Question about 1994 Chevrolet C1500
Both trans or 4l60e just want to know will it work if so do i have to change anything
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Replacing a 4L60E with a 700R4?
Not with good results, the 4L60E is run by your ecm, the 700R4 while looking close to the same does not relie on your ecm for commands,it relies on a cable to regulate your line pressure.
Posted on Jan 01, 2009
here is a place to call that sells only GM parts and they will also let you know what will fit your truck Schram auto and truck parts 1-800-292-1032
Posted on Feb 21, 2009
actually i would say no because there are 6 cyl transmissions with 4 frction plates and v8's have 5 friction plates in the forward planetary gear
Posted on Mar 27, 2009
The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.
Posted on May 26, 2009
Installing the full-size Blazer trans into the S-10 would be safer. As long as they came off of the same size engine then yes, they will interchange. But.... the trans off of the S-10 is not built as strong as the trans for the full-sized Blazer, clutch capacity is less, band servo may have smaller apply area, and torque convertor stall speed may different enough to set a "code". Towing capability would be compromised. I have no idea what you meant by the "bolt for the plate".
Posted on Jul 08, 2009
Tips for a great answer:
May 08, 2016 | Cars & Trucks
Mar 06, 2014 | Cars & Trucks
Aug 08, 2010 | 1999 Chevrolet S-10 Pickup
Jun 06, 2010 | Chevrolet Suburban 1500 Cars & Trucks
Feb 13, 2010 | 1998 Chevrolet K1500
Sep 23, 2009 | 1994 GMC Sierra
Apr 04, 2009 | 1992 Buick Park Avenue
Feb 24, 2009 | 1991 Chevrolet K1500
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: