Question about 2000 Ford Windstar

Open Question

2000 ford windstar

Speedometer,tach,radio,windows,turn signalsand I don't no what else not working

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2000 ford windstar

fuse #10 in the fuse box inside the van under the dash this fuse will be blown HOWEVER the reason the fuse is blown is your real problem
the most likely cause is the reduntant bps on the master cylinder just unplug it and the fuse should stop blowing.
you can replace it if you want.
be very carefull of leaking brakefluid on harness below this sensor if brakefluid has leaked into harness and is not attended too it can cause major problems.

Posted on Sep 03, 2008

Ad
chuck943
  • 783 Answers

SOURCE: 2000 ford windstar anti theft light flashing vehicle won't start

This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.

Posted on Feb 16, 2009

cwbtat
  • 52 Answers

SOURCE: 1999 ford explorer xls speedometer

doubt it is a fuse,could be,but i would check the speed sensor under the vehicle at the transmission,it will be a plug in with 2 or 3 wires going in to it,it will be on the side of the trans.towardthe rear of it.

Posted on Apr 19, 2009

DarkTurtle
  • 16 Answers

SOURCE: 2000 ford windstar speedometer

replacing the speedometer cable will not fix your problem , your problem is the dash gauge it self on the windstar there is a magnet inside a small metal dish that controls the speedometer when the magnet fails it begins to catch the metal dish randomly , ... witch makes the speedometer go crazy

Posted on Aug 24, 2009

bbbman78
  • 680 Answers

SOURCE: Remove the radio in a ford windstar 2000

There is a ford radio removal tool. It looks like a pair of horse shoes most times. Or you can insert four 8 common D finish nails in the four holes (or 4 six D finish nails) -one in each hole until you feel it click. Be gentile. simultaneously push each side towards their respective front door and gently pull the radio out.

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Instrument cluster


Do an online search for speedometer repair places. You can get yours rebuilt for a fraction of the price of new or junkyard

Jun 18, 2017 | 1994 Oldsmobile Bravada

Tip

How to reset your speedometer & tach on a 2005 Pontiac Montana.


If your 2005 Pontiac Montana's speedometer and tachometer does reset back to zero after you shut it off, put you ignition switch on and off until it resets. You might have to do this again after a few trips until it is permanently reset. The speedometer & tach will act up sometimes when your battery was run down or disconnected and has not been used for awhile.

on Mar 08, 2014 | Pontiac Montana Cars & Trucks

1 Answer

Cooling fans won't activate along with other issues.


The car sounds like it got flooded with water, do you have a title to it? Does it say salvage? If not then the dash issue has nothing to do with the other non electrical issues. There maybe a BCM (body control module) that is bad. Sounds like there are wires that are not connected to the thermostat to run the fan or the fan relay is bad or unplugged. The entire cooling system needs to be pressure tested. The coolant should be 50/50 water and coolant, there is a lot of things going on with the car so how many miles are on it and has the ignition switch been replaced?

May 21, 2013 | 1998 Audi Cabriolet

1 Answer

Turn signals on 2001 Chrysler Town & Country cause dash lights to come on and speedometer & odometer quit working


I would say its probably a short or a ground problem at the turn switch or a wire in that area. you need a test light and probably a multi meater and some nohow a ground or wireing problem can even drive a master teck crasy.

Apr 18, 2013 | 2001 Chrysler Town & Country

1 Answer

Gauges in 92 camaro rs stopped working


Remove it..Probably installed incorrectly . Tach is probably incorrectly wired into the distributor harness and effecting rpm voltage to the speedometer and may possibly blown the voltage regulator to the gauge in the dash.

Sep 11, 2017 | 1992 Chevrolet Camaro

1 Answer

Speedometer and tach don't work


my speedometer stop working too, and the needle was on the wrong side of the nib.
I pushed the little black nob (trip counter) at lower left corner for ten sec.it seem to reset things, it works fine now

Feb 08, 2013 | 2000 Dodge Caravan

1 Answer

Battery indicator light comes on above idle RPM, gauges start fluctuating.


The first thing you need to know is what the alternator output is when this starts happening.
It could be a faulty connection in the wiring harness, or a bad ground connection, or a failing alternator.

Aug 25, 2012 | 2000 Mercury Cougar

1 Answer

Turning the key to start does nothing but make the instrument panel do a light show,speedometer & tach.go back and forthal dial do a dance ,radio ,windows,lights do not work. took battery out to have...


just a thought , your ignition barrel may be faulty , sometime's the things that are hung of key rings aid to this fault and regular starting of course.

this has happed to me on other vehicles , in your case it may be the problem ..

also check your start relay this may be faulty !
hope this helps

Oct 09, 2010 | 2006 Dodge Caravan

1 Answer

2001 Dodge Ram 2500 - gauges don't work


check the engine to body ground strap. located rear top of engine screwed to firewall Remove,clean, and resecure.

Nov 12, 2009 | Dodge Ram Pickup 2500 Cars & Trucks

2 Answers

2002 Lincoln LS electrical systems down- won't start


Removed CD player for jammed CD. Reinstalled but car ignition and most electrical sytems won't operate although fuses appear OK. Don't know if it is related to the anti-theft system.When ignition is turned on, both tach and speedometer needles peg out and return to zero but no type of ignition

Apr 05, 2009 | 2002 Lincoln LS

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...