Question about 2007 Dodge Caliber SRT4 Hatchback

Open Question

Where is the tipm located on a dodge caliber

Where is the tipm located

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: where is the tipm located

I quote from the service manual:

"The Totally Integrated Power Module (TIPM) is a combination unit that performs the functions of the Power Distribution Center (PDC) and the Front Control Module. The TIPM is a printed circuit board based module that contains fuses, internal relays and a microprocessor that performs the functions previously executed by the FCM. The TIPM is located in the engine compartment, next to the battery and connects directly to the B+ cable via a stud located on top of the unit. The ground connection is via electrical connectors."


This link also provides interesting info on reflashing (re-programming) Dodge Ram TIPM module.


Regards.

Posted on Jul 25, 2009

Testimonial: "THIS WAS VERY HELPFUL"

Ad
  • 412 Answers

SOURCE: Needing to locate the airbag control module '07 caliber

it is located behind the floor shifter in center console..under small piece of carpet

Posted on Jun 20, 2009

taran_2005
  • 10515 Answers

SOURCE: Dodge caliber tipm failed? Left rear signal light

Hi,

If you've taken it out before you will have no problem replacing it. No programming is needed or anything like that.

The only place you'll be able to get one is your dealer. It will have to be ordered using your VIN number so it will be configured with all of your specific vehicle's options. There is a module inside the TIPM that controls most of the electrical features on your car and it's programmed VIN specific before it leaves the factory.

he first thing I would recommend doing is removing the positive cable that goes to the TIPM, clean and check the connection. Disconnect the battery first. Clean any corrosion you find at the TIPM or the terminal side and see if that helps.

If not, I would next wiggle test the positive cable at the TIPM and see if it will act up. Turn on some high loads, like the blower motor on high and the headlamps, wiggle the cable behind the terminal's crimp and watch for a change in the headlamps or blower motor speed.

If you don't see anything there then I would next pull the TIPM up and look for any wiring problems, remove the electrical connectors and check for any terminal damage or corrosion.

I believe you will probably not find any external problems and it's going to be an internal problem in the TIPM itself and replacement is the ONLY option.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Posted on Jan 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the flasher signal located in the 2007 dodge caliber?


It's controlled by the totally integrated power module .electronic control module . Defective TIPM Is Causing Dangerous Power Problems in Chrysler Vehicles Dodge Ram Turning Signal Electrical Problems Do you know basic automotive electrical trouble shooing ?

Jan 04, 2017 | Dodge Cars & Trucks

2 Answers

I have a 2007 dodge caliber 2.0L the low beam headlights work but the high beams do not cant find a relay or a wiring digram how to fix them


There isn't a relay , headlamps are controlled by the TIPM - totally intergraded power module (electronic module ) Dodge TIPM low beam repair Same for high beam

Aug 25, 2016 | Dodge Cars & Trucks

1 Answer

What fuse is the horn fuse on a 2007 dodge caliber


The horn system operates on battery current received through the Totally Integrated Power Module (TIPM). A signal is received by the TIPM from the Cab Compartment Node (CCN) over the Controller Area Network (CAN) Bus when the horn switch is pressed, and the horn(s) sound(s). The horn system circuit is designed so that the system will remain operational, regardless of the ignition switch position.
There is no dedicated fuse for the horn.

Use a test light to check for power at horn to see if you have power.



eb5d9b72-4d53-427e-a4e0-308ffa44a181.jpg Auto Repair Help US

Sep 06, 2014 | 2007 Dodge Caliber 2.0

1 Answer

Can anyone help with a 2007 dodge caliber sxt 2.0 it loses comm with computer it also has a po700 161b and the etc light flashing and wont take gas


This one is simply complicated it could be corrosion in several different areas such as the wiring harness in the left fenderwell. the wiring to the "TIPM" totally integrated power module, or a simple software update (not likely) OR what i think the problem is, assuming the above is all checked and ruled out the TIPM itself could be bad. this is a VERY COMMON problem. As an automotive electronic rebuilder i see these a lot from 2006 up 2012 for the same issue if you'd believe it. hope the info helps. Tim

May 15, 2014 | 2007 Dodge Caliber SXT Sport Hatchback

2 Answers

Instrument panel


There's a fuse that controls the instrument panel. Don't know the location it should be in owners manual.

Aug 14, 2017 | 2010 Dodge Caliber

1 Answer

All fuses are good on Dodge 2008 Caliber. Changed rear signal and backup bulbs for good measure. Still the tail lights don't come on. Dash lights flicker but don't come on. Open circuit near was...


You have no clue of the complexity of these systems , controlled by the TIPM - totally integrated power module . Your best bet would be to take it to the dealer . Recall on TIPM . You do not have the knowlede to fix this .
http://www.dodgeproblems.com/trends/tipm

Mar 01, 2018 | 2008 Dodge Caliber

1 Answer

WHERE IS THE TIPM LOCATED ON DOGE CALIBER


TIPM = Totally Integrated Power Module This is a $900.00 part and it must be tested with a scanner before it can be condemmed as defective.

Feb 24, 2012 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Where is the low beam relay located on my dodge caliber


2007 Dodge Caliber is not equipped with a "low beam relay" that is user - servicable. The headlamps on that vehicle are controled by the Totally Integrated Power Module (TIPM).
To diagnose the headlamp circuits, it is necessary to use a scan tool that is capable of two-way interactive communications with the computer network in your vehicle.

Nov 24, 2011 | 2007 Dodge Caliber SXT Sport Hatchback

Not finding what you are looking for?
2007 Dodge Caliber SRT4 Hatchback Logo

Related Topics:

981 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...