Question about 2006 Cadillac Escalade

Open Question

2000 Cadillac Deville DTS: back up sensor light above rear window is flashing a red light while in drive. Backup warning yellow lights and bell are working fine.

Posted by on

  • Alan Feb 23, 2012

    Any ideas on why the light is flashing and how to resolve this issue?

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: 2002 Cadillac Coolant sensor

The engine coolant temperature sensor is located on the driver side of the engine near the rear of the engine compartment

Posted on Oct 08, 2008

emissionwiz
  • 75822 Answers

SOURCE: 1994 cadillac deville concours

Look if the engine is doing what you say then it is overheating and there is no problem with the sensor, remember the sensor only tells what is going on, it does not cause anything like overheating. Have you bled the system of air, there is a factory procedure to do this.

Posted on Oct 14, 2008

  • 1 Answer

SOURCE: how to remove drivers inner

how to remove drivers inner door panel on 2003 cadillac deville dhs to repair window trac

Posted on Dec 28, 2008

dealt_soul
  • 296 Answers

SOURCE: im receiving a check coolant

No the light is linked to a sensor. There is a coolent sensor that tells you that the level is low. It sounds like the sensor has gone bad. And the sensor is located in the coolent tank. If it is bad from my understanding you have to replace the whole tank. But take a paper clip with the engine off and disconnect the wire harness from the sensor and jump the wires and see if the light goes off.

Posted on Jan 20, 2009

  • 1986 Answers

SOURCE: Door panels

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Cadillac Deville DTS


The stability control system is typically triggered by the abs system/connector sensor on your wheel hub bearing. If you haven't replaced your hub bearings on the front you may have one going bad. Cheap fix for a diy.

Sep 09, 2014 | 2000 Cadillac DeVille DTS

1 Answer

2000 Cadillac Deville DTS 4.6L HO Northstar


Well, I don't think so. The pressure sensor will throw its own code (0450, 0451, 0452, 0453, or 0454). And likewise, the fuel level sender or sensor could also throw its own codes (P0460-P0464).

I'm not sure the level sensor and the pressure sensor are linked together. They are separate on a 2005 buick century, the pressure sensor being at the top of the tank located on the fuel pump module, but Cadillac: anything is possible.

Since you replaced the purge solenoid, there may be a problem in the circuit. The purge should have battery voltage to it with the key on. The ECM will ground the circuit internally when the purge is wanted. One symptom of a purge valve that isn't working or stuck closed can be a whooshing sound when the fuel tank cap is opened, indicating excessive pressure in the tank.
A shop's scan tool could be used to command the purge valve on to check it.

Sep 09, 2014 | 2000 Cadillac DeVille DTS

1 Answer

The service stability system light is on, and also when I drive over 70mph the car has a squeaks on the left side of the car


The stability light uses the same sensor as the abs system . I would be checking out the wheel bearing adjustment as the disc may be touching the sensor causing a problem

Aug 03, 2013 | 2000 Cadillac DeVille DTS

1 Answer

I have a 2000 Cadillac Deville DTS and the check engine light started to flash, i went to scan it and it said that cylinder 8 was misfireing. checked the coil pack and its fine, check the spark plug and...


DO SPARK PLUGS AND WIRES CHANGE IF NOT HAVE DONE TUNE UP IN A LONG WHILE. CLEAN FUEL INJECTORS.CLOGGED FUEL INJECTORS WILL CAUSE CYLINDER MISFIRE ALSO.

Mar 19, 2011 | 2000 Cadillac DeVille

1 Answer

HOW TO REPLACE A BACKUP LIGHT ON A 2000 CADILLAC DEVILLE


Look for the wires leading to the light on the 2000 Cadillac Deville.
Try to figure out which one leads to the 'white' light that is for backup.
If there is a replaceable bulb, then there should be a way of rotating a socket out from behind.
Some Devilles have LED lighting for the red brake lights, I think.

May 31, 2010 | 2000 Cadillac DeVille

1 Answer

Service stability sytem warning came on when i hit a bumps in the road. on a 2004 cadillac dts


Hello. Most likely you only jarred the sensors which caused the service warning light to come on. Take it to any AAMCO if you have one near by where they will scan the computer for free. While they have the scanner connected have them reset it which will turn off the light. Joe

Apr 02, 2010 | 2004 Cadillac Deville

1 Answer

I have a 2002 Cadillac DTS. It randomly dies when


Had same problem,called my Cadillac buddy and he said pick up both crankshaft position sensors.Charged me $100 cash and has not stalled again,drove me nuts for two years.

Jun 18, 2009 | 2002 Cadillac Deville

1 Answer

94 cadillac deville turn signal problem


Replace bulbs as the contacts have melted or corroded and they will cross contact to the running lights that come on with the headlights. Check all.

Apr 26, 2009 | 1994 Cadillac DeVille

1 Answer

No problem but a question about three lights above rear window


That is the BACKUP SENSOR SYSTEM indicator.
its detecting objects behind the vehicle.

Feb 27, 2009 | 2007 Cadillac DTS Sedan

1 Answer

Rear door panel 2002 cadillac dts


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Oct 02, 2008 | 2000 Cadillac DeVille

Not finding what you are looking for?
2006 Cadillac Escalade Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...