Question about Chevrolet Silverado 1500

Open Question

How to install dimmer signal switch on 2002 chevy silverado

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 507 Answers

SOURCE: dimmer switch replacement

Air bags have to be removed, but the steering column could be left in vechile. Although, it is easier to work with when it's out of vechile. And I'ld go someplace else. That seems a bit high for that job.

Posted on Sep 14, 2008

  • 1263 Answers

SOURCE: where is the dimmer switch

the dimmer switch is located in the steering column and is a part of the turn signal module. you must remove the steering wheel,column cover to remove the turn signal/dimmer switch module.

Posted on Apr 17, 2009

  • 1 Answer

SOURCE: location of the dimmer switch on a 91 chevy

the turn signle lever, in the columb tricky to do , it was about 160 for a columb repair shop to do
there are some relays under the hood on the fire wall passenger side. mine has what the relays are under the relay cover it looks like a big T see if it clicks when you pull on the turn siginal lever a relay may be the problem

Posted on May 16, 2009

  • 2007 Answers

SOURCE: 90 chevy silverado lights not working

You must have a bare wire at the back of your truck that's shorting out where gravel stones have pounded the outside coating off. If you have an after market trailer plug on there, you might want to check that out too. The connections to your main wires from the trailer plug, are never done properly, and always cause problems somewhere.

Posted on Jun 09, 2009

  • 77 Answers

SOURCE: turn signal/dimmer switch repair,dimmer switch

it is both replacable and repairable.
1. remove steering wheel
2. take off locking plate with two screwdrivers
3. remove locking plate
4. remove retaing screws and take out turn signal lever
5remove screws from hazzard switch (3)
6.take off panel under the dash to get to wire harness
7.remove harness and switch assembly

use wire or string tied to harness to pull that back thru the steering column

Posted on Dec 18, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hazard lights staying on and want cut-off on my 1995 Chevy Silverado 4x4

Sounds like a bad multi function switch. (switch handles turn signal, hazard and headlight dimmer switch)

Mar 02, 2017 | Chevrolet Silverado Cars & Trucks

1 Answer

My 2001 chevy silverado's low beams don't work. I

The wiring for the low beams would run not to the ignition, but to the dimmer switch. I don't know what color they are, but sounds like you are at the source of the problem, if the low beams quit when the column is let down. Pull the trim pieces off the steering column and examine the wires going to the dimmer switch. You may see some wiring insulation scraped off. It could be a bad dimmer switch, but check the wiring first.
Good luck.

May 03, 2012 | 2001 Chevrolet Silverado 1500

1 Answer

What does the dimmer switch on a 2002 Chevy impala do? And how can I replace it?

There are two "dimmers".. The first is used to switch between high and low beam healamps. This switch is integrated into the "smartswitch" which contains the turn signals as well. The other dimmer switch is for the dashboard lamps and allows you to adjust the brightness of the dashlights. This is part of the the headlamp switch assembly.This is a common failure item in impalas and when it fails it usually results in loss of dashboard lamps when driving at night. Replacement of the headlamp switch is necessary.

Dec 08, 2011 | 2002 Chevrolet Impala

2 Answers

2002 chevrolet cavalier, my brake lights, front and rear turn signals and hazard lights are not working

Your Hazard switch is bad. There were a bunch that had faulty soldering connections, and would fail prematurely. This circuit also competes with the turn signals, and the brake lights. Replace the switch with an aftermarket replacement, and it should fix your issue.

Dec 20, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

06 Chevy Silverado, when i put either turn signal on my back up lights flashes. Any suggestions!

Either you have a short within your turn signal and reverse light circuit...or someone is playing with you, and switched the bulbs around, and put them in the wrong socket,,

Dec 02, 2009 | 2002 Chevrolet Silverado 1500

1 Answer

Dashboard control panel lights on 2001 Chevy Silverado go off. Sometimes they come back on when I hit a bump. Electronic odometer, Drive indicator lights go off.

This could be either a bad headlight switch or dimmer switch. Sometimes the dimmer switch gets dust inside it and causes these symptoms.

Sep 13, 2009 | 2001 Chevrolet Silverado 1500

2 Answers

Where is the dimmer switch located at on a 1990 chevy silverado pick up, 305 engine

the dimmer switch is located in the steering column and is a part of the turn signal module. you must remove the steering wheel,column cover to remove the turn signal/dimmer switch module.

Apr 17, 2009 | Chevrolet Silverado 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides