Question about 1997 Chrysler Town & Country

Open Question

1997 chrysler town & country keyless entry relay

Where is this relay located

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
blueextc3221
  • 15935 Answers

SOURCE: Where is the factory amp

The amp relay is in the Relay/Fuse box located under the hood. The amp relay is the one labeled NBS which stands for Name Brand Speakers. If you are trying to install an after market radio in a 2001 Chrysler Town and Country, you may notice that no sound comes from the speakers. This is because the single wire that is connected to the factory radio sends a signal to the Bus which tells the relay to turn on - powering the factory amp.

I bypass this by running a wire from the red Acc power wire on the radio to the relay. Connect the wire to pin number 87 on the relay. When standing in front of and facing the van, pin number 87 is the pin, on the NBS relay, which is closest to you and furtherst right.

Are you looking to replace the amplifier? or bypass the speaker wires??

Usually factory amplifiers in vans are under the P/S Front seat. However they can be up under the dash as well (P/S).

If you're looking for it because it is not turning on - check the relay (as above).

Thanks for using FixYa - a FixYa rating is appreciated!

Posted on Jan 31, 2009

Ad
chryslertech
  • 115 Answers

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Posted on Mar 08, 2009

emissionwiz
  • 76846 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

keemo68
  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

alicantecoli
  • 22246 Answers

SOURCE: Chrysler trouble code U110C on 2005 chrysler town

encrypted software ,dealer only----yes i know you are showing a reading but it doesnt mean anything or if it does it shows a different code .so your snap on or mac tools scanner is a waste of time and money.Nearly all new motors from 2005 are using encrypted software to stop general mechanics like me from working

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On the 1997 Chrysler Town & Country LX, 3.3Litre, the tail lights don't work. The break lights work, the turn signal works also. It's not the light bulb.


All three of your lights on the rear are ran separately. The tail lights are ran with headlight switch the brake lights off the break sensor the turn signals are ran from arm switch and then there are relays as well. Electrical issues are a real pain to track. However that's not abnormal have 2 of the 3 working when theres a bad relay or short in the wire

Oct 07, 2014 | 1997 Chrysler Town & Country

1 Answer

1997 chrysler town & country was cutting out,died,now wont start


you need to put a scanner on it and see what code comes up.
my guess would be the crank sensor which is very common .

Feb 12, 2010 | 1997 Chrysler Town & Country

1 Answer

On my 1997 Chrysler Town & Country , my Horn and Cruise control went out , checked fuses and relays. They were good. Now the Air bag light is on. what could be the problem??


This is definitely an issue with your clockspring. The clockspring is a device in the steering column that provides electrical contacts for horn, cruise and airbag. The good news for you is this part is covered under a Chrysler warrantee / recall.

Jan 07, 2010 | 1997 Chrysler Town & Country

1 Answer

Transmission relay switch


It's located in the engine compartment butthere is also a control module I suggest you buy a alldatadiy subscription to locate what your looking for. As some have them in different places. and please rate if this was helpful.avid101

Aug 12, 2009 | 1997 Chrysler Town & Country

1 Answer

Describe your 1997 Chrysler Town &


You need to replace the whole assembly. It comes as a motor/regulator.

Jul 28, 2009 | 1997 Chrysler Town & Country

1 Answer

My car alarm will not reset and the issue with problems below


If you (hopefully) have the key fob (keyless entry remote), try closing the doors, then lock and unlock using the keyless entry. This should reset the security so the vehicle will start.

Jul 04, 2009 | 1998 Chrysler Town & Country

1 Answer

Power lock cd/radio keyless entry not working


There aren't any fuses or relays for your problem, it must be taken to the dealer or other shop that has the special tool to do it to be reprogrammed. It's not a tool you want to purchase for casual use, it's called a "DRB III" and costs around $8,000. I have the directions to do it if you would still like them let me know.

May 31, 2009 | 2006 Chrysler Town & Country

1 Answer

Power sliding door will not activate when outside handle is pulled on chrysler town and country 2002


oh we have a 02 C T & C and our keyless entry for the sliding doors. when the side doors are not closed all the way or opened all the way the keyless entry won't kick in. try doing it closed or fully open, if this does not work try checking the battery in the remote. over all lets put it this way the 02 C T & C is like the best mini van around however it comes with alot of problems from ac. to tail lights

Apr 06, 2009 | 2002 Chrysler Town & Country

1 Answer

Random Horn Blowing


Wiring short, or incorrect wiring of your alarm system. Go through the wiring, and make sure everything is connected to what it should be, and check the material condition of those wires while you're in there.

Aug 15, 2008 | 1997 Chrysler Town & Country

Not finding what you are looking for?
1997 Chrysler Town & Country Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...