Question about 2008 Ford Escape

Open Question

Location of restraints control module on a 2008 ford escape?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Scorpedo
  • 111 Answers

SOURCE: ignition control module location for 1997 ford thunderbird?

It should be right on the side of the distributor, a small ( usually grey ) plastic type box with 4 connections on one end if i remember right.

Posted on Dec 12, 2008

Ad
chuck943
  • 783 Answers

SOURCE: where is the ignition module control located on 1996 ranger 2.3 e

It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.

Posted on Apr 08, 2009

  • 14 Answers

SOURCE: IAC control valve. Locato\ion 2002 ford escape

If it's not idling and has problems starting, it's probably the IAC motor. It's located on the throttle body. Follow the airfilter box all the way to the engine, where the rubber flex hose attaches. The throttle body should be the first aluminum part you come to. Attached to the side you'll find small little aluminum part with a small wire harness attached. Unplug it, take the IAC motor off and clean inside with carb cleaner. This should fix the problem with the idle.

Posted on Sep 11, 2009

  • 84 Answers

SOURCE: ABS & traction control just went out on 2008 Ford Escape.

Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Posted on Feb 03, 2010

  • 70 Answers

SOURCE: cruise control ford escape 2002. ford escape

If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

Posted on May 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 FORD ESCAPE TURN SIGNAL FLASHER LOCATION


Doesn't have one ,flashers an turn signals are controlled by the SJB - smart juction box , fords BCM - body control module . Your best bet take your vehicle to a qualified repair shop.

Sep 13, 2017 | Ford Cars & Trucks

1 Answer

Where is the fuse for the abs breaks on a 2008 ford escape


PAGE 221 OF OWNERS MANUAL SHOWS LOCATION [UNDER HOOD]NUMBER 18 the following link is a copy of your owners manual
2008 Ford Escape Owner Guide 3rd Printing

Aug 05, 2016 | 2008 Ford Escape

1 Answer

Who to replace powertrain control module location 2008 ford taurus


The power train control module is under the cowl (where the windshield wipers are).

May 13, 2014 | 2008 Ford Taurus X

1 Answer

Compass module fallure escape 2008


I would check all fuses and replace any blown and retest. If the compass is still not working..I would make sure there is power at the compass module...If there is.. I would replace the module.

Nov 13, 2012 | 2008 Ford Escape

1 Answer

2008 Ford F-150 Air Bag module location


most comon location is in the passenger kick panel
best of luck

Nov 05, 2012 | 2005 Chevrolet Cobalt

1 Answer

Air bag light on in 2008 ford focus


For the airbag light situation to be resolved you need the airbag code to be deciphered from a scantool that can read airbag codes,,If the alternator has low output it would turn on also the ABS light,If the car was flooded it is posible that the control module did short out its location in in the center bottom console

Aug 11, 2012 | 2008 Ford Focus

1 Answer

Where is the fuel pump driver module on a 2008 Ford Escape


on the bottom of the car near the gas tank, looks like a small square box with wires connected to it.

Jul 22, 2012 | 2008 Ford Escape

1 Answer

Computer location on 2002 ford escape


For Escape and Mariner, the Powertrain Control Module (PCM) is located behind the instrument panel (cowl), center to both driver and passenger sides (access from the engine compartment).

zjlimited_678.gif

Fig. Powertrain Control Module (PCM) view



Hope this helps (remember to rate and comment this answer).

Sep 04, 2011 | 2002 Ford Escape

1 Answer

What does a airbag code 47 mean on a 2003 ford escape xlt


CHECK THE CODES FOR THE (RCM) RESTRAINT CONTROL MODULE CODES SHOULD START WITH A ( B ) EXAMPLE B1342


HOPE THIS HELPS

Aug 07, 2010 | 2003 Ford Escape

Not finding what you are looking for?
2008 Ford Escape Logo

Related Topics:

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...