Question about Fiat Albea

1 Answer

Need a manual for Fiat Albea 2005 4 door sedan 1.2 cc

Hi people , hard times in Greece and have to start fixing the car myself to save money , we are really tight with wages these days so if any one has an English manual to offer to repair the car or knows where i can find one do the kind thing and let me know..........before this crisis we were all OK but now we are down the river without a paddle.....keep your spirits up no matter what......thanks and cheers for any help....

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Fiat Master
  • 917 Answers

???????????? ??? ?? ??????????, ?????? ?? ??? ?????????????? ????

Posted on Jul 14, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 241 Answers

SOURCE: Drivers side door handle won't work

yes you will have to remove door panel to do the jhandle.

with the trunk problem i will recommend to wiggle the key to open it out other wise you will have to call a locksmith.

hope this helps

Posted on May 15, 2008

  • 21 Answers

SOURCE: fiat brava loud tappet

Depending in the mileage, sometimes the crankshaft bearings were out lowering the oil pressure. including an additive or one grade heavier oil could solve the tappets clicking. Also check the connections to the fuel injectors and the gas pressure to the injectors.

Posted on Jul 05, 2008

  • 21 Answers

SOURCE: Fiat Multipla 2002

In all these cases it appear to be a problem with the synchronizers or a dented pinion. To verify, the oil can be check for metal deposits. Fiats have bronze synchronizers and when placed under heavy shifting load they were out rapidly. if this is the case replacement is the solution and transmission has to be open. The car can be driven but gear will keep releasing. Sometimes the synchronizer level bends causing an incomplete setting off the gear.

Posted on Jul 05, 2008

  • 1 Answer

SOURCE: Fiat Punto

hi i have recently bought a 1200 fiat punto sporting and it driving my nuts every time i go to try fill it up the petrol backs up and comes out all over the floor can you tell me what causes it and if their is a cure as its inconvient and an embarressment

Posted on Jul 30, 2008

SOURCE: Fiat Multipla

This could be your water pump. The faster your engine turns, the worse the noise gets. Check the water pump for leeks. Turn the engine by hand (put a spanner on the crackshaft holding nut and turn) and listen for the noise. This will point the faulty componant. As for the square, if it is on any metal part it may need a welding repair. Without seeing the hole, I can be no clearer in my advice on the hole.

Posted on Nov 29, 2008

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 Focus power lock on right rear door does not work.

Yes you can doit yourself with lots of pantiaince, To save money get a used one from a auto wrecker, Allso get a hold of a repair manual , To guide you though it, You should be able to borrow one at a libarry,

Dec 07, 2012 | Cars & Trucks

2 Answers

Knocking noise when cornering

If you can figure out what side it is coming from, it is probably the velocity joint in the half shaft (drive shaft) going to the wheel. Please rate my answer so I am rewarded points for it.

Feb 02, 2012 | Cars & Trucks

1 Answer

Good morning! My 1990 Toyota Corolla 2 Door Sedan has been fine until the past 3 days. The car starts fine then several minutes after driving the car will die. I pull over on the side of the road, put it...

this may be a few things, the most common is a bad ignition coil,this looses spark and car dies, then after cranking a few times it will start to work again, the problem can also be a fuelpump doing the same thing, the best thing would be to check for spark when it dies but you would need someone to spin the engine while you were to see if the sparkplug wire was sparking,another common thing is the distributor itself or the cap, see this can go on and on without a good diagnoses you can throw parts at this car all day, it would be cheaper to have someone test it, they would need to drive it until it stalled and then do some quick testing before it started and this may take a few days because you said after a few times it will run fine,

Dec 10, 2010 | 1990 Toyota Corolla

1 Answer

How hard is it to do a tune up yourself?

Not hard at all .Hardest thing to do is to gap plugs.

May 13, 2010 | 2005 Toyota Camry Solara

1 Answer

They say my ignition module need to be replaced so my car will start can i fix it myself or is this a problem only the dealership can fix?

If you can locate it you can fix it. They are not hard to do. You may want to save some money and get one out of the junk yard.

Mar 31, 2010 | 1997 Buick LeSabre

1 Answer

Altima 2007 hybrid break problem

Very interesting post, But I can't help but think there must still be a problem if you have to press the brake pedal really hard. I am not doubting you one bit on what you were told but it seems a bit odd to me.

I can see where a bad brake switch could cause this problem, ( The switch that lets the car know your brake is applied and it is safe to start the car).

Thanks for your post.

Oct 02, 2009 | 2007 Nissan Altima 3.5 Sedan

3 Answers

My timming belt snapped on my fiat scudo will it damage the engine

as long as you dont drive it until its fixed it should be ok. YOu may have to reset your timing once you re-install it.

Sep 30, 2009 | 2005 Fiat Pininfarina

1 Answer

Need a user manual book

go to and purchase the service manual for your car, it will have 1000's of information that a book won't have and it will have all recall issues with the car and the location of any parts you may need to find and you can do it buy typing in a search and print out only what you need, saves money and you keep it for a year. Hope this helps.

Jun 18, 2009 | 2008 Toyota Yaris Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fiat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

77932 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides