Question about 1999 Ford F350 Regular Cab

1 Answer

1999 f350 superduty dash light with the (!) came on what is it for

Is this the check engine light my snap on scanner says no codes present or pending, how do i clear the light

Posted by on

  • harrybuck716
    harrybuck716 Feb 23, 2012

    The problem turned out to be a bad park brake switch, thanks for the help



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sounds like the low tire pressure indicator. Check the air pressure in all 4 tires. If thats not the problem then it could be a sensor gone bad. Cold weather sometimes plays havoc with the tire pressure

Posted on Feb 23, 2012


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 353 Answers

SOURCE: how do you change glow plugs in 06 f350

Glow Plug: Service and Repair
Glow Plug
Special Tool(s)

6c247a7.jpg Removal
1. CAUTION: Do not pull on the wiring to remove the glow plug connector or damage may occur.
Only one glow plug connector shown.
Using the special tool, remove the glow plug harness.
2. NOTE: If coolant residue is found on the glow plug, a new glow plug sleeve may have to be installed.
Remove the glow plug.
1. Install the glow plug.
- Tighten to 19 Nm (14 lb-ft).
2. Clean and apply clean engine oil to the O-ring seals.
3. Using the special tool, install the glow plug harness.


There is a speed sensor on each front hub and one on top of the differential.

Posted on Sep 22, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Tdc light comes on then loses power then light goes off then car picks up speed

First thing you need to do is to have the car scanned with a engine malfunction light scanner . then you'll get a engine trouble code. even if the check engine light shuts off for sure you'll get a pending code witch is a code that was seen but could be not present at the time you scan the car.

depending on what is the code then search on google for bmw engine trouble code list and repair procedures.

to find out what codes meens go to that link

Nov 07, 2015 | BMW 320i Cars & Trucks

2 Answers

I have a 99 crown vic intercepter that is hesitating when i push on the gas.also the check engine light is flashing

Can't solve the problem without getting codes from scanner, but you should absolutely not drive a car with the check engine light "flashing" as this is an indication from the computer that serious engine damage will occur if you continue driving. This is with any car with a flashing check light.

May 28, 2014 | 1999 Ford Crown Victoria

1 Answer

I have a 2001 f350 superduty 7.3L with no headlights

Have you checked the main light switch, not the dimmer, look for a burnt connector to the main light switch, if found replace the light switch and the connector, the repair connector from the dealer must be soldered in and shrink tubed, no quick connectors. Here is a picture of the main light switch and the cost and part number.
MOTORCRAFT Part # SW5994 w/ Conventional Headlamps; w/o Fog Lamps


Jul 12, 2012 | 2001 Ford F350 Super Duty SuperCab

1 Answer

I have a 99 350 superduty and fuse 3 under the hood has bkown and u would like to know wat it is the engine is a 7.3

It's for the right side stop and turn light for the trailer. It should be a 7.5 amp fuse (mini). Hope this helps....

Mar 10, 2012 | 1999 Ford F350 Regular Cab

1 Answer

Where is the fuse for the cigerette lighter/adapter?? for a ford f350 superduty desiel

Should be under the dash on the drivers side. Check your manual for the exact location of the fuse in the panel.

Oct 17, 2011 | 2000 Ford F350 Super Duty Super Cab

1 Answer

1999 Honda Civic, special edition , engine light on thank you

The check engine light in honda 99 come on mostly when you have bad gas tank cup,or you dont tight enouhg the gasoline tank cup,you can see if the problem of the check engine light is from what i talking about,going to any autozone and request the obd scanner,at no charge just leave your driver license or credit card,conect the scanner follow the isntructions,if the code in the scanner is p 1456,then the problem is that above,so dont panic car is almost normal,just give extra snap to the fuel tank cup and the check engine will come off in the next 3 to 5 days.

Dec 02, 2009 | 1999 Honda Civic

1 Answer

99 f350 fuse for the speedemeter

there is no speedo fuse . if it was a fuse the whole cluster would not be working . i think speed sensor with is on the trans . you should have a shop check this befor you start replacing parts

Jun 10, 2009 | 1999 Ford F350 Regular Cab

2 Answers

1999 F350 crew cab 4x4 ford, gear shift lever

Ok ready to stand on your head under the dash?
It's doable... there is a flange connected to the gearshift lever under the steering column. If you remove the lower dash cover where the fuses are, you should be able to see it when you move the gear shift lever... look around on the floor of the truck to see if you dropped a star-headed bolt or two... these bolts worked loose on my superduty and made shifting very was an easy fix... let me know how you do on it.

Dec 06, 2008 | 1999 Ford F350 Regular Cab

Not finding what you are looking for?
1999 Ford F350 Regular Cab Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides