Question about 2000 Ford Ranger SuperCab
I have a 2000 ford ranger and all of a sudden with no warning I began having problems. All at once my speed odometer stopped working and it did not want to go out of first gear. I lowered it into second and picked up my speed and popped it back into drive. Then the O/D light began flashing and further down the road the transmission jerked pretty hard a couple times until I got it back home and parked. What is going on, could someone please give me a little insight as what I am dealing with concerning what has to be done for repair??????
The best thing would be to have transmission control module - ( computer ) checked for DTC'S - diagnostic trouble codes . The flashing O/D light is trying to tell you that . The transmission is in limp home mode . A sensor or shift solenoid is most likely the problem . Your transmission is electronically controlled , has sensors , shift solenoids , an a computer that controls it all , plus electrical signals (inputs) from the engine computer .
Posted on May 07, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
crawl back under veh have somone shift trans with wheels blocked engine off look to see if shifter is still connected to trans. if is look too see if moves linkage all through ranghes to low .if it does remove trans pan too see if it moves inside trans.let me know ,,, If you took it to a shop thats were they would start.
Posted on Dec 13, 2008
Set your idle speed to mfg recomindation if that doesnt help check the dash pot that is what keeps the engine from stalling at sudden speed reduction
Posted on Mar 15, 2009
I had the same problem on a toyota truck after I had it lifted that is, the shif linkage was not properly adjusted. If I held the shifter down it would not jump outta gear, but hit a bump or stomp on the gas and it would
Posted on Mar 23, 2009
SOURCE: !998 ford ranger stuck in 4x4
sounds like it's the motor is going bad or has a bad connection, try cleaning the connector if there isn't any gunk in the connector, check the manual see if there is a ohmn test you can run on the motor, if not i'd replace the motor.
Posted on Apr 10, 2009
SOURCE: I have a 1991 Ford
Has fuel filter & spark plugs been changed lately, if not good inexpensive place to start. Does it happen more when you try to give it gas hard, or even when accelerating slowly? Worse in wet weather or no?
Posted on Apr 26, 2009
Tips for a great answer:
Nov 26, 2015 | Ford Cars & Trucks
Nov 18, 2012 | 1997 Ford Ranger SuperCab
Nov 25, 2009 | 2000 Ford Ranger SuperCab
Nov 17, 2009 | 2000 Ford Ranger SuperCab
Nov 30, 2008 | 2000 Ford Ranger SuperCab
114 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: