Question about 2000 Chevrolet Silverado

1 Answer

Problem lights the abs and brake lights on my instrument panel come on at the same time. i've taken it to be looked at and have been told that there is no problem with my brakes. they don't come on all the time.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 360 Answers

This is an issue with the ground in most cases . if not its your abs pump

Posted on Oct 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

ABS light comes on and loss of instrument cluster light


it's a good chance your ebcm "brake control module'

GOOD LUCK

Nov 02, 2012 | Cars & Trucks

1 Answer

Master Cylinder? HELP!


Hi Jacki, If you are losing brake fluid it must be leaking from somewhere and the places are limited. Fluid can leak from any one of the four wheel brake cylinders, the master cylinder, the ABS pump and valve unit, the master cylinder or cracked or broken metal or flexible brake pipes. Wherever the leakage is, it must be visible and detectable, as the fluid will make the area wet, If you look at each one of the four wheels, I'm sure one will have been marked by the leakage. The ABS / Traction control are separate from the Emergency brake warning light. The latter (E Brake) warns of loss of brake fluid. Whenever you top up it will extinguish, but illuminating again when the fluid has leaked out! The ABS and Traction control warnings will come on when an electronic signal fail to be transmitted and thereby triggering a fault code. These codes will be extinguished when the vehicle is connected to a scanner and the faults are deleted from the vehicle computers memory. You will most likely find that the wheel cylinder which is leaking has contaminated the pick up sensor which sends the signal to the ABS / Traction system. It will likely need removing, cleaning and then refitting. I am very sure that if you take a flashlight and lay down, even without crawling under the vehicle, you can identify where the leakage is, and point it out to those experts who it would seem have been misleading you. I doubt the leakage will be on the master cylinder, as having two unrelated faults would seem to be stretching coincidence a little far. (But I may be wrong and two problems may have come separately together! I believe the two are related to one wheel cylinder which has contaminated a sensors, The leakage is the most serious problem, as it can leave you without brakes! have that seen to very urgently! In fact NOW!!!! Regards John

Feb 22, 2012 | 2007 Chevrolet Malibu

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

1 Answer

What brake ststem do 2001 silverados have? rear brakes


Hi. Your 2001 Chevy Silverado is equipped with Antilock Brake System (ABS). You will identify also if your car is equipped with ABS by looking at the instrument panel for a yellow ABS indicator light after you turn on the ignition.

All the best!

Nov 10, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

1993 S500-yellow light started flashing on the instrument panel. Round circle with 3 dots on both sides, between the ABS and Brake on the instrument panel


that light is your warning light for the brake pads. One of the brake pad sensors is starting to touch the rotor causing the light to come on or flash. Have the brakes checked. You will probably be needing to replace the brakes and the sensors.

Oct 08, 2010 | 1993 Mercedes-Benz S-Class

2 Answers

Fuel Pump Fuse Number for a 1998 audi a4 2.8 quattro


Fuses: Fuse arrangement in fuse panel, behind instrument cluster, left
Fuse Arrangement In Fuse Panel 62624464

1 - Heated washer jets 5A 2 - Turn signals 10A 3 - Headlight washer (relay), illumination for glove
compartment, climate control, Automatic Transmission, instrument cluster 5A 4 - License plate light 5A 5 - Instrument cluster, seat heating, test connection
for cruise control, bulb monitor for auto-check display, Automatic Transmission display, switch
lighting, mirror switches and actuators, airbag
warning light, outside temperature indicator,
climate control 10A 6 - Central locking system 5A 7 - Anti-lock brake system (ABS) 10A 8 - Vacant 9 - Mirror heating 10A 10 - Vacant 11 - Cruise control (Automatic Transmission) 5A 12 - On board diagnostic system 10A 13 - Brake lights 10A 14 - Interior lights, reading lights, anti-theft alarm system, vanity mirror 10A 15 - Instrument cluster, power windows, climate control, automatic transmission 10A 16 - Anti-lock brake system (ABS), Anti-Slip Regulation (ASR) 5A 17 - Heated door locks 10A 18 - High-beam, right 10A 19 - High-beam, left 10A 20 - Low-beam, right 15A 21 - Low-beam, left 15A 22 - Side marker and tail light, right 5A 23 - Side marker and tail light, left 5A 24 - Wiper and washer system 25A 25 - Blower for heating, climate control 30A 26 - Rear window defogger, mirror heating 30A 27 - Rear window wiper 15A 28 - Fuel Pump 15A 29 - Engine timing 30A 30 - Sun roof 20A 31 - Tail lights, cruise control, automatic transmission 15A 32 - Engine timing 20A 33 - Cigarette lighter 15A 34 - Engine timing 15A 35 - Trailer recptacle 30A 36 - Fog lights 15A 37 - Radio 20A 38 - Luggage compartment light, central locking system 15A 39 - Emergency flasher system 15A 40 - Horn 25A 41 - Anti-lock brake system (ABS) 25A 42 - Vacant 43 - Vacant

Apr 05, 2010 | 1998 Audi A4

2 Answers

ABS brake light stays on all the time.


Any competent repair shop with a scanner should be able to pull codes from the ABS computer. It is likely a speed sensor or wire.

Dec 04, 2009 | 2001 Chevrolet Suburban

1 Answer

Abs light stays on ol the time olso hand brake


My 2000 passat does the same thing... I was told i need to replace my abs pump... but Ive been driving it this way for eight months with out any known problems... i was told it just wount pulsate the brakes for you... you need to do it old school and pump the brakes in an emergancy

Nov 18, 2009 | 1998 Volkswagen Passat

1 Answer

1997 Saab 9000 weird ABS problems: 1. Occasionally, the ABS instrument panel light will come on without the brakes being applied and the ABS system being activated. 2. Sometimes, even though the brakes are...


have car scanned auto zone -advanced auto and some other auto stores will do this for free most likely one of your sensors is starting to go bad usually will activate at low speed under 10 mph as ur slowing down do check this problem early as abs can cause vehicle to stop longer

Oct 05, 2009 | 1991 Saab 9000

Not finding what you are looking for?
2000 Chevrolet Silverado Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...