Question about 2000 Oldsmobile Bravada

1 Answer

There is no power coming from the orange wire. What is the problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Oldsmobile Master
  • 75,797 Answers

Orange is the GM wire color for "Hot" leads to everyhting in the car, check all the fuses.

Posted on Feb 24, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of the power seat circuit breaker on a 2001 s10 blazer lt?


I think that more than likely wher eit draws the power in the fuse box the circuit feed to the fuse is burnt out ,this is often a strip on the back of the fuse box that runs across the frrd to the fuses so check for a feed in the fuse box on the fuse for the power seat

Oct 21, 2014 | 2001 Chevrolet Blazer

1 Answer

95 chrysler new yorker no distributor signal


Lets start at the beginning. Do you have power going to the coil and is the ASD relay working ?

Aug 03, 2013 | Cars & Trucks

1 Answer

1983 Chevrolet C10 Silverado: The AC compressor and heater blower motor fan will not come on.


The brown wire at the speed switch is the power wire. Powers is then directed to the blower motor resistor throught the orange, lt blue and yellows wires. The blower motor receives power through the orange wire. Check for power at the fuse with the key on. If there is no power the problem could be the ignition switch or the wiring in between the switch and the fuse block

Apr 05, 2013 | Cars & Trucks

1 Answer

Where can i get a wiring diagram for my 2002 chrysler neon auto


12V CONSTANT WIRE RED and PINK/BLACK Ignition harness
12V IGNITION WIRE DARK BLUE Ignition harness
12V ACCESSORY WIRE BLACK/ORANGE Ignition harness
STARTER WIRE YELLOW Ignition harness
PARKING LIGHTS (+) BLACK/YELLOW At Headlight switch
POWER DOOR LOCK (5-wire reverse polarity) ORANGE/PURPLE Harness Coming Into Vehicle From Driver's
Door
POWER DOOR UNLOCK (5-wire reverse
polarity)
PINK/PURPLE Harness Coming Into Vehicle From Driver's
Door
DOOR TRIGGER (-) YELLOW/BLACK At Headlight Switch
DOMELIGHT SUPERVISION (-) Use door trigger
TRUNK TRIGGER (-) GRAY/BLACK At Light In Trunk
TACHOMETER WIRE TAN/BLUE or BLACK/GRAY At Ignition Coil
BRAKE WIRE (+) WHITE/BROWN At Brake Pedal Switch
HORN TRIGGER (-) BLACK/RED Harness Coming From Steering Wheel At
Column
CAUTION! SRS airbag wires are not enclosed in protective loom at the steering column. They are a twisted pair of wires that run with rest of
ignition harness. Be careful not to cut or probe these wires.

Radio:

(Black plug)
Rear Right speaker -: Blue w/White stripe
Rear Left speaker -: Brown w/Yellow stripe
Front Right +: Purple
Front Left +: Dark Green
Rear Right speaker +: Blue w/Orange Stripe
Rear Left speaker +: Brown w/Blue Stripe
Power Antenna/Amp: White
(Gray Plug)
+12v battery wire: Pink or Pink w/White Stripe
+12v Ignition wire: Red w/ White Stripe
Front Right speaker -: Blue w/ Red Stripe
Front Left speaker -: Brown w/ Red Stripe

May 03, 2011 | 2002 Dodge Neon

1 Answer

Heater blower only works on high. Replaced the resistor no difference.Checked fuses OK. What else could it be.


The resistor has a thermal limiter in it, if its bad, it cannot be reset. The blower motor may be bad causing high amperage, burning out the limiter. At the resistor,Ck if there is power at the GRAY/BROWN and GREEN/WHITE, and BLACK/GRAY wires, they should. If not CK the Violet/Orange wire, it should have power.If the Violet /Orange wire has power, but the others do not the limiter is bad and it needs replacement (resistor) If all have power, then when gounding each wire (except the Violet/Orange wire) the blower should come on

Nov 15, 2010 | 2007 Ford Ranger FX4 Off-Road

1 Answer

A 2002 impala radio lights but no sound comes out


Below is an answer I found on line pasted it here - checked it out - found I had same problem. Additional notes from my repair...You must remove the scuff trim - pull back the carpet to get to the harness - inside the harness trace the two orange wires from the rear frontwards... the splice is approx. in line with the column between the front and rear doors...until you find the splice with a single orange wire - my splice was all green powder copper corrosion = no power. I pulled on the two rear wires and they immediately seperated form the single wire splice joint, came right apart - spliced -took about two minutes - radio works like new - good luck... I found the problem to be an orange power feed wire in the passenger side rear door scuff plate that totally corroded open. Evidently water came into the car interior through the fresh air vent below the front windshield and ran back though the wire harness tunnel. The splice area was just past the passenger rear door pillar where one of the orange wires was spliced into two smaller orange wires that provided power to the factory amplifier. Respliced the wires and now works great. Please pass this on as the most likely failure mode for this vehicles inop radio when the radio lights up but no sound. RICK

Nov 02, 2010 | 2002 Chevrolet Impala

2 Answers

My low beams keep shutting on and off but high beams are fine


this could be solved by taking the bulb out of its holder and cleaning the contact of the bulb and holder.
turn the ignition on after this with the bulbs in the holder and plugged in but not in the headlight kitself.Turn the lights on and see if the work if still the same try moving the bulb while on in its older and see if its just loose. if so holding it one way it will work. wedge something something to hold it in place or buy a used bulb holder.
Check the fuses at the same time and the wire plug that powers the bulb. check and clean the contacts of these also
Let me know how it goes and ill help again if it persists.
bakerboy11@hotmail.com
Automobile

May 17, 2010 | 1994 Dodge Ram

1 Answer

**** hill, i can't get my central locking to work from the fob or the switch


you don,t mention the model year or type this might be of help, make sure the battery in the fob is good.

Up to vin number 470739 there is a in-line fuse (15a) on the Aux fuse panel that powers the lock motors and from vin # 470740 on, the power comes from fuse # 17 (15a) in the Aux fuse panel. Power to the lock switch (in the drivers door) goes in on the brown w/blue tracer wire and on to the other door motors by orange w/red and orange w/ green tracer wires. Don't forget to test the black wire off the switch for a good ground. To lock and unlock the other doors and trunk the switch reverses the polarity on the two orange wires.


Feb 26, 2010 | Jaguar XJ6 Cars & Trucks

1 Answer

Heater fan not working in a 1996 Chevy S-10


I looked at wiring diagrams at bbbindustries: the orange wire to the 20 amp htr fuse is direct from the ignition switch. You might check: that orange wire splices to the 10 amp brake fuse (fuse #12). check if that also has any voltage problems.
There are two black fusible links that supply power to the ignition switch. the fusible links come from the battery junction block.

May 26, 2017 | 1996 Chevrolet S-10 Pickup

1 Answer

1976 ford van ,no brake lights, I tested the brake light swt. it is good but i need to know the colors that come out of the signal swt. for the brake lights


this is off a 1983 model, might be the same........green wire power from brake light switch into turn signal switch, coming out is green/orange wire, left brake.......orange/black wire, right brake.

Oct 16, 2009 | 1983 Ford Econoline

Not finding what you are looking for?
2000 Oldsmobile Bravada Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...