Question about Hyundai Atos

Open Question

How to take off the rear wiper cover on a hyundai atos

How to remove the rear window wiper cover

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: How do you remove rear hatch panel cover on 1998 chev blazer

There should be screws around the edge of the panel. There are plastic panel locks that need to be pulled out, really the only way you can do that is to gently/firmly pull up on the panel. I had to exchange my rear wiper motor. To put the interior piece back on, just pop the locks back into place and screw back down.

Posted on Apr 19, 2009

  • 3911 Answers

SOURCE: How to remove the rear window wiper on a 1997 wagon

First do not pry on it, you will crack the rear windshield and have a bigger problem. In addition to the little slider lock at the base of the shaft mostly likely the wiper arm is corroded onto the motor/transmission shaft. What I have done successfully is carefully hack saw off the top of the wiper arm over the shaft. The top of the shaft is then exposed, soak it over and over with a penetrant, put a gear puller onto it and pull it off. A new shaft is about $45.00 at saturnparts.net which may be cheaper than a dealer. A dealer mechanic tells me what he does is drill a hole down through the top of the shaft, squirt a bunch of W40 down into the hole, then drive a metal screw into the hole which pops the arm off. In either event the old shaft is worthless. If your motor works count yourself among the lucky, note that most car parts stores will tell you that one wiper motor fits the rear of saturn SW from 94-99, that is not true. Take your old motor in with you to make sure they sell you the right one.

Posted on Oct 22, 2009

Testimonial: "Thank you for your response. Very helpful"

  • 40 Answers

SOURCE: Hyundai atos 1.1 2004, 100,000 what parts must be replaced

if it has one, the timing belt should be done, along with a tune up. spark plugs air filter, fuel filter. etc

Posted on Jan 02, 2010

  • 15 Answers

SOURCE: Having trouble removing the rear

you can only get a replacement wiper blade from a hyundai dealer .because the centre pin is thicker than a normal blade and when you get a replacement all you do it just hold the plastic rear wiper housing and pull the old wiper blade out then push the new on back home and your done
STRAKER1999

Posted on Dec 05, 2010

  • 45 Answers

SOURCE: rear windshield wiper does not cover the intended

IF YOU HAVE A PLASTIC CAP ON ARM REMOVE IT AND THE NUT UNDER IT, AND LIFT WIPER ARM OFF.

Posted on Jan 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the water deposit for the rear screen wash on my hyundai atos?


One reservoir in the engine well provides fluid for front and back. You problem is likely that a hose has come off for the back it is located at a connector in the area of the rear right seat, behind the plastic fascia.

Aug 13, 2016 | 1998 Hyundai Atos

1 Answer

Do I need to remove Phillips screws to remove reflector to change brake light bulb


We do not have this model of Hyundai in the USA so sorry have no info.

Jul 14, 2016 | 1998 Hyundai Atos

2 Answers

Where is the Computer box in the Atos Hyundai?, we want to fix it


does the Hyundai atos Prime 1.1 2008 model have a computer box

Sep 12, 2014 | 2007 Hyundai Atos Prime

1 Answer

How to remove the rear wiper cover on a 2008 saturn vue


2008 Saturn Vue rear wiper blade: Pop off the cover over the bolt that comes out of the rear window. Unscrew the nut. Now you can remove the assembly. Give the old wiper a tug and pull it out. Snap in a new 11-inch wiper. Replace the assembly, bolt and cover.

Dec 03, 2010 | 2008 Saturn VUE

1 Answer

The rear window wiper blade in stuck in an "up"


frozen motor. remove a rear door cover, and turn on rear wiper and listen for motor noise, also check fuse

Nov 05, 2010 | 1994 Mercury Villager

2 Answers

How to replace rear wiper blade - "07 Hyundai Santa Fe


pull the arm out,towards you ,then press the small tongue on the plastic clip and slide the pastic bit down the arm and off. replacement is a push fit until the clip clicks into place.

Jul 29, 2010 | 2007 Hyundai Santa Fe Limited

3 Answers

How easy is it to replace the front wiper motor on a 2004 ford escape ? Where is it located ?



Front Wiper Motor
Removal & Installation

NOTE A new wiper motor assembly comes with the linkage arm installed.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the windshield wiper mounting arm and pivot shaft
    WARNING Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location.
    NOTE Use a suitable tool to separate the wiper linkage arm from the wiper mounting arm and pivot shaft assembly.
  3. Remove the 3 bolts and the wiper motor.

    7f7866e.gif

    Fig. Wiper motor and linkage

To install:
  1. Install wiper motor and bolts.
  2. Tighten wiper motor bolts to 10 ft. lbs. (13 Nm).
  3. Install windshield wiper mounting arm and pivot shaft.
  4. Check wiper operation.

Rear Wiper Motor
- Removal & Installation
  1. Remove the rear pivot arm.
  2. Remove the rear wiper motor shaft nut cover
  3. Remove the rear wiper motor shaft nut.
  4. Open the lift gate window.
  5. Remove the rear wiper motor cover trim panel.
  6. Disconnect the electrical connector.
  7. Remove the 2 rear window wiper motor nuts
  8. Remove the rear window wiper motor.

    79be491.jpg
    Fig. Rear wiper motor view-2008 model shown, other years similar

To install:
  1. Install rear wiper motor and tighten mounting nuts to 62 inch lbs. (7 Nm).
  2. Reconnect the electrical connector.
  3. Install wiper motor cover trim panel.
  4. Install rear wiper pivot arm tighten nut to 53 inch lbs. (6 Nm).
  5. Install shaft nut cover.
  6. Check wiper operation.

Good luck (remember rated this post).

Feb 25, 2010 | 2004 Ford Escape

1 Answer

HOW DO I REPLACE A REAR WINDOW WIPER ON 2005 FORD ESCAPE?


Remove the rear pivot arm.
Lift the pivot arm to the upright position.
Slide the locking tab out.
Pull up and remove the pivot arm.
Remove the rear wiper motor shaft nut cover.
Remove the rear wiper motor shaft nut.
Remove the rear wiper motor cover.
Remove the rear wiper motor bracket nut.
Remove the bolt and the rear wiper motor.

Jan 29, 2009 | 2005 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...