Question about 1991 Lincoln Town Car

Open Question

91 lincoln towncar-the only lights that come on when I pull the switch is the headlights.all other lights work accept front blinkers and the running lights all together.i checked fuses and bulbs. Any ideas would be awesome

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: 1988 Lincoln Towncar

check them all there different fuses fo window and radio cheers pierre

Posted on Jun 25, 2008

michigan man
  • 3533 Answers

SOURCE: 2006 lincoln towncar Burnt out light bulb

I recommend autozone if you buy the bulb from them they will assist you but I believe it has to be replaced from inside the trunk

Posted on Jan 15, 2009

crayzeetrayn
  • 837 Answers

SOURCE: REPLACE HEADLIGHT ASSEMBLY IN 2000 LINCOLN TOWNCAR

Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.

Posted on Mar 13, 2009

inhisname
  • 76 Answers

SOURCE: 1989 Lincoln towncar cartier with electronic dash

hello, this is posaably a bad or loose ground in the circuit, it could even be in the headlamp switch itself. does the problem exist in the high beams as well?......good luck, marty

Posted on Jun 07, 2009

  • 564 Answers

SOURCE: how do I change a headlight on a 2006 Signature

open your hood locate the back of the light that you want to replace these are usually held in place by self locks turn the light counterclockwise until it unlocks pull it out of the opening be sure that you dont touch the tip of the new bulb with your finger or hand or youll blow it as soon as you turn it on (the oils in your skin) put the new one in and reverse the process to install.

Posted on Mar 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 91 Ford Explorer. Front headlights having issues. Good bulbs I believe. Sometimes when switching between high and low beams on the column, lights would go oput for a moment then back on....


Sounds like it has possibly got a defective multifunction switch,which is part of the turnsignal lever/high beam lever switch. Aside from physically diagnosing the circuit I would say replacing the multifunction switch may take care of your problem.


Hope this helps

Oct 23, 2013 | Ford Explorer Cars & Trucks

1 Answer

My 91 Lincoln towncar won't start. I get 1 click


E brakes not the problem you could have a dead spot in your starter .

Nov 30, 2012 | Cars & Trucks

1 Answer

My rear lights wont come on even though the brake lights and the head lights work. is it the running light modulator


If your car uses a modulator it might be the problem. Or the tail light fuse or the headlight switch.
The tail lights are on a different circuit from the brake lights.

Aug 21, 2012 | Cars & Trucks

1 Answer

98 nissan altima front left blinker does not work when headlights are on, works when headlights are off but blinks rapidly ,left rear blinker works when headlights are on or off but blinks rapidly also


the rapid blink is because there is a bulb outage some where, Pull Over turn on left Blinker Get out of your car look at the front left blinker hen walk to the rear of your car and look at the left rear Blinker light then do the same for the right side blinkers if all are working rapidly your left right switch is bad

Jul 09, 2009 | Nissan Altima Cars & Trucks

1 Answer

REPLACE HEADLIGHT ASSEMBLY IN 2000 LINCOLN TOWNCAR


Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.

Mar 13, 2009 | 2000 Lincoln Town Car

4 Answers

Dash and tail lights on a '91 Lincoln Town Car - quit working


From what you just said i dont belive the mechanic checked your fuses correctly.

Check your self to confirm, But if no avial i belive the controller for your lighting may be fried.

Feb 25, 2009 | 1991 Lincoln Town Car

3 Answers

Headlights


The only thing that all of your problems have in common is the light switch and the dash wiring harness. The stereo is linked to the light switch because of it's illumination feature' You need to test the light switch with a test light by probing the wires at it's plug.

Aug 26, 2008 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
1991 Lincoln Town Car Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...