Question about 2000 Dodge Grand Caravan

1 Answer

How much power steering fluid does it hold? - 2000 Dodge Grand Caravan

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

The system holds just under 2 pints, depending on what part you are replacing, you may not need this much fluid. if the fluid is contaminated and you need to flush the system you may use twice this much.

Posted on Feb 23, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the steering wheel pump on my southwind rv 1995 454 motor


Find the power steering pump. Loosen all the bolts holding the pump. Remove the fan belt. Remove the power steering hoses (collect the power steering fluid in a pan). Remove the pump itself. Install in reverse order. Add approved power steering fluid.

Apr 11, 2017 | Cars & Trucks

3 Answers

How do you bleed a power steering pump


hi.
power steering pumps do not normally need bleeding. just slowly turn the steering from one side full lock, to the other side and back a few times. this will get rid of any air in the system. keep an eye on the fluid leve while you are doing it though.

any problems after doing this would suggest a different problem, rather than air in the system

Apr 06, 2011 | 1989 Chevrolet K1500

1 Answer

Is it very difficult to change the power steering pump in a 2004 kia sedona?


  1. Remove the Power Steering belt.
  2. Disconnect the power steering hoses from the power steering pump. Take caution as there may be some pressure.
  3. Remove the bolts holding the Power Steering pump to the pump mount.
  4. Install the new Power Steering pump.
  5. Reconnect the power steering hoses.
  6. Reconnect the Power Steering belt.
  7. Top off with fluid.
  8. Start up the vehicle.
  9. Turn the wheel to the left.
  10. Top off with fluid.
  11. Turn the wheel all the way to the right.
  12. Top off with fluid.
  13. Repeat the last 4 steps until the fluid level doesn't change much, and is topped off.

Feb 18, 2011 | 2006 Kia Sedona

1 Answer

The power steering isn't working. The reservoir was empty and I added power steering fluid and it still very hard to steer


YOU HAVE A RUPTURE PRESSURE LINE IF YOU HAVE NO POWER STEERING FLUID IN THE POWER STEERING RESERVOIR.LOCATE LEAK THEN BLEED POWER STEERING SYSTEM BY ADDING POWER STEERING TO RESERVOIR.DONT OVER FILL BY FULL COLD MARK ON POWER STEERING DIP STICK.ADD FLUID TO RESERVOIR WAIT A 2 MINUTES.CHECK FLUID LEVEL AGAIN.WHEN POWER STEERING FLUID LEVEL STOP DROPPING.START ENGINE LET IT RUN FOR 10 SECONDS.THEN TURN OFF ENGINE CHECK POWER STEERING FLUID ADD FLUID IF FLUID LEVEL DROPS. WHEN FLUID LEVEL STOP DROPPING.SAFELY RAISE SUPPORT VECHICLE FRONT WHEELS.START ENGINE.NOW TURN STEERING WHEEL GENTLY FROM STOP TO STOP MEANING LEFT TO RIGHT DONT HOLD IN POSITION.LET THE STOP TO STOP BE QUICK.CHECK POWER STEERING FLUID AFTER YOU HAVE TURN STEERING WHEEL ABOUT 7 STOP TO STOP.WHEN FLUID LEVEL STOP DROPPING YOU AT HOT MARK ON DIP STICK BLEEDING PROCESS COMPLETE.TURN OFF ENGINE LOWER VECHICLE BACK TO GROUND WAIT ABOUT 5 MINUTES CHECK YOUR FLUID LEVEL.IF FLUID LOOKS LIKE A TAN COLOR.YOUR POWER STEERING SYSTEM FULL OF AIR.TURN OFF VECHICLE LET VECHICLE SET A LONG WHILE TO AIR BUBBLES SETTLE DOWN LOOK FOR LEAKS AROUND POWER STEERING PUMP FRONT SEAL AND CHECK FOR LEAKS AROUND POWER STEERING LINES.

Dec 01, 2010 | 1999 Oldsmobile Alero

1 Answer

How many quarts of power steering fluid does my 1993 Isuzu Amigo hold?


POWER STEERING FLUID SYSTEM YOU POUR A LITTLE FLUID AT A TIME UNTIL FLUID LEVEL REACH THE COLD LEVEL MARK ON POWER STEERING DIP STICK DONT OVER FILL YOU WILL BLOW THE FRONT SEAL.

Oct 29, 2010 | 1993 Isuzu Amigo

1 Answer

I have had the power steering pump replaced on my 99 pontiac grand prix, since then it has had no problems with power steering for about two months......then all of a sudden its making that whining noise...


YOU NEED TO BLEED POWER STEERING SYSTEM BY HAVING LOW FLUID AIR ENTER THE SYSTEM.PARK CAR ON SOLID LEVEL GROUND SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS.YOU CAN LEAVE CAR ON GROUND BUT TURNING STEERING WHEELS BACK AND FORTH WILL WEAR SPOT IN TIRES.TURN STEERING WHEEL TO THE LEFT WITH THE ENGINE OFF.CHECK POWER STEERING FLUID.ADD MORE FLUID IF LOW.MAKE SURE FLUID LEVEL ON COLD MARK ON DIP STICK.THE YOU CRANK CAR UP LET IDLE LITTLE HIGH FOR 15 SECONDS.THEN TURN OFF ENGINE.CHECK POWER STEERING FLUID LEVEL MAKE SURE ITS ON COLD MARK AT DIP STICK.THEN YOU START THE CAR UP WHILE IDLING TURN STEERING WHEEL IN BOTH DIRECTIONS SLOWLY TO THE STOPS DONT HOLD IN STOP TURN STEERING WHEEL LEFT AND RIGHT FOR SEVERAL TURNS.STOP ENGINE CHECK FLUID IF FLUID TAN STILL HAS AIR IN SYSTEM.LET CAR SET A LITTLE WHILE TRY THE BLEEDING PROCEDURE AGAIN.THERE IS A REASON POWER STEERING FLUID WAS LOW CHECK ALL POWER STEERING HOSES AT POWER STEERING PUMP TO THE RACK PINION ASSEMBLY.

Jun 13, 2010 | 1999 Pontiac Grand Prix

2 Answers

What liquids go in each resevoir?


Coolant in 50% concentration goes into the coolant overflow bottle. Windshield wiper fluid into the wiper fluid bottle. Power steering fluid into the power steering fluid bottle.
You do not need to add any other fluids to these. Do not add water to the washer fluid bottle for example, if you drive in a climate that would allow it to freeze.

Dec 21, 2009 | 2002 Lincoln LS

1 Answer

HOW TO REPLACE A POWER STEERING HOSE


FIRST OF ALL YOU HAVE TO REMOVE POWER STEERING FLUID.USING A SUCTION GUN OR LARGE SYRINGE.REMOVE MUCH FLUID AS POSSIBLE.WHEN DONE REMOVING POWER STEERING FLUID.YOU NEED A INLINE WRENCH AND OPEN BOX END WRENCH TO REMOVE THE POWER STEERING HOSE.YOU HAVE TO REMOVE POWER STEERING LINE FROM THE RACK.UNDER THE CAR SAFELY RAISE AND SUPPORT VECHICLE. THEN REMOVE THE TIRE OR WHEEL.THEN REMOVE THE INNER FENDER SPLASH SHIELD.ITS GOING TO BE A TIGHT FIT AND HARD PLACE TO GET YOUR HAND TO REMOVE THE POWER STEERING LINE FROM BOTTOM.WHEN DONE.MAKE SURE NEW POWER STEERING HOSE OR LINE HAS NEW O RINGS.WHEN INSTALLING THE THE NEW STEERING HOSE.WHEN ALL IS DONE BLEED POWER STEERING SYSTEM. FILL UP POWER STEERING PUMP TO CORRECT FLUID LEVEL.THEN LET IT SET FOR 2 MINUTES UNDISTURBED.THEN START THE ENGINE RUN IT FOR 2 TO 3 SECONDS.ONLY CHECK THE RESERVOIR AND ADD MORE FLUID AS NECESSARY.REPEAT THE OPERATION UNTIL THE FLUID LEVEL REMAIN CONSTANT.NOW RAISE FRONT OF THE CAR UNTIL THE WHEELS CLEAR THE GROUND START THE ENGINE AND INCREASE THE SPEED TO ABOUT 1500 RPM.NOW TURN THE STEERING WHEEL GENTLY FROM STOP TO STOP CHECK THE FLUID LEVEL.LOWER THE VECHICLE TO THE GROUND WITH ENGINE STILL RUNNING MOVE THE CAR FORWARD SUFFICIENTY TO OBTAIN FULL RIGHT LOCK FOLLOWED BY FULL LEFT LOCK BUT DONT HOLD THE SREERING WHEEL FIRMLY AGAINST THE STOPS.RECHECK THE FLUID LEVEL IF THE FLUID IN THE RESERVOIR IS EXTREMELY FOAMY ALLOW THE CAR TO STAND FOR A FEW MINUTES.WITH ENGINE OFF.WHEN JOB IS FINISH. WARNING DONT DRIVE CAR ON ROAD IF YOUR FLUID STILL FOAMY OR POWER STEERING PUMP MAKE NOISES.REBLEED THE SYSTEM AND CHECK FLUID LEVEL AND CHECK FOR LEAKS.DONT DRIVE CAR UNTIL YOU START FEELING NORMAL STEERING.IF YOU HAVE TROUBLE DONT DRIVE.HAVE IT TOWED TO THE NEAREST GARAGE.

Oct 05, 2009 | 1999 Oldsmobile Alero

1 Answer

Steering issues


Find the leak and repair it...It is a sealed system, if you are adding large amounts of power steering fluid, it is leaking out somewhere. Hoses, reservoir, steering box, power steering pump are places to check. You should only have to add minimal fluid to the system for the entire year.

The immediate squeal you hear is most probably the unit is out of fluid or has leaked onto the serpentine belt and causing it to slip.
Fix the leak and check your serpentine belt for wear.

Apr 23, 2009 | 2001 GMC Yukon XL

1 Answer

Power steering


some do some dont if you have a look under the bonnet see if theres a cannister that is labelled power steering fluid if your not sure turn the steering wheel to full lock with the engine running when you hold it on full lock it should make a sort of rubbing noise if it does its power steer if its power steering make sure your fluid is full also a broken power steering belt would cause it not to function also it only works with the engine running

Jun 02, 2008 | 1992 Daihatsu Charade

Not finding what you are looking for?
2000 Dodge Grand Caravan Logo

1,040 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...