Question about 1998 Lexus ES 300

1 Answer

1998 lexus es 300 dome light

My dome light isn't working--fuse is ok--how do I remove the dome light cover to replace the bulb?

Posted by on

  • 3 more comments 
  • Anonymous Mar 12, 2014

    2006 f150

  • Anonymous Mar 14, 2014

    Checked fuses & bulbs ... They are ok ??

  • Anonymous Mar 14, 2014

    my lexus 300 es 1998 is showing code p733 c;3 shift solinoid is that covered in my power train warrenty?

  • Anonymous Mar 15, 2014

    how do you remove rear seat from 2010 lexus es 350

  • Anonymous Mar 31, 2014

    spot light bulb

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Use a small thin blade screwdriver. Gently pry off where the small slots are located.

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for interior dome light for 1996 Lexus ES 300?


The best place to look is in your owners manual or you can physically look inside the the fuse box.

Apr 26, 2010 | 1996 Lexus ES 300

1 Answer

How to change front driver side turn signal bulb in a 98 Lexus es 300.


This may be right.I got this third hand.. works on later models. Above the area of the turn signal there will be a piece of black plastic that extends from the left side of the front of the car to the right. In this case if its the driver side pull up the plastic tab holding down the plastic strip in front of the battery directly above the headlight and lift it up. This will expose a screw that retains the front signal/driving light housing. Remove screw and carefully slide housing forward. Once out remove bulb and replace. This should only take 5 minutes, works on either side

Apr 07, 2010 | 1998 Lexus ES 300

1 Answer

HOW TO CHANGE A HIGH TAIL STOP LIGHT


open truck. remove access cover on tailight assembly. Turn the plastic tail light plastic bulb holder 1/4 turn, pull out burned bulb.

Feb 01, 2010 | 1998 Lexus ES 300

1 Answer

Lexus es300 1994 Dome light issue!


yes there is a blown fuse. look under the left side of dash and also check the fuses under the hood.

Jun 13, 2009 | 1998 Lexus ES 300

1 Answer

How to replace third brake light on 1997 lexus es 300


"To get access to the 3rd brake light:

- Place each hand against both sides of the plastic housing, and firmly grasp and pull the housing towards you. It might not budge at first, but it should move once you get a good grip on it.

- Pull the housing out just enough so that you can see the brake light bulb and stick your hand underneath. Ignore the speaker wires.

- Pull out the old bulb from the socket (it plugs in/out). Wear rubber gloves when handling the new bulb, and put the new one into the socket.

- Reverse the steps here to put the 3rd brake light back into place. Test out your brake light, and you're done" quoted from lexusk8 @ clublexus.com (great forum)

May 29, 2009 | 1998 Lexus ES 300

1 Answer

How do I change the license plate lights on a 1997 Lexus ES 300?


Open the deck lid (trunk) to better access the lights. There will be 2 of them. Recommend replacing both at the same time even if only one has failed. Generally sold in pairs anyway.

Directly above the license plate will be mounted 2 clear light covers. On the right side of each light cover you can see a small plastic rivet. Push in the center 1/4 inch with a small screwdriver then you will be able to pry out and remove the rivet without damaging it. This will save you from buying replacement plastic rivets for re-installation. Remove the light cover with the bulb harness attached.

The bulb harness requires a short turn counter clockwise to remove it from the light cover and the new bulbs snap into the harness. No twisting or screwing. Replace the bulb harness the same way and fasten the light cover back into place using the plastic rivet.

Saves time because both bulbs and light covers are exactly the same style, there is no left or right. Cheers!

Apr 29, 2009 | 1997 Lexus ES 300

1 Answer

How to replace third brake light on 1998 lexus es 300


in order to replaced the bulb, u go from inside the car (back Seat). The housing for the brake light will shift to the left (passanger side) then slide out, disconnect connector and replace buld

Apr 28, 2009 | 1998 Lexus ES 300

1 Answer

1998 lexus es300 right turn signals blink fast


replace the right turn signal light bulb.The light bulb is failing.

Apr 07, 2009 | 1998 Lexus ES 300

Not finding what you are looking for?
1998 Lexus ES 300 Logo

546 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...