Question about Chevrolet Silverado 1500
My wipers won't work on anything but high. if you turn them off while wipeing they stop without going down
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Well sure enough all I had to do was replace the circuit board...wish I had done this a couple months ago...it was so easy to do and will now be much easier to drive with being able to see clearly again....
Posted on Jan 08, 2009
Ya i have a 2000 mal myself that sounds like the switch because if it was the motor the high speed would not work either.
Posted on Jan 26, 2009
to all...it may be a switch problem. if it was the wiper motor, common sense says you wouldn't have any wipers at all. also have someone go over the wiper relay in your vehicles.
Posted on Jun 12, 2009
raeally sound s as if you fuel pump pickup is clogged. this is exactly what was wrong with a 1997 tahoe. no engine codes. slow acceleratoion fine all the way to freeway speeds 70mph. but if you go full throttle truck would buck and backfire through throttle body. it is a lot of work but you must drop the tank, inspect your lines into the tank, pull the pump replace the filer and if if filter is torn make sure pump is not also clogged. good luck
Posted on Dec 31, 2009
under hood drivers side on fire wall between engine and brake master cylinder take off wiper arms slide tab at bottom lift off -- un- screw cowl the cowl is in 3 parts -unscrew center with hood closed first the screws are recessed about an 1-1/2 below the top of cowl open hood and unscrew the both sides of cowl and remove than remove center watch the washer hoses now will have access to the wiper transmission mark where transmission is before unbolting motor and transmission remove motor install is in reverse
Posted on Feb 10, 2010
Tips for a great answer:
Oct 08, 2012 | 2010 Dodge Ram Pickup 1500
Jul 30, 2012 | Cars & Trucks
Nov 05, 2011 | 2006 Chrysler PT Cruiser
Feb 21, 2011 | 1999 Chevrolet Venture
Sep 08, 2010 | 1999 Chevrolet Malibu
Jun 15, 2010 | 1997 Chevrolet Blazer
Apr 15, 2010 | 1990 Chevrolet K1500
Dec 11, 2008 | 2000 Chevrolet Malibu
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: