Question about Cars & Trucks

Open Question

Can any one give me the full wire map for Legnum 6a13 ECU?

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: MAP sensor wiring to ECU

There are 3 wires from the MAP to the ECU

Brown is E (Ground)

Yellow is VC to VCC (sensor to ECM)

Light Green with a Red tracer is PIM to PIM

Posted on Feb 10, 2009

Ad
c17hydro
  • 2984 Answers

SOURCE: firing order 6a13

here ya go

c972b6e.gif

b2f2a31.gif

Posted on Aug 28, 2009

c1apton15
  • 3400 Answers

SOURCE: when should a cambelt be

Should be changed every 60k

Posted on Feb 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi I have a 96 legnum and its not getting power to the fuel pump . I have checked the fuel pump relays & fuses changed the engine ecu .checked all the wiring . And still not getting power to the fuel pump...


check the wire to the pump; also are you sure you don't have a bad pump?
You checked the wire that plugs into the harness on the tank and what did you find?

May 19, 2014 | Cars & Trucks

1 Answer

Car starts and idols great but cuts out and dies when I give it gas, like it's flooded. Already changed fuel pump skreen and fuel filter. Air, fuel mixure?


  • too high fuel pressure. 30 ok 60 bad. PSI
  • leaking injectors
  • ECU injector driver shorted, turning on injectors full time
  • injector drive wire shorted to ground bad wiring.
  • ECT stuck at -40F (alaska temperature) USE a SCAN tool.
  • MAP sensor vacuum hose/pipe clogged (ECU thinks your are going up hill all the time and floods.
  • The scan tool can check each , but not fuel pressure.

that is a start,

Feb 20, 2014 | 1997 Toyota Corolla

1 Answer

When I crank the vehicle I have to keep the throttle open I checked the ECU for trouble codes it showed a problem with the MAP sensor voltage too high I replaced the the MAP sensor then trouble code showed...


Need to check the wiring from map sensor to control module and make sure you got correct map sensor also if o2 sensors are giving incorrect reading can affect this

Nov 12, 2010 | 1993 Chevrolet C3500

1 Answer

Cant find power wire in mitsubishi 97 legnum


try using a headlight bulband two peices of wire to make it go and just keep trying evry wire till it lights up. ps make sure battery is connected

Mar 21, 2009 | 1997 Mitsubishi Galant

1 Answer

MAP sensor wiring to ECU


There are 3 wires from the MAP to the ECU

Brown is E (Ground)

Yellow is VC to VCC (sensor to ECM)

Light Green with a Red tracer is PIM to PIM

Feb 09, 2009 | 1995 Toyota Corolla

1 Answer

MAP sensor


There are 3 wires from the MAP to the ECU

Brown is E (Ground)

Yellow is VC to VCC (sensor to ECM)

Light Green with a Red tracer is PIM to PIM

Hope this helps. Thnaks for choosing FixYa for assitance.
A FixYa rating from you from my answer would be appreciated.
Thanks in advance.

Jan 24, 2009 | 1995 Toyota Corolla

2 Answers

Lengnum 2.5lt 4wd


This would be worn CV joints.

Aug 18, 2008 | Mitsubishi Diamante Cars & Trucks

1 Answer

Map sensor wiring for Chevy s-10


Well after looking it up it's the the map input wire is light green on both 4 and 6 cylinder models.

On a 4cyl the map has black gray and light green, the black is ground, the gray is a 5 volt refrence from the pcm(power control module), and the light green goes to to ECU for MAP input.

On a 6cyl the map has black gray and light green, the black is goes to the automatic transmission, gray is a 5 volt refrence from the pcm(power control module), and the light green goes to to ECU for MAP input.

Hope this helps and good luck

Jul 01, 2008 | 2000 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...