Question about 1992 Ford F350
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Adjust your rear brake shoes. Then rebleed the system. Start at the master cylinder Bleed master first then the wheel furthest away from the master (right rear then left rear then right front then left front. Do that and your pedal should be good.
Posted on Dec 30, 2008
simple : obtain replacement pump from parts provider (no used stuff)
Now help me out here: thats the year they were bolted to the pass side front of engine
and not inside the tank right? (better go look to see for sure)
using a tube wrench unscrew the fuel lines (i use large wire nuts to temp block off fuel leakage)
with a 12 mm wrench undo the two side bolts holding the pump to block
wiggle pump it should come straight off
clean mounting place on block with solvent let dry
silicone back (or use gasket that comes with pump ) of pump
apply pump to block (depending on where crank stopped you may have some tension on arm you will have to overcome to get flange to meet block )
use locktite (blue)or simmiliar thread lock on bolts retighten firmly but not hang up the dog tight
use light grease or vasolene on tube connections don't try to tighten dry
Now the fun part your diesel now has air in the fuel system
there are two ways to remove this ( hard and harder)
your choice here are both methods
loosten the fuel supply line for #8 injector ( I did not say remove) 1 full turn ought to be enough
crank engine 30 seconds only
wait 5 minutes for starter to cool down
crank engine 30 sec again
did it start but runs rough while it's still running tighten #8 injector (caution fuel under high pressure)
engine smooth out good your lucky
engine did not start yet
wait 5 minutes
crank engine 30 sec again
if so tighten #8 injector up
Now here's something I've done to my diesel to make this much less a hasstle
trace fuel line as it comes up from pump
obtain a small low pressure electric fuel pump and a two short pieces of fuel line
and a few clamps
use tube cutter and cut fuel line just before it bends to go in filter
slide tube and clamps over pipe (both sides)
insert pump observe flow arrrow towards filter
the wires of pump can be stretched over to #1 battery terminals
now any time you change a filter or open your fuel system for any reason
all you need do is connect pump to battery
open sharader valve on top of filter for a few min
and start truck as normal
then disconnect wires and stow away for another day
Posted on Jul 08, 2009
climb under the truck! on the drivers side of the trans in the neutral safty swith unplug it and look for rotted connectors! if so repair damage! second go to passengerside near the rear of the trans ull see a plate that s being held by 2 7 or 8 mm bolts remove plate ! behind the plate there will b another plug do the same! inspect for corrosion
Posted on Mar 19, 2010
1st of all when Ford started out with putting "EGR's" on those diesel engines, they rushed it and are nothing less than a pain in the ***! i recommend having an EGR cleaning service performed by your local Ford dealer, i know they charge up the wazoo, but they're the best people to perform the service period.this is a VERY common problem with those engines and that service is "supposed" to be performed every 30K I believe. i dont recommend attempting to remove and service it youself, this WILL only make it worse.
Posted on Mar 26, 2010
Testimonial: "Im relieved to here that someone else is thinking the same thing. Im still going to try it myself as i am somewhat skilled at this but Thanks a bunch!"
Never, ever use starting fluid in your diesel.
Taken from the Owners Manual - Diesel Supplement:
Do not crank the engine for more than 30 seconds at a time as starter
damage may occur. If the engine fails to start, turn the key to OFF and
wait 30 seconds before trying again.
Do not use starting fluid such as ether in the air intake system (see Air
Cleaner Decal). Such fluid could cause immediate explosive damage to
the engine and possible personal injury.
Do not add gasoline, gasohol or alcohol to diesel fuel. This practice
creates a serious fire hazard and causes engine performance problems.
1. Make sure all vehicle occupants have buckled their safety belts. For
more information on safety belts and their proper usage, refer to Seating
and safety restraints chapter in the owner guide.
Posted on Sep 06, 2010
Tips for a great answer:
Dec 31, 2016 | 1992 Ford F350
Mar 16, 2013 | 2003 Ford F350 Super Duty DRW SuperCab
Oct 18, 2010 | 2000 Ford F350 Super Duty Super Cab
Mar 12, 2010 | 1992 Ford F350
Dec 24, 2009 | 2004 Ford F350
Sep 23, 2009 | 2000 Ford F350 Super Duty Super Cab
Sep 20, 2009 | 1992 Ford F350
Jun 27, 2009 | 1992 Ford F350
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: