Question about 1995 Honda Accord

Open Question

Windsheild wipers. Turn on and then shut off shortly after. Changed motor, and controller, and still the same problem. what or where else should I look or check? 95 Honda accord

Turn on and then shut off shortly after. Changed motor, and controller, and still the same problem. what or where else should I look or check?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 740 Answers

SOURCE: 1995 Honda Accord will not start

First you must check to see what missing. You must have spark at the pugs and gas at the injector for this car to start. See whats missing and get back to me. The 1995 Honda Accord has a history of bad distributor. If there is no spark at the spark plugs replace distributor. However on some models the coil is separate and not in the distributor, if so make sure the coil is working.

Posted on Dec 10, 2008

Ad
  • 1 Answer

SOURCE: i have a 95 honda

I'm experiencing the identical problem as we speak !

Posted on Jan 03, 2009

tony chavous
  • 50 Answers

SOURCE: vss for honda accord 95

there is a ten millimeter bolt holding it in remove this then depending if you have a factory or afterrmarket replacement you may have to remove the three tourqe scews fom sensor and replace just the electrical portion of the swith and reuse the shaft. Be sure to lubricate the shafts oring before reinstalling and double check to makesure the sensor is seated before installing the ten millimeter bolt. this can some times be tricky because the gear on the sensor doesnt mesh eith the gear in the diff just rotate the sensor side to side if this happens until it bottoms out

Posted on Feb 01, 2009

  • 74 Answers

SOURCE: 1996 honda accord windshield wipers

Sounds like the wiper arm has become disconnected. There may be a clip or bushing that has broken or fallen off. The wiper motor/arms etc are accessible by taking the cover off (usually plastic and possibly held in by screws or large plastic slots) that's at the base of the windshield. You may have to lift the hood for access and removal. Just take your time and don't force anything.

It's really simple after that. You turn your motor on and look for moving parts, that'll be the wiper motor. Either it's disconnected at the motor or it be disconnected on the arm. Usually one arm will move both wipers. If you're lucky, maybe it's just fallen off and you can find the clip or bushing and re-attach it. Otherwise, you may have to get a new part, which in this case would probably come from the dealer.

You may possibly also get it from a junkyard, but chances are if it's a small part, then they may not sell it to you. However some junk yards WILL sell you these small parts, and others may even let you pull the part yourself. If you could do this, you could also see how the part properly attaches.

If it's confusing how to re-attach the parts, then you may have to buy a Haynes or Chilton manual to see exactly how everything looks. Diagrams would be great. If there's no good pix in the manual, then try online. The best would be to see fully functional operating wipers on a similar car. Maybe find a buddy to take a peek at his after you practice on yours.

The part if broken should fit multiple years of your make of car.

Get this fixed soon because not only will it not pass inspection, but it is highly unsafe.



Posted on Feb 10, 2009

  • 101 Answers

SOURCE: 2004 Honda Accord. The windshield wiper blades are

There is a 10mm nut on the wiper where it connects to the post near the hood. Unscrew it and lift the arm off of the post. Turn it just a little up and put it back on the post. Screw the nut back on and it should work.

Posted on Sep 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The windsheild wipers on my 2000 grand prix don't


Check the fuses and relay. It could be the wiper motor going out as well

Nov 12, 2017 | Cars & Trucks

1 Answer

Chevy Venture 1999 Turn on the windsheild wipers nothing happens nothing even tries to happen except the radio goes off. Use the cruise control radio goes off but cruise works. Replaced the windsheild...


Learn how to test electrical circuits ! Find a wiring diagram so you know which wires to test . Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine size . Under system click on body & accessories , then under subsystem click on wipers / washers .Check B+ voltage and ground circuits .
Wiper Motor Switch Troubleshooting
Windshield Wiper Motor Wiring Tutorial

Aug 22, 2017 | 1999 Chevrolet Venture

1 Answer

I have a 2003 grand am. The other day my windsheild wipers stopped working all together. I cannot hear the motor working when i turn them on. I changed the fuse in the driver's side panel and the...


Test the connector to see if it has power with a multi-meter. Corrosion plays a big factor. But considering it is a 2003 I'd probably say it is the motor considering you changed the fuse.

Nov 17, 2017 | 2003 Pontiac Grand Am

1 Answer

THE WINDSHEILD WIPERS DON'T SHUT OFF


The park switch is built into the motor. YOu need a new motor. Find an independent shop and have them replace with a rebuilt or new aftermarket unit instead of a dealer unit. The labor guide shows 1.4 hours to replace the motor

Jun 26, 2017 | 2004 Chevrolet Tahoe

1 Answer

Windsheild Wipers will not move, the arm seems to be slipping on the motor shaft,


It sounds like you live in a climate were snow and ice occurs. If so a lot of people leave their wipers on upon shutting off their cars. If you happen to do that and the windsheild had moister on it or if the snow starter falling while your vehicle was still warm it will freeze. The larger the snow amount the stronger the force will be if you start your vehicle up the next morning with your wipers buried in frozen ice & snow. Since the wipers were not shut off the wiper motor will run and the wiper blades will not. This will strip the linkage the wiper arms press onto leaving you with out working windsheild wipers

Jan 27, 2010 | 2003 Chevrolet Tahoe

1 Answer

My 1997 Ford F150 dies whenever i turn on wipers


sounds like a new problem, I would try unpluging the windshield wiper motor under the hood turn on the switch inside the truck and see if it still dies, if it doesn't suspect a short inside the wiper motor itself (replace wiper motor).

Jan 19, 2010 | Ford F-150 Cars & Trucks

1 Answer

The windsheild wipers do not turn on, have already changed the fuse


wiper motor is under the hood check for continuity and power will switch is on could be ur motor which u can change ur self probably 100 bucks for a lexus

Nov 24, 2009 | 1994 Lexus LS 400

1 Answer

Put in a new wiper motor 1997 e39 528i bmw\it stops in the middle


Remove arm(s), put wiper motor in park,(shut off) then re-install arm at base of windshield where they were before,when shut off.(in park position.)

Sep 26, 2009 | 1997 BMW 318

1 Answer

How to realign wipers after replacing wiper motor


sHUT WIPERS OFF AND ALLOW THEM TO PARK

















Shut wipers off & allow them to stop in what should be park position. Now lift caps at pivots, loosen nuts, lift arm slightly and move it to bottom of windsheild, where you feel it was before when off. Now tighten nuts (snug) and do same to other arm. Now turn them on,let them wipe a couple of times then shut off again and see where they stop, if good snug up nuts, snap cap back over & done, if not, repeat as above on movement where you want it.







Dec 06, 2008 | 1996 Dodge Caravan

1 Answer

Wipers


You have two problems. The first is the wipers turn off and stay in the upright position and do not close. The motor is fine. There is a steal 'close' tab that has been bent out of position. You just need to push the steal tab back into position. You can use a chisel or screwdriver to pound it back into the 90 degree position.

The windsheild washer motor probably needs to be replaced

Jul 07, 2008 | 2001 Pontiac Grand Prix

Not finding what you are looking for?
1995 Honda Accord Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...