Question about 1996 Honda Odyssey

1 Answer

3rd light diagram - 1996 Honda Odyssey

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 73 Answers

Found these online for you... hope they help.
This first link is specific to your 1st Generation Ody....it's a great forum and hope you get your answers there
http://www.odyclub.com/forums/28-1995-1998-odyssey/20360-need-help-96-third-brakelight.html



http://www.odyclub.com/forums/52-2005-2010-odyssey/57976-how-replace-high-mounted-rear-brake-light.html
In my 2002 Honda Odyssey, the high brake light is accessed by removing a small triangular red piece from the right side of the cover. This piece often breaks but I was successful by soaking the area with STP silicone spray, waiting 15 minutes and then prying the piece up in the slot on the left side with a miniature flat bladed screwdriver. You then remove the underlying screw amd remove the housing. Twist the bulb holder out and remove the bulb by pulling straight out. Push the new bulb in - I usually hold it in a paper towel because by this time my hands are dirty. Twist the bulb holder back in. Push the housing back in starting on the left side. Replace the screw. Put in the triangular piece starting with the right side clip. I then pry the housing open with my screwdriver very carefully to fit the left clip in. If you break the piece it's under $10 at the Honda dealer. The piece is not well designed but you can make it work if you're patient.

Also, be sure you purchase the replacement light bulb lamp first before you tear everything apart. See sources and related links below for more light bulb information.

Read more: http://wiki.answers.com/Q/How_do_you_replace_high_rear_brake_light_on_a_Honda_odyssey#ixzz1nFpCWpiu

Posted on Feb 24, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 dodge journey


Follow the link for wiring diagram so you can trace the problem. http://bbbind.com/free_tsb.html

Dec 08, 2016 | Dodge Journey Cars & Trucks

1 Answer

700r4 transmission won't shift from 2nd to 3rd in my 1989 Chevy K2500 and I don't have reverse lights anymore either.


Check to make sure you have power down to the transmission. A wiring diagram will be extremely helpful.

Oct 26, 2013 | 1988 Chevrolet C1500

1 Answer

2000 Chevy Blazer wiring diagram


I HAVE 2000 BLAZER and the 3rd brake light works but the ones in the tail light do not work have turn signals and new bulbs but no brake light

May 28, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

Need symbol for 3rd brake light on ford fiesta 2003 fuse box


I use and I'd recommend you register for free at www.autozone.com Once registered you'll have access to repair and shop manuals for virtually any car or truck. All the data and diagrams you need now or may need in the future will be a couple of mouse clicks away. A diagram of the fuse panel is usually available.

Jul 19, 2011 | Ford Fiesta Cars & Trucks

2 Answers

95' Buick regal, 3rd brake light works, tail lights work, turn signals work, stoplight switch seems to work ie 3rd brake light working, fuse is ok, changed bulbs, but no rear brake lights.


If the third brake light works and the regular ones don't, it is most likely a bad turn signal (multifunction) switch. The switch is able to kill the brakes lights to run the turn signals, and in rare circumstances does this. I've seen it several times. It could also be wiring, especially near the turn signal switch, but it is usually the switch.

Nov 25, 2009 | 1995 Buick Regal

2 Answers

No brake lights on a 1996 ford contour ..3rd light and blinkers work fine I have ohm'd out brake switch on pedal and it is good ..blinkers on front and back both work.. no power to bulb socket on brown to...


The brake lights (excluding the 3rd brake light) go through the turn signal switch. It's possible there's a bad connection in the switch causing your symptoms. I would rule out the brake switch on the pedal, considering the third brake light works. Locate a wiring diagram for the brake light circuit, follow the wires into the steering column as far as you can and verify it's getting power up until the turn signal switch and verify no power is coming out of it. Once that's determined it's time to replace the switch.

Oct 04, 2009 | 1996 Ford Contour

1 Answer

I need a wiring diagram for a 1996 grand-am. the brake lights stopped working but the 3rd brake light still works.


I assume the stop lamp bulbs are OK.
Check the ground connection is ok at the rear brakelamp sockets.

Sep 07, 2009 | 1996 Pontiac Grand Am

2 Answers

Need a diagram for a chev s10 third door


please,if u get a diagram on that 3rd door let me know..lol i haven'tbeen able to open my 3rd door in about 5 yrs. I had it repaired several times just NO good on the ZR2

Aug 26, 2009 | 2000 Chevrolet S-10

1 Answer

1988 ford thunderbird brake lights and turn signals not working


When this happens the problem is most likely the multi-funtion switch aka turn signal switch. Check to see if the 3rd brakelight comes on when the brake pedal is pushed. If so replace the MFS. The 3rd brakelight in late 80's fords bypasses the turnsignal switch.

Dec 29, 2008 | 1988 Ford Thunderbird

Not finding what you are looking for?
1996 Honda Odyssey Logo

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...