Question about 1985 Pontiac Grand Prix

Open Question

Need timing specs for a 1985 pontiac grand prix

Need timing specs

Posted by on

  • Kenneth D. Lamb Feb 24, 2012

    What engine? Setting timing will be different for different size engines. Best bet would be to find a Mitchells Manual.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
StormStrikes
  • 104 Answers

SOURCE: I need a wiring diagram for my 2000 pontiac grand prix

I own a 2001 Pontiac Grand Prix GTP and may be able to help you out if you let me know what specifically you are looking for.

Posted on Jan 02, 2009

Ad
davidg65
  • 26 Answers

SOURCE: 2002 Pontiac Grand Prix Thermostat

as you face the engine the thermostat bell is on the right (drivers side) Follow the radiatoe hose. Remove the two bolts and raise the bell still attatched to the hose. the thermostat is there with the rubber seal. You can gently pry the thermostat out with a screwdriver or something similar. Put in new thermostat be sure it is the same as the old one, and then replace or change the seal (be sure it is the smae size and thickness as the old one as I got the wrong size from Napa) Then replace the bell, and tighten, but not over tighten. I hope this helps!

Posted on Jan 31, 2009

  • 462 Answers

SOURCE: 99 pontiac grand prix 3.8 l.No battery power to pcm

Pin 20 on the blue pcm connector is the power wire to the pcm it is an orange wire. (hot at all times). The power to the data link connection is the cig fuse in the i/p fuse box.

What is the exact problem you are having?

Posted on Aug 04, 2009

  • 52 Answers

SOURCE: 1998 pontiac grand prix starter

disconnect the negative battery terminal first then disconnect the positive treminal so there are no accidents, raise the car safely go underneath & remove the starter cover should be 3 10mm bolts holding the cover on then remove the 2 through starter bolts 15mm then disconnect the + battery cvable from starter then disconnect the solenoid wire should be a 7 mm bolt. good luck

Posted on Sep 11, 2009

motor1258
  • 6674 Answers

SOURCE: spark plug gap for 2005 pontiac grand prix gt 3.8

.060 thousandths of an inch.

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the intake manifold torque specs on a 2005 Pontiac grand Prix gtp 3.4 liter with super charger?


If it were mine, I'd want to be very sure what it was and so I always use a Repair Manual I can see and read, but that me.

Mar 13, 2015 | 2005 Pontiac Grand Prix GTP

1 Answer

Can you give me the rear wheel camber spec for a 2001 Pontiac Grand Prix, GT? I am replacing the springs and would like to check & adjust (if necessary) the camber when done.


the only way you can adjust camber is special bolts. you will need a 4 wheel alignment anyhow when you are done and the alignment shop will adjust it, if needed.

Oct 06, 2009 | 2001 Pontiac Grand Prix

1 Answer

Wheel bearing torque


Front:
Mounting bolts 96 ft/lbs
Axle nut 159 ft/lbs

Rear:
Mounting bolts 55 ft/lbs

Sep 26, 2009 | 2001 Pontiac Grand Prix

2 Answers

I need to know what the torque spec is for a auto trans. pan gasket on a 2002 Pontiac Grand Prix?


It is actually 10 ft lbs. This is something that you want to tighten to exact specs.


Hope this helps!

Sep 24, 2009 | 2002 Pontiac Grand Prix

1 Answer

Need timing specs and point gaps please


Well I can't really help with the timing specs but the points gap should be .019 (in.), but I always learned to use a match box to gap them  and that works great too. Hope this helps.

May 06, 2009 | Pontiac Grand Prix Cars & Trucks

1 Answer

1998 Pontiac Grand Prix spark plug removal


no it can be done no spec. tools needed

Feb 10, 2009 | 1998 Pontiac Grand Prix

1 Answer

Head bolt torque specs for 1992 Pontiac 3.1 ltr


the last time i did the same job the gasket kit had the specs inside the box. the parts store should have a book/reference manual

Dec 09, 2008 | 1992 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...