Question about Dodge Pickup

Open Question

2004 dodge ram 1500 5.7 hemi error codes po172 and po175

Our 2004 dodge ram 1500 will not idle error codes are po172 and po175

Posted by on

  • shaffer81 Feb 23, 2012

    we have put new plugs,and an egr valve still will not idle

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
dustyboner
  • 331 Answers

SOURCE: Diagnostic code P2299 for 2004 Dodge Ram 1500 5.7 hemi?

P2299-BRAKE PEDAL POSITION / ACCELERATOR PEDAL POSITION INCOMPATIBLE

Set Condition:
The PCM recognizes a brake application following the APPS showing a fixed pedal opening. Temporary or permanent. Internally the PCM will reduce throttle opening below driver demand. One trip fault and the code will be set within 5 seconds. ETC light will illuminate, the light will only stay illuminated while DTC is active.




Possible Causes

DRIVER PRESSING ACCELERATOR PEDAL, THEN PRESSING BRAKE PEDAL, AND CONTINUES TO HOLD THEM DOWN SIMULTANEOUSLY

STOP LAMP SWITCH

APP SENSOR


The most likely cause of this DTC is Brake Torquing the engine by pressing the Accelerator pedal and the pressing the Brake Pedal.

Posted on Jul 17, 2008

Ad
  • 1129 Answers

SOURCE: 2004 ram 1500 with 5.7 hemi using 1 quart every 3,000 miles

Slide a large piece of cardboard under the truck after driving for ten minutes note in which area directly above the spot on the cardboard the oil is coming from then get under the vehicle with a drop light to look for the origin of the leak, if no leak is detected then it may be the engine is burning oil this could either be valve stem seals or broke or worn oil rings.

Posted on Sep 12, 2009

  • 151 Answers

SOURCE: 2004 ram 1500 hemi 5.7 alternator

You need to release the belt tenion before, removing the alternator. The engine is equiped with auto tenioner.

Posted on Sep 14, 2009

  • 249 Answers

SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi

i have an 02 and i purchased a repair manual from autozone

Posted on Jan 05, 2010

shark2th667
  • 343 Answers

SOURCE: My 2004 Dodge Ram 1500

faulty O2 sensors will throw a lot of things out of whack so start there, allow diagnostic reboot, drive and check codes again...

Posted on Oct 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 dodge ram 1500 (Hemi) is overheating at idle but does fine on the highway, what could cause this?


According to anandtech.com, Tom said: "If this only happens at idle and your fans are operating and your coolant level is good, my suspicion is the thermostat. "

May 12, 2015 | 2004 Dodge Ram 1500

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

1 Answer

I have a few error codes for my 2004 dodge ram hemi 1500 4x4. they are po172, po300, and po304.


The p0172 is due to an O2 sensor in the exhaust seeing too much oxygen, the po300 is a missfire present and p0304 is cylinder #4 missfire, check plug and wire to #4 and repair, this should also take care of the p0172, if a cylinder is missing it is just pump air into the exhaust thus causing the code p0172.

Jan 13, 2012 | Cars & Trucks

1 Answer

My 2004 Dodge Ram 1500 Hemi 5.7L V8 is running two codes PO175 fuel system rich 2/1 and PO131 O2 Sensor circuit 1/1 low does this mean I need new o2 sensors or what?


faulty O2 sensors will throw a lot of things out of whack so start there, allow diagnostic reboot, drive and check codes again...

Oct 01, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer

My 2004 ram 1500 hemi has a very rough idle when in gear still has tons of power


Get the codes read and you will find out which coil pack you need to replace.

Nov 08, 2009 | 2004 Dodge Ram 1500

1 Answer

Dodge Intrepid codes


could be a vac leak. what are the definitions for the codes??

Sep 21, 2009 | 2004 Dodge Intrepid

1 Answer

Knock Sensor location on a 2004 Dodge ram 1500 5.7 hemi


2 knock sensors are used..small black plastic sensor bolted into engine block below each exhaust manifold..be careful not to over torque bolts upon installation

Feb 24, 2009 | 2003 Chrysler PT Cruiser

2 Answers

04 Dodge Ram 1500 Hemi 2WD O2 Seneor


change up and down stream o2 senors

Dec 15, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

601 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...