Question about Cars & Trucks

Open Question

How to change landrover defender tdci fuel filter

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 275 Answers

SOURCE: car won't start after changing the fuel filter

you might have to just crank it when you change the filter it has to fill it back up so keep tryin and spray some ether in the intake if it starts you just not gettin fuel yet

Posted on Nov 17, 2008

alicantecoli
  • 22095 Answers

SOURCE: my ford focus 1.8 tdci has no power and misfiring when driving?

you left something loose on suspension,what ?? i dont know could be anything as a drop link is something iam not sure about whats it called in queens english please so i can advise ,lower track control arm ,track rod end,anti roll bar ???brake caliper loose ???as for loss of power ?? it depends on year as to weither you have common rail injection system or not .fuel filter is obvious also gauze filter on pick up inside tank.

Posted on Jan 27, 2009

pumpkinman
  • 1144 Answers

SOURCE: Low Fuel Pressure on Landrover Freelander TD4

causes .bad filter,gas line leak,tank leak call dealer to find aux pump.bad gas.i had a truck i replaced the in tank fuelpump 5 times one week they were all bad. could be as simple as your gas cap? any check engine lights on?

Posted on Oct 07, 2009

BCAS1298
  • 3092 Answers

SOURCE: Ford focus 2008 tdci 1.6 changed the fuel filter

Just make sure that the outlet on the fuel filter is pointing toward's the front or to injector's. There is no air to be bleed out of fuel system, just turn key and fuel system will pressureize, also check your fuel cut off switch might be located at driver side kick panel, will have a round cover with fuel shut off on it. good luck, hope this was helpful.

Posted on Dec 08, 2009

  • 5370 Answers

SOURCE: one cylinder misfiring after changing timeing belt for my landrover defender 110

Check the help link,click the link below for troubleshooting :----Misfire on cylinder? http://schematicsdiagram.blogspot.com/2011/12/misfire-on-cylinder-4.html
--------Car misfires and error code P0306 and P0303 is shown? http://technoanswers.blogspot.com/2012/01/car-misfires-and-error-code-p0306-and.html
--------Cylinder 6 Misfire? http://howtobyme.blogspot.com/2011/12/cylinder-6-misfire.html
-----------While stop engine idles like cylinder missing? http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html
--------Oil on spark plugs and car misfires? http://technoanswers.blogspot.in/2012/02/oil-on-spark-plugs-and-car-misfires.html
---------This will help.Thanks.

Posted on Feb 19, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Landrover td5, I have changed fuel pump and filter, only goes a few miles and stops, spin filter off it's only half full?


the problem is that the fuel tank is not venting and allowing fuel through
check tank vent or EVAP system for venting problems

May 06, 2017 | Cars & Trucks

1 Answer

Landrover defender bleeding brakes


You will need a special tool for bleeding the anti lock brake hydraulic control block. Please see the dealer for details.

May 16, 2012 | 1997 Land Rover Defender 90

1 Answer

Good afternnon, I have a landrover 110 diesel 1987 the engine wont rev initially but if you hold down the accellerator it will slowly pick up.After engine has reached high revs when you remove your foot...


Its possible the fuel lift pump is faulty. remove the fuel filter, if you see that its half full of fuel, then this will tell you the pump is at fault.
There is a lever on the fuel lift pump, turn the ngine till you feel itgo harder, then feel the travel of the pump and if it is firm or easy to operate.
Lift pump failure is common on these.

Sep 21, 2009 | 1994 Land Rover Defender

2 Answers

Ford fusion 1.4 tdci will not start unless the hand pump is used


HAVE YOU CHECKED THE FUEL LINES WHERE THE FUEL PRIMING PUMP IS CONNECTED FOR ANY CHAFFING THEY ARE COMMON FOR CHAFFING BESIDE THE FUEL FILTER WHICH WOULD EXPLAIN WHY FUEL IS RETURNING TO FUEL TANK.

Sep 11, 2009 | 2004 Ford Fusion

1 Answer

Car won't start after changing the fuel filter


you might have to just crank it when you change the filter it has to fill it back up so keep tryin and spray some ether in the intake if it starts you just not gettin fuel yet

Nov 17, 2008 | 1997 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...