Question about Cars & Trucks

Open Question

Need to find a DSO 15W 05

My DSO 15W 05 is not working. i think a person tried to fix it but he destroyed it. instead of trying to undo his misstake and fix the problem i need a new one. i need a link to a website where i can buy one. DVE SWITCHING POWER SUPPLY MODEL : DSO 15W 05 INPUT : 100-240V-0.4A 50-60Hz OUTPUT : +5V === 3A

Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 154 Answers

SOURCE: 1996 plymoth grand voyager is showing code p1496 , 5v supply output too low..what does that mean?

It means the Engine Computer registered the 5 volt sensor circuit at 3.5 volts or below for more than 5 seconds. There are numerous sensors that will be affected - this 5 volt supply is generated through the Engine Computer (PCM) - so any one of the sensors, or wiring to the sensors could be shorting bringing down that voltage or it could also be an internal problem with the PCM (Powertrain Control Module)
To troubleshoot this problem effectively - you would need an electrical schematics, a good Volt/Ohm Meter and a basic electrical understanding.
You should first take a good look at the engine wiring harness to see if any part of it is possibly rubbing against metal or if it is not routed properly. You may see something obvious (that is how I solve a lot of electrical issues like that)
Then worry about getting technical if you don't find anything

Posted on Aug 06, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

Can you use other oil in a mazda tribute like GTX high Mileage 15W-50

personally i would advise staying with the manufacturers recomende oil, maybe go with a fully synthetic version

Dec 26, 2014 | Mazda Cars & Trucks

1 Answer

Went to buy an 05 Chrysler Crossfire Convertible from a used car dealer. He was replacing the spring in the key fob. When he tried to start the car, the engine turn over then stop. When tried again nothing...

Try using a code reader to reset the CPU and have him reprogram the key correctly as well. Personally I would not buy a car from this person until he had everything fixed properly.

Jan 10, 2014 | 2005 Chrysler Crossfire

1 Answer

How do i unlock the gas cap of a ford tauras 05 without a key?

I would try & pick it,but I went to school for that

You have to use your electric drill on the key
way or key slot to destroy the lock

Mar 13, 2013 | Cars & Trucks

2 Answers

How hard is it to replace the passenger side mirror on my Pacifica

not too hard, behind the mirror on the inside there should be a triangular plastic cover, this will unclip with a little bit of levering with a screwdriver or flat blade.
once removed you should see a few holes in the door frame, in a few of those holes you will see at least 3 bolt heads, undo the bolts making sure you dont drop them inside the door cavity, there will also be a multi wire electric plug that you will have to seperate, the outside mirror can now be removed.
Dont try just replacing the glass as it involves almost destroying the whole mirror assembly, replace the complete mirror assembly

Jul 03, 2010 | 2004 Chrysler Pacifica

1 Answer

Speedometer sticking

Make sure that the outer cable cover is not pinched ,and try taking the inner speedo ,cable out and lube it with a light oil (e.g )automatic transmission fluid,you may have to undo the speedo cable from both end 's to do this. oil,the inner part and reassemble.

Mar 08, 2010 | 2005 Nissan Sentra

1 Answer

Cannot open my tailgate

Check your local auto parts junk yard and locate a similar truck that was wrecked on its side or front and get the parts off of that vehicle taking notes on how it is installed. That might be cheaper than a body shop.

Jun 02, 2009 | 2005 Chevrolet Avalanche

1 Answer

2000 1.6 zetec ford focus,engine not starting

Try spraying the electrics with WD40

Mar 07, 2009 | 2001 Ford Focus

3 Answers

HID fog light

check your connections to the relay, sounds like something is breaking down under load

Feb 18, 2009 | 2005 Chevrolet Silverado

1 Answer


yeah dude that happened to me, i put subs in my 05 g6, it supposedly happens when the battery dies or u undo the batter, so i took it too a dealership and they tried making me pay $30 for them to tell me it doesn't work so being the angry person i gave them a few choice words and got out of the nice 30 bucks but they will make u pay for a new stock system for a nice $350 bucks which i told them to go screw themselves and i put the dash kit in so i could read the mpg temp and all that and just put a dvd player in it was better and looks better. and to get ur discs out u pull the stock system out get a screw driver and pliers and start taking the junk apart to get them

Aug 13, 2008 | Pontiac G6 Cars & Trucks

2 Answers

Low beam and DRL will not come on

most headlight switches are pop in style that u just pop out of the dash and gently undo the electrical connector and replace it in reverse order, however all GM cars have individual relays for the lights so You may want to try a new relay first.

Jun 30, 2008 | 2005 Chevrolet Equinox

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides