gets bad information from the control system. (where testing is important)

Posted on Oct 07, 2009

  • 5763 Answers

SOURCE: 2003 Jeep Liberty Stalls

thats correct, may have bad ecm (computer) or bad wire to crank sensor from ecm, also ive run into this problem and it was the new sensor i put in was no good and aftermarket,also cam sensor can do this, and also make sure the 5 volt feed wire is good,good luck hope this helps.

Posted on Oct 13, 2009

Testimonial: "It ended up being the cam sensor. Thanks for the info. Fixed it right up."

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my 2003 jeep grand Cherokee cuts off when I put it in reverse

engine stalls.?
what cuts off, the radio:?

transmission slips (cuts has no real meanings, to vague)
makes odd noise.
does car drive perfect in DRIVE (other shoe drops)

Mar 06, 2015 | Jeep Cars & Trucks

1 Answer

Trouble code po351 engine stalls, tach also goes

Feb 09, 2010 | 1998 Jeep Grand Cherokee

1 Answer

2003 Jeep Grand Cherokee Stalls and won't restart right away....wait a couple minutes and will fire check engine codes...only does it about once a week....

Do you have the 4.0 liter inline 6? The CPS (crankshaft position sensor) can cause this kind of behavior. I've been lucky driving 4.0 powered Jeeps since 1989 and not had a CPS go bad but lots of other Jeep owners have. I would check the CPS first but it could be other things. Solving a stalling problem online is difficult.

Nov 02, 2009 | 2003 Jeep Grand Cherokee

1 Answer

When i start engine in 2003 jeep it want stay started .

sounds like either the sock on your fuel pump might be cloged or something more serius your cracnk shaft position sensor is gone. or the map sensor is not sending the right mixure of gas n air

Sep 09, 2009 | 1993 Jeep Grand Cherokee

1 Answer

While I'm driving my car, it seems to slip out of gear while coasting and my tach drops to zero and it sometimes stalls. What could be causing this?

check for a loose wire around the coil area push them all on tight, and look for dirty or rusty wire conectors

Jul 02, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Stalls when driving or idling

it could be a vacuum leak try and get a vacuum gauge and see if it reads like it suppose to

May 21, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Jeep Grand Cherokee Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides