Question about 1999 Buick Century

3 Answers

Turn signal bulb out

My 2000 buick century's turn signls are out. how do I get to them. it's the Front ones. the back ones were easy to change. In addition, the area where I see P N D D2 D3 on the dash, the light is gone. ia that a fuse or what?

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Forget the fuses and relays for now if the buld is out replace it 1- open hood 2- pull up on headlight retainer clips 3- pull out headlight assembly 4- replace bulb (simple)

Posted on Dec 03, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,952 Answers

If you look on both sides of the light housing you will see to white clips. Push up on the clips and the housing releases. Just push it forward and remove the rubber caps and replace the bulb.

Posted on Oct 28, 2008

  • mohammed marika thambi
    mohammed marika thambi Oct 28, 2008

    Could be the control stick for the blinkers. If the lights work, try
    replacing the stick or checking out the signal path for that blinker
    Pull up on the two white plastic clips on both side at the rear of the
    light assembly. Pull the light assembly forward amd remove the black
    rubber circle behind the bulb. Remove the bulb assembly by turning
    counter clockwise. Pull out bulb. replace bulb and repeat steps in
    reverse order.

  • mohammed marika thambi
    mohammed marika thambi Oct 28, 2008

    TURN SIGNAL SWITCH -- OEM Design Turn Signal, Headlamp Dimmer,
    Windshield Wiper And Washer Switch And Lever, A High Quality Direct
    Replacement Part Providing Exact Fit For Easy Installation And Reliable
    Operation, Direct Replacement Part For OE Number 26085928"


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Buick Master
  • 19,396 Answers

That is probably the relay, start replacing the turn indicators relay.

If thet does not work , then it is probably a short on the instrument panel stick.

Check also the indicator fuse.

Posted on Oct 28, 2008

  • Ginko
    Ginko Oct 28, 2008

    Start checking the fuse, if the fuse had blown, then that was probably the problem.

    If the fuse is OK, there is also a relay that controls the indicators, replace it.

    If the fuse and the relay are ok, check the bulbs and replace them. If it still does not work, that means that there is a lose contact or a lose connector.

    If the fuse keeps blowing, then there is a short somewhere, replace all bulbs, then look for the short.

    If indicator switch is located on the stick on the instrument panel, then an area were you often get shorts and broken contacts is within the wirings that run inside the stick.


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I get to turn signal bulb on right front of 1990 buick century

open hood look for the light assembley powercords that go into the headlamp..turn right or left to loosen ... you may have to just take a screw driver and remove the cover over the signal light. press in and turn and replace.

Mar 08, 2015 | 1990 Buick Century

1 Answer

Change front turn signal bulbs

This may help. It shows how to remove the light assembly to gain access to all the bulbs on the front.

Feb 25, 2015 | 2000 Buick Century

2 Answers

How to change 2000 Buick Century Turn Signal Flasher

Did you check fuse? Reference owners guide. If you can check for voltage at fue, stick paper clip in fus slot (red, positive lead) negative lead to chasis. REPLCACE ALL LIGHT BULBS AT ONCE then have some one push brake while you hold brake bulb in your and watch to if it blows, if not turn key to on flip turn signal see what happens let me know what you see, Good luck

Aug 18, 2014 | 2000 Buick Century

1 Answer

How to replace right front turn signal

go to the store buy the right light bulb, change it. it easy to change, it like take out a like bulb, put new one. if some thing is blocking u reach to bulb, temp remove it, change it, put back it to where it at before.

Jan 27, 2012 | 2000 Buick LeSabre

1 Answer

Both of the turn signals do not work. The hazard lights only work in the back. I looked at the fuzes on the passenger side, and they are still good. What can I do to get them to work?

It sounds like you have at least two bulbs out in the front. I suspect that both turn signals did not stop at the same time? Check the front bulbs. Many turn signal bulbs have two filiments; one for parking lights and the other for turn signals. The same filiment is used for turn signals and hazards.
Another possibility is that there is a bad or broken ground wire in the front?
Finally, it could be the turn signal switch.

Apr 05, 2011 | 2000 Buick Century

2 Answers

I have 4 way flashers but no turn!!!

there is a flasher for both 4 way & regular turn signals ( check to make sure the bulbs are good
the backs are easy >>> Just step on the brake, If the lights light up the bulbs are good you my have to remove the bulbs one at a time in the front check your ground wires to the lights if everything is good replace the flasher unit if that fails replace the turn signal switch

Feb 26, 2010 | 1990 Buick Century

2 Answers

Signal bulb on 2003 buick regal

To change front turn signal –
open the hood; look in back of headlight; two white clips; pull straight up, and then whole headlight comes out including turn signal; it is all one unit; remove rubber cover, then you take bulb out of unit. Mechanism that bulb fits in will need to be turned clockwise (looking from the front) and pulled to get it out of the larger unit holding all lights. Be sure and put rubber cover back on before re-inserting the two white clips.

Mar 16, 2009 | 2000 Buick LeSabre

1 Answer

1992 Buick Century turn signal

You may have some corrosion in the socket where you plug in the bulb. This would cause the lights to not blink. Put the turn signal on, and check the lights, front and back. Are then on, and not blinking, or are they not on at all? If the bulbs are good, and they aren't on, it's the bulb socket problem. Get fine sandpaper, fold it around a pencil eraser, sand off any gunk or corrosion inside the socket. It could also be a faulty ground wire, check for a loose wire at the light assembly. front and back.countrycurt0

Aug 22, 2008 | 1992 Buick Century

1 Answer

Front Left turn signal lamp doesnt work

check wire contacts in socket. If they are melted change the socket
It can be removed easily just unplug the wires.
I have replaced both front sockets on my 1999 Buick Century.
Hope this helps.

Aug 03, 2008 | 1999 Buick Century

Not finding what you are looking for?
1999 Buick Century Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides