Question about 2002 Volvo S60
How do i remove the center console?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: how to remove front door
Pop the grab handle cover off, two different styles.
1. With a slot under the grab handle, take a small screw driver off and gently push up, it should just pop out.
2. Simple cover that can be separated with a bone tool or similar so you don't chip the cover piece.
Behind that you will find two Torx 25 screws, Take those out.
Around the edge of the panel should be around 8 plastic rivet type of thing.
Again...two different styles.
1. With center pins that blend in perfectly with the rivet. Should be about 3/32nds diameter. Push the center in and the rivet deals should pop out. Be sure not to lose the center piece...easy to lose.
2. Same deal but with a larger center pin.
Take the plastic triangle piece near the upper right hand area as facing the panel.
Pull bottom away from door and up to release from top section of door.
Careful removing the cable for the door lock release, and remove the connectors from the tweeter and driver's door module.
Posted on Aug 14, 2008
SOURCE: HEADLIGHT ADJUST ON AUTOMOBILE
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
Posted on Sep 30, 2009
Tips for a great answer:
Jul 19, 2015 | 2002 Volvo S60
Jul 14, 2014 | 2002 Volvo S60
May 11, 2014 | 2003 Volvo S60
Nov 18, 2012 | 2002 Volvo S60
Jul 07, 2010 | 2002 Volvo S60
Sep 15, 2009 | 2002 Volvo S60
Dec 02, 2008 | 2002 Volvo S60
304 people viewed this question
Usually answered in minutes!