Question about Cars & Trucks

Open Question

Clk convertible rear seat back removal - Cars & Trucks

Posted by on

  • eric roberts Feb 26, 2012

    I needed to remove the back of the seat to remove the side panels to get to the main hood rams but was able to remove the side panels with the seat back in position. Thanks to all who offered advice and will probably need more in the future as I continue to refurb my CLK convertible 1998.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

freetek
  • 5568 Answers

SOURCE: remove back seat

In most cases, the factory installed rear speakers are accessible through the trunk, not behind the seat. Open your trunk and check if you can see them by looking up and forward in the trunk opening.

Posted on Nov 23, 2008

SOURCE: a4 convertible drivers seat.

I have had the exact same problem , the actaual cause of the seat not sliding back is due to the small cable retaing clip which fastens at the underneath of the seat this is a very common problem and is very trickY to get to as you say the rear panel appers to need to come off , it does not, you axs the small clip from removeing the liners at the very bottom of the seat where there is a footwell light , when you axs this area you be able to get to the clip or the actaul cable ,to which ever is broken,,

Posted on Jun 07, 2009

  • 3741 Answers

SOURCE: how to remove rear seat back 1987 mustang

Tools Required:

  • 3/8 inch Drive Ratchet
  • 3/8 inch Drive 3” Extension
  • 3/8 inch Drive 10mm Socket
  • 3/8 inch Drive 13mm Socket
  • T-50 Torx Bit
  • 1/4 inch Allen Wrench
  • 3/16 inch Allen Wrench
  • 1/2 inch Wrench
  • Drill Motor
  • 1/8 inch Drill Bit
  • 5/16 inch Drill Bit
  • 2 inch Hole Saw
  • Trim Tool (Fork Tool)
  • Electrical Tape
  • Center Punch
  • Hammer
------------------- Installation:

Remove Back Seat:
  1. Locate the retainers securing the seat bottom into the vehicle, approximately 10 inches from the end of the cushion, either side. Use your thumb to push in retainer release tab. Lift the seat up to remove.
  2. Remove the two 13mm screws securing the seat back, located on each lower corner. Lift seat upward to release seat back from brackets at the top. You can carefully prop the seat back under the retracted top , use caution if choosing this method not to damage or scratch the vinyl of the seat. You can remove the seat from the vehicle completely by disengaging the flanges securing the top of the rear seat to the fabric of the convertible top well .
  3. Remove Quarter Trim Panels:
    1. Grip the Quarter Trim Panel Cap at the shoulder strap opening and lift up to dislodge the retaining clips.
    2. The inside Quarter Trim Panels are two-piece panels. Remove the upper portion of the Quarter Trim Panel from the vehicle; it is not necessary to remove the lower portion. Pull the forward edge of the trim Panel over the pinch weld in the doorjamb.
    3. Use a Door Trim Tool (Fork Tool) to dislodge the pushpin retainer at the rear edge of the Trim Panel approximately 4” down from the top, pry Trim Panel toward the outside of car to release retainer.
    for more help click this link directly
    1. http://www.americanmuscle.com/05-07-lightbar-install.html ---------

Posted on Oct 05, 2009

  • 1 Answer

SOURCE: removing rear seat back

there my be bols holding the seats in place

Posted on Oct 21, 2009

emissionwiz
  • 75051 Answers

SOURCE: how do you remove 89 convertible mustang rear seat

hit it hard (with the side of your hand or palm) at the bottom of the seat on the right and the left to relase the spring retainers, run a putty kniofe under the seat edge to locate the spring retainers

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the rear seats in a 04 Toyota Convertible Solara


If you can't pull seat bottom up at front, ck for bolts at front edge of seat bottom.remove them first ,remove seat bottom. Then bolts for seat back wil be seen at bottom of seat back.

May 15, 2017 | Toyota Cars & Trucks

2 Answers

How to remove the rear headrests on a 2015 BMW 428i convertible?


Rear Headrest removal on Convertible - Bimmerforums

www.bimmerforums.com/.../showthread.php?...Rear-Headrest-removal...
Sep 6, 2008 - So I've searched and I've tried to yank the rear headrests out like what I'm reading and I ... Bimmerforums - The Ultimate BMW Forum - Powered by vBulletin... 3 series & 4 Series (E21, E30, E36, E46, E9x, F30, F32, F33, F44).

convertible - possible to remove rear headrests? (car seat issue ...

www.bimmerfest.com > ... > E90/E91/E92/E93 (2006 - 2013)

Mar 10, 2012 - 25 posts - ‎14 authors
Unfortunately the rear headrests or head restraint gets in the way and ... So as a temporary measure, I'm wondering if it's possible to actually remove the car's rear head restraints? ... HR&G Full Review: 2014 F33 428i M-Sport Convertible (my side .....2001-2015 performanceIX, Inc. All Rights Reserved . 335i convert booster seat - suggestions?
6 posts
Mar 17, 2008
Removing Rear Seats From E36 Convertible, Help!
17 posts
Feb 10, 2006
More results from www.bimmerfest.com

How To Remove Back Headrest BMW E36 - YouTube



Jan 16, 2016 | BMW Cars & Trucks

1 Answer

How do I remove the lens to Change backup light 2001 clk 430 convertible


I believe you do not remove the lens - rather you open the trunk and find the back of the lamp (you'll have to remove the panel in front of it) and remove and change the bulbs from inside the trunk.

Feb 13, 2015 | 2001 Mercedes-Benz CLK-Class

1 Answer

How do I remove the rear seat back on a 2004 clk500


remove the seat cushions and should be a screw at bottom of seat back at both sides, then grab hold of it and lift straight up about and inch or so then it should come forward and out.

Sep 19, 2014 | 2004 Mercedes-Benz CLK-Class

1 Answer

Mercedes clk convertible seat belt extender does not work ?


Its stuck or the spring is sprung. Remove the panel and access the belt and see what the problem is. Most times (98%) the belt is stuck and only needs to be unstuck. If thats is not it then replace part.

May 22, 2014 | 2003 Mercedes-Benz CLK

1 Answer

Location of hydrolic roof pump top up point for mercedes 320 clk convertable year 2000


It is located in the truck under a cover most likely behind the rear seat back cushion.

Oct 05, 2012 | Mercedes-Benz CLK Cars & Trucks

2 Answers

Passenger power seat on my 2002 CLK will move forward only and not backwards, how do I get it to work ?


Wiggle the switch that controls the problem movement, if the seats moves or jitters a little the switch is defective and will solve the problem. If nothing happens when you do this simple test then go under the seat and probe the large wiring connector the power seat transmission, when you move the switch to rear seat travel position and see if any of the wires light up, if it does show voltage when the switch is toggled then the seat transmission may be at fault. I think you have a switch problem based on my expereinces but do the testing because the part is not cheap.

Jul 17, 2012 | 2000 Mercedes-Benz CLK

1 Answer

2001 mustang convertible. How do you remove the rear seat to access the motor or pump ot check oil level? Thanks, Bruce


The seat bottom is held in with 2 release buttons located left and right of the center of the seat. (see photo) push with a screw driver and lift, then pull the seat bottom forward and remove.


gozer.jpg
The rear seat back is help in place by 2 self tapping bolts on the lower left and right of the seat back near the floor, if I remember correctly you'll need a 10mm socket. Remove the 2 bolt and lift up to remove the seat back. When re installing the seat back do not over tighten the bolts they have a tendency to strip.

Aug 15, 2011 | 2001 Ford Mustang

1 Answer

CLK 320, the SRS light come on


Hi, There is a connector on the bottom side of the seat belt buckle. remove the rear seat bottom and check to see if the connector is damaged or just disconnected. The srs light has to be cleared using a scan tool.

Feb 27, 2009 | 2002 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...