Question about 2001 Ford Explorer Sport

Open Question

How do I drain transmission fluid form a 2000 ford explorer sport 4x2

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 92 Answers

SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location

the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

Posted on Oct 21, 2008

  • 1 Answer

SOURCE: I need change the automatic transmission fluid Explorer 2002 E.B.

There IS a transmission drain plug on the 2002 Ford Explorer! It is, however, difficult to get the fluid back in as there IS NO dipstick (tube) to refill it. I installed the pan bolts far enough to hold the pan up (level) and then stuck a hose (attached to a funnel at top of engine compartment) through the opening between the pan and the bottom of the transmission. I was able to put five quarts in that way - no more as it will overflow (trust me). You can check other sites on how to check to see if that's enough and how to add more as needed. That's not simple either. Great idea Ford Motor Company (sarcasm) !!!!!!

Posted on Oct 13, 2009

  • 85 Answers

SOURCE: 05 Ford Explorer Transmission

on the bottom of the transmission pan you will find a nut with a hex or torx in the middle you remove the center plug when the truck is hot and running on a level serface the trans fluod will dribble out if it does not dribble out it is low if it runs out fast a steedy streem it is over full now their is a part that screws into this for a fill if you remove the pan you will see how it works the pan has a pipe/ stack that when full of fluid the top of the pipe is at the full point if you remove the large nut the stack and plug will come out the best way to change the trans fluid is take it to some place that has a fluid exchange equment this will get all the fluid out including the torque converter

Posted on Dec 27, 2009

cmcduncand
  • 714 Answers

SOURCE: how can i check to transmission fluid level in 2005 ford explorer

Does not have a dip stick.

Start the vehicle set park brake

In the side if the transmission oil pan a bigger bolt with a small bolt in the center.

Remove smaller center bolt trans fluid should drip out at a fairly constant rate if not its low.

Hope this tip helps.

r/
David

Posted on Feb 15, 2010

  • 73 Answers

SOURCE: Drain plug for 1998 Ford Explorer auto transmission 4x4

It does not have a drain plug. You have to loosen the bolts that hold the drain pan and let the fluid drain out that way.

Posted on Apr 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Ford Explorer sport is losing all the water from radiator


3 ways of loosing the coolant/water search for leak -hole in radiator,hoses at connections or damaged,water pump,heater core and hoses //blown head gasket coolant being burnt will show white smoke out tail pipe ,oil will show milky cocoa color ---//transmission oil cooler lines have internal damage in radiator and transmission has fluid draining

Aug 25, 2016 | 2003 Ford Explorer

1 Answer

Change oil transmission ford explorer 2002 4x2


i know you cannot check your transmission fluid like years prior to the 2002 they made this model so you have to take it into the shop/dealership to have them check your levels, and change the transmission. They are trying to eliminate the backyard mechanic from doing maintenance on the vechicles

Jun 17, 2014 | 2002 Ford Explorer

1 Answer

2003 ford explorer transmission won,t pull in any gear.


check make sure transmission fluid not too low or could have plugged transmission filter.or code scan for faulty transmission fluid pressure sensor or transmission range sensor bad or out of adjustment.transmission could have failed.garage has to run fluid pressure test see if transmission failed or you could have faulty shift solenoid..

Feb 26, 2013 | 2003 Ford Explorer Sport

1 Answer

I replaced valve body gasket on my 2001 ford explorer now it wont go in gear at all what could be the problem


Check your transmission fluid level. If you changed out the gasket more than likely you had to drain alot of fluid. Most people say 7-8 quarts but it takes more than that.

May 04, 2012 | 2001 Ford Explorer Sport

1 Answer

Hi there- i have a ford explorer 96 limited, o/d light is flashing constant- no reverse- would transmission conditioner harm anything if tried & what is an approx cost for replacement of transmision...


Hi, there no need to add anything to transmission its to late for that if you alredy lot reverse. For a rebuild unit and labor,fluid ,and i would add a cooler also you looking at any were between $1500 - $2000 dollars it all depens on shop rate and if its 4x4 or 4x2 . Thanks if i can help just re post.

Jan 08, 2011 | 1996 Ford Explorer

2 Answers

Transmission removal pictures for a 1996 ford explorer..i need to know how many bolts there are to remove the transmission from the motor


4x4 has seven transmission-to-engine bolts
4x2 has six transmission-to-engine bolts

You need to tell me though if this is an automatic or manual and 4x4 or 4x2 There are 3 different auto trannys: 4R44E, 4R55E then A4LD and 4R70W

Sep 06, 2010 | Ford Explorer Cars & Trucks

1 Answer

Where is the transmission drain plug on a 2000 ford Explorer


If you have an automatic transmission you dont have a drain plug; remove the trans pan to remove the fluid

Jan 30, 2010 | 2000 Ford Explorer

1 Answer

Draining transmission on 2000 explorer 4x4


there is no drain plug on the trans, u must drop the pan to service the trans, they do this so the trans filter will get changed while u are in there.

Apr 23, 2009 | 1998 Ford Explorer

1 Answer

Where is transmission drain plug 2001 FRD Explorer Sport


2001 Ford Explorer,depending on the engine option,will have either a 4R70W or 5R55E model transmission.Neither trans has a drain or fill plug in the pan or case.Changing the fluid is achieved either by removing all the pan bolts,removing the pan and fluid,then reinstalling and adding fluid through the filler tube,or by a shop that has a total flush machine that usually hooks into the cooler lines.I also change the filter on both transmissions as part of the fluid service.The 4R70W trans has a gasket that is reuseable for the life of the vehicle.The 5R55E pan requires a new gasket if dropping the pan.

Jul 17, 2008 | 2001 Ford Explorer Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

431 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...