Question about 1996 Dodge Ram 1500 Club Cab

Open Question

Hi I recently bought a 96 1500 dodge sport that had an engine comartment fire I went through everything fixed what needed to be fixed not totally sure where and how all the vacume lines went put that obvious ones back to how they were but the 3/8 lines and the 1/4 ones were a little difficult to figure out so I just attached them all together and fed them back into the throttle body now is that correct or should I reroute them properly or does it even matter

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
66 chrgr
  • 1011 Answers

SOURCE: 1992 dodge dakota v8 5.2l sputters and back fires at a steady

a common problem with these engines is a leaky intake gasket which sucks in outside air spray carb cleaner around intake base see if engine idle increases .most likely this is your problem

Posted on Feb 26, 2009

Ad
tomdalek42
  • 1 Answer

SOURCE: How to adjust the timing on 4cyl '95 dodge dakota

unfortunately you do have to tear it all down, but it's not as bad as it sounds. the 4cyl is easy to work on. you don't have to put it all back together to find out if timing is correct. if you have a good fully charged battery just run the engine with only the timing belt attached. (of course be absolutley sure to keep tools, engine pars, and hands clear!)

put on the parking break and the trans in neutral

tear down to the timing belt

adjust to tdc (there is a hash mark on the cam gear)

remove or losen the idler pully

allign the timing gear and crank gear. there are marks on these from the factory install.

tighten idler pulley

run engine. it should be fairly obvious if it's too advanced or lagged when you give it some gas.

Posted on Mar 04, 2009

  • 6 Answers

SOURCE: firing order for 98 dodge caravan.

1-4
5-6
2-3
double check first

Posted on Mar 17, 2009

motor1258
  • 6674 Answers

SOURCE: 3.9 engine. spark plug wires inadvertantly got removed from distributer cap and not sure how they go back on.

moz-screenshot-1.jpg

Posted on May 31, 2009

  • 1 Answer

SOURCE: 2003 Dodge Ram 1500 won't start -little red light on dash came on

my power locks dont work or heated seats on my 2003 Dodge Ram 1500 i also have keyless remote entry and that dont work i took it to the dodge dealer and they had it for three days and could not find the problem they said the called dodge and did not get a answer please help 93300D6B-4D4D-9E7E-99D8-25B4690C888B 1.03.01

Posted on Oct 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My truck will not stay running when I let off the gas.


If you have recently replaced the battery, disconnected the battery or had to jump start the dodge, you have likely reset the electronics.

The result of this reset is that the engine control module needs to relearn the running parameters including the idle point.

It take several minutes of idle/driving to reset the baseline parameters and during this interval keeping the engine from stalling is a challenge.

Hope this helps? Engine Stalling After New Battery Fix It Like Pro

Nov 17, 2016 | Dodge Cars & Trucks

1 Answer

Will fire ,but will not turn over


Dodge Dakota Crank No Start Fix - YouTube

? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...

Inspect Fuses if Engine Cranks But Does Not Start : Dodge ...

repairpal.com > Problems > Dodge > Dakota
Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.

Dakota won't Start - Discussion on Topix

www.topix.com > Dodge Dakota
Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.

Dodge Dakota Questions - PROBLEM STARTING - CarGurus

www.cargurus.com > Questions > Dodge > Dakota

CarGurus

Jan 09, 2016 | 1990 Dodge Dakota

1 Answer

1997 pontiac trans sport engine was running went into house for wallet came out and engine had died. tried to restart and it fires but sounds like not firing on all cylinders or timing had jumped. is there...


I would pull plugs from each cylinder see what is not firing. You may need new coil if any of the cylinders are not getting spark. Also animals this time of year need warm places to sleep squirls love to eat plug wires.

Nov 24, 2012 | 1997 Pontiac Trans Sport

1 Answer

Electrical Short in 1998 Plymouth Dodge Neon


Lets start at the beginning.
What exactly is the problem you are trying to solve ?
Does the engine not crank, or not start ?

Jul 31, 2012 | Cars & Trucks

1 Answer

Where is the low beam relay located in the dodge caliber


There is no "low beam relay" in a 2007 Dodge Caliber. The headlamps (Hi and Low beams) are controlled by the Totally Integrated Power Module in the engine compartment.

Nov 24, 2011 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

1994 saturn strn sw drove it home cleaned engine comartment now it fires but wont run sounds like fuel depravation?


Sound like a components are wet; applied air compressor to dry all engine compratment and try to start, Dry spakrplug and wires.

Keep us updated.

Oct 09, 2011 | Cars & Trucks

1 Answer

1997 dodge avenger won;t start. engine has no spark. checked the spark plugs, they look good.


Does your engine turn over, just not fire? if it sounds like it wants too start but its not firing, try your distributor. this happened to my car last week actually, went out and bought a new dist. and it is fine now. its a big expense, so try to find one at a junk yard and they say you can take it back if its not that. thats your best bet. hope it helps.

Oct 18, 2010 | 1997 Dodge Avenger

1 Answer

I have a 1987 ford-150 straight 6 engine in it, only has 71,000 miles on it and recently i had a problem with the truck shutting down and if you gave it a few minutes it would fire back up so i had the...


You probably need a tune up or timing might have been changed which would alter the rpms. Replacing the module can erquire moving the distridutor and it may not have been returned to the same position. I have experienced same problem.

Jan 04, 2009 | 1999 Dodge Ram

1 Answer

Cranking but no fire


check your ignition coil.probably it doesnt send signal to the spark plugs.have it checked.

Jul 24, 2008 | 2001 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...