Question about Hyundai Accent
I don't know how to reach the rear break light of my hyundai accent model 2000
Hi, You will have to pop the trunk open and pull some of the carpeting away to acsess the light assembly. Then just turn the socket and the bulb should come out. Replace with same bulb size and watts. Good luck.
Posted on Feb 25, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION 1. Check the pads for wear or oil contamination and replace, if necessary. • The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets. • All four pads must be replaced as a complete set. • When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material. 2. Check the pad for damage or deformation. Brake pad thickness: Standard value: 9 mm (0.354 in.) Service limited value: 2 mm (0.0787 in.)
INSTALLATION 1. Install the pad clips. 2. Install the pads onto each pad clip.
3. Insert the piston in the cylinder using the Special Tool (09581-11000). 4. Install the new pads. The shims are attached to each pad as illustrated Be careful so that the disc or pad isn't contaminated by grease. 5. Install the bolt and tighten to the specified value. Tightening torque Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
Posted on Jun 11, 2008
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
Posted on Jan 08, 2009
Go to hyundaiusa.com and then click on OWNERS on their menu bar. Then create a new account for your specific Hyundai vehicle year and model. Once you successfully log into your account, under the My Vehicle page you should see an underlined link labeled "Owners Manual". Clicking on this link, you will then be able to download a complete PDF version of the original owners manual.
Posted on Apr 27, 2009
Tips for a great answer:
Feb 24, 2012 | Hyundai Accent Cars & Trucks
Sep 05, 2011 | Hyundai Accent Cars & Trucks
Apr 21, 2011 | 2000 Hyundai Accent
Apr 15, 2011 | 2006 Hyundai Accent
Feb 10, 2011 | 2009 Hyundai Accent
Aug 12, 2010 | 2000 Hyundai Accent
May 03, 2009 | 2003 Hyundai Accent
Dec 23, 2008 | 2006 Hyundai Accent
Sep 20, 2017 | Hyundai Cars & Trucks
205 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: