Question about 2001 Hummer H3
How do I change the language from spanish to english in a hummer h3
With the engine off and the key on.Make sure all the doors are closed.Momentarily press the trip stem until the correct language is displayed.Hope this helps.Good luck.
Posted on Feb 26, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
switch ignition on. press instrument switch on off until oill reset appears then hold switch down for about 5 seconds and listen for faint bleeping noise oil is then reset.
Posted on Jul 20, 2009
I'm not 100% on this but I think it's like a lot of GM's; turn the key to the "on" position(not running), stomp the gas pedal to the floor 3 times within 5 seconds & the light should flash & go out.
Posted on Sep 24, 2009
I brought my 2006 H3 in to the dealer for the same thing. My blower stopped working all together but it started as an intermittent problem. He said he had to replaced a diode or resistor either behind the switch on the dash that controls the fan or on the fan motor itself. Have not had a problem since but that was only about 4 months ago.
Posted on Apr 09, 2009
follow the owners manual, usually 3 to 5 thousand miles, oil does not go bad but it absorbs contaminants, and can only do so much, also check any filters
Posted on May 05, 2010
SOURCE: 2006 H3 Hummer fan problem
Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner
Posted on Jun 11, 2010
Tips for a great answer:
Jan 01, 2016 | 2006 Hummer H3
Jul 16, 2014 | 2005 Renault Scenic 1.5
Sep 29, 2012 | 2006 Hummer H3
Aug 05, 2011 | 2006 Hummer H3
Dec 31, 2010 | 2006 Chevrolet Trailblazer
Aug 09, 2010 | 2006 Hummer H3
Sep 18, 2009 | 2007 Hummer H2 SUT
1,292 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: