Question about Cars & Trucks

Open Question

99 integra hatch wiring for third brake light

I have a 99 integra with aftermarket spoiler w/brake light trying to wire it up i have two wiring harness in the back hatch cover need to know which one is the brake light?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: can't get the spoiler, that holds the 3rd brake light on the off

when i had to take my spoiler off i had 2 plastic pins that were still holding the spoiler down i gave mine a good push and they popped right off. i have a 2006 nox

Posted on May 26, 2009

  • 1 Answer

SOURCE: rear speakers do not work with aftermarket stereo install

I had the same problem a while back after having a JVC MP£ player fitted at Halfords. The guy told me my sub-woofer behind the back seat wouldn't work with the new stereo which I said was ridiculous, then one of the other guys came to look and told him I needed a different cable to link everything together - then it worked brilliantly.
Sorry I dont know a part number but that is definately your problem.
I hope this helps - or better still that you already have it sorted !!

Posted on May 30, 2009

  • 66 Answers

SOURCE: How to replace and change the third brake light (

there should be a screw on either side of the black plastic case, after that it is simple

Posted on Aug 12, 2009

youredone82
  • 426 Answers

SOURCE: 99 JEEP BRAKE LIGHT WONT WORK..THIRD BRAKE LIGHT WORKS

on chrysler products the third brake light is run independant of the body control module, try checking the fuses that run the brake lights and see if any are faulty if not check you have voltage at the switch and a signal getting to the lights.

Posted on Aug 26, 2009

michigan man
  • 3533 Answers

SOURCE: i need a wiring digram for 99 f 350 diesel, engine

give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local Ford dealership in the parts department and they be able to print off the pictures and diagrams you need if all fails stop by your local library and get your hands on a Haynes auto repair manual for your truck wish you the best of luck Michigan Man.

Posted on Feb 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location third brake light wires


you can use one of the wires from either brake light and make yourself a good ground in trunk and running the two wires to you light switch. be careful where and how you run wires around the trunk hindges as you do not want them to become pinched and short out as that is a safety issue and get you pulled over. always solder and heat shrink all splices and wire to wire connections, if you dont you will hate your self later as wire from front of car to back of car could then need to be replaced.

Sep 12, 2014 | 2014 Dodge Dart

1 Answer

Brake lights on both sides are out. 2008 jeep liberty limited. 3rd light above hatch works. Tail lights work. Blinkers work. License plate light works. Bulbs are good. Replaced the brake light...


The lower brakes lights are not on the same circuit as the upper third "high" mount, so this is either a fuse issue from a short in the system or it is a brake light switch problem, if the park lock works (auto transmission only) the system has power and the problem lies in the wiring. attached is a link to a wiring diagram source, trace the circuit. http://bbbind.com/free_tsb.html

Jun 19, 2017 | Cars & Trucks

1 Answer

I have a 2007 Infiniti G35s sedan. I installed an OEM spoiler & spliced the spoiler wires to the 3rd brake light wires. Non of the brake lights work now including the 3rd & spoiler. What did I do?!...


Sounds like you have lost ground somewhere along the way. might try running a ground from spoiler to frame or simply replacing wires back to original and trying again. Would put my money on a ground wire. good luck

Aug 12, 2012 | Cars & Trucks

1 Answer

How to replace the high third brake light in the spoiler on the hatch back


you will need to find idendtical replacement bar,usually snaps in place with no adhesive,pry the l.e.d bar out with a screwdriver ,being carefull not to scratch the paint,you can use tape of any kind to mask around your work area.

Jun 04, 2012 | 2008 Hyundai Accent

1 Answer

Which wire in my 99 jeep cherokee sports hatch powers the break light?


Before chasing wires, I'd start looking at brake light switch. (I'm assuming you don't have brake lights) Brake light switches are a common problem - it's mounted just above your brake pedal under dash - small switch w/a couple of wires coming from it. Easy fix

Mar 28, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

How to replace 3rd brake light on 2004 Chrysler Pacifica?


the 3rd brake light is mounted to the spoiler. you need to remove the spoiler from the liftgate to acces the mounting bolts and the wire clip. there are five points of attachment of the spoiler,four hex nuts (metric) and one snap clip. two are accessable when the liftgate is open, they are in the corners of the liftgate. two more are under the upper rear window interior trim. the interior trim is held on by snap clips. if you pry outward on the trim starting on the right side of the window and work your way toward the middle you will be able to gain access to the two other nuts. once you have removed all four nuts, then close the liftgate and remove the spoiler by lifting up to disengage the last attachment point (snap clip). you will then need to change the light by removing the two nuts and disconnecting the wire clip. re-instal is the opposite of above. make sure that the wire for the third brake light does not get pinched when installed. (mine was improperly installed from the factory and the wire was pinched and this may have been why there was an early failure of the light)

Feb 18, 2010 | 2004 Chrysler Pacifica

3 Answers

Can't get the spoiler, that holds the 3rd brake light on the off


regarding chevy equinox spoiler there are three 10mm bolts one on each end and one in the middle then there are three pins in the middle that snap in. these are very difficult to release without breaking them. If they break use a two part adhesive sparingly to hold the spoiler down or it will hit when you open the hatch.

Apr 05, 2009 | 2005 Chevrolet Equinox

1 Answer

Need 02 trailblazer third brake light removal


Open the full hatch.
Pull down the weather strip near the rear dome light.
There should be a wire with a connector in it. Disconnect it
Close the full hatch.

Open just the window hatch. There is 1 screw on either side of the bulb housing.

Jan 20, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

2005 Lincoln Ls 3rd Brake Light Wiring


The best way to wire a third brake light is to run the wire directly from the brake light switch on the side of the steering colum to the light. You will need a test light to find out what wire lights up when you push the brake pedal. Then you can splice into it when you run your wire to the rear light.

Jan 01, 2009 | Lincoln LS Cars & Trucks

1 Answer

1995 ford mustang break lights do not work.


get a manuel from an auto parts store. in this manuel it will have etm(electrical troubleshooting manuel) it shows the brake lights and wires colors of wires. trace the wire color from the fuse using the diagram. purchase a test light from wal mart to see if your wire has power. if it does there may be a bad connection or component but hte etm shoud show you what components are on the circuit.any questions email me at jacobtaylor3@yahoo.com

Dec 31, 2008 | 1995 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...