Question about 1999 Ford Expedition

Open Question

What sizes is the bolt AC compressor for ford expedition 1999

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 99 Answers

SOURCE: Brake line burst 1999 ford expedition

Which brake line are you talking about?. The metal steel ones,or the rubber ones. Doesn't matter. If you are buying the rubber ones, then just ask for them by year and model of truck.

If you are working with the steel ones, they are either going to be 5/16 or 1/4 depending which line it is. the 5/16 ones are usually attached to the master cylinder or the ABS unit. The fittings sometimes if you don't find the right one have to be re used, in which case you will need to flare the tubing. (Double Flare) Or you can go to the dealer, pay an arm and a leg, but you don't have to flare the tubing, which takes the fun out of the job.

Posted on Apr 07, 2009

Ad
  • 2 Answers

SOURCE: what size belt bypasses ac compressor on 2001 ford

I just went threw the same thing. I found that Auto Zone's 822K6 belt fit perfectly. Hope this helps you

Posted on Jun 27, 2009

  • 226 Answers

SOURCE: where is the low pressure ac port on an 1999 ford

If you find the big round silver thing (reciever/dryer) it is in it or in the same line nearby. Probably area of passenger side close to firewall. The low pressure side is the larger of the tubes.
Lee

Posted on Jun 02, 2010

  • 5546 Answers

SOURCE: What tires can fit a 1999 ford expedition xlt

I believe it will fit. If you go to DiscountTires.com you can use their site for alternate tire sizes. Especially handy is the feature which shows you the Speedometer error for different size tires. The site will also show you recommended and popular substitute tire and wheel sizes.

The 1999 model had a 265/65/17 as an alternative. You may want to ask the Tire store you intend to use if they can reconfigure your Speedo to be accurate. Some of the Fords can be done electrically without changing Speedo gears.

I did something similar by going from a "60" series to a "65" series in the same width. On my Grand Marquis, I gained 5% mileage improvement, but have to watch Speedo until I get it reconfigured. I hope this helps to answer your questions.

Posted on Jul 27, 2010

Testimonial: "can u help me a bit more, & tell me the size of rims & tires that could fit. im on a site called wheelsnext.com & i dunno which tires will fit or rims"

  • 1 Answer

SOURCE: 1999 ford Expedition caliper removal

IT IS RUSTED ON GO TO YOUTUBE AND SEARCH
"Remove Rusted Brake Rotors"

Posted on Jan 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ac clutch will not engage on my 1999 ford expedition


It sounds like it's either out of freon, or compressor oil. You can pick up a can of refrigerant that has the oil in with it at any Autozone or Advance Auto. It'll have the pressure gauge and fill hose with a coupler already on it. Hook it up with the engine running and a/c turned on...compressor should kick on pretty quickly. Hope this does the trick for ya!

Jul 15, 2012 | 1999 Ford Expedition

2 Answers

How to turn off air compressor on 1999 ford expedition


  • Under the hood in the relay panel will be a relay for the compressor. When you locate the relay box look on the underside of the lid for the legend (layout) of the relays. Pulling that relay will stop the compressor from turning on.
  • You can also just unhook the connector on the compressor and secure it to stop the compressor from turning on.
  • If you need the compressor clutch to not turn at all, like if the bearings are bad, then you need to buy a smaller belt to bypass the compressor all together.

  • Hope this helps and thank you for using FixYa.

Regards, Tony

Jul 19, 2011 | 1999 Ford Expedition

1 Answer

I have a 1999 ford expedition and my ac is not cold! I checked fuses and they all seem fine. The ac is blowing but its not cold! How can I tell if its the compressor? Could it just be the a/c clutch...


Hi Kaseyloe, I think that the first thing you should have inspected is the AC gas pressure. If its leaked out, the unit won't run. The clutch of the compressor won't activate. Best take it to a refrigeration company and have them check it for you.
Regards Johngee10

Jun 10, 2011 | 1999 Ford Expedition

1 Answer

I have a 1999 Ford Expedition, Eddie Bauer. The ac compressor clutch will not kick in when useing the climate control. The system is fully charege. I ran power directly to the comperssor and the clutch...


Check the high and low pressure switches, either switch can cause the compressor not to run. Look for the switches in the high and low side lines. Hope this helps, let me know.

Sep 22, 2010 | 1999 Ford Expedition

1 Answer

A/c low pressure quick disconnect location? 1999 ford expedition


on the tube between the firewall and the a/c compressor. On some Fords the low pressure port is on the dryer2_bing.gif (aluminium cylinder). Good news is the low pressure and high pressure port are different sizes. You cannot mess it up.

Remember the flow for the a/c system is :
1. From the compressor a high pressure (HP) gas goes to the condenser in front of the radiator.
2. From the condenser a HP2_bing.gif liquid goes to an expansion device (orifice tube or expansion valve)
3. From expansion device the low pressure gas enters the firewall to the evaporator.
4. From evaporator the low pressure liquid/gas mixture goes through the dryer back to the compressor suction

May 29, 2010 | 1999 Ford Expedition

1 Answer

How to change ac pulley on 1999 ford expedition


Remove the bolt from the front of it pull the clutch off then there's a spring clip behind the clutch remove that then lightly pry between the OUTSIDE of the pulley and the compressor it should work off

May 11, 2010 | 1999 Ford Expedition

1 Answer

Where is the AC Charger located for a 1999 Ford expedition.It is a v8


follow the large ac line/hoes from the ac compressor u will come to the small ac service port ,this is the one

Jul 05, 2009 | 1999 Ford Expedition

1 Answer

Cant find AC charger in a 1999 frod expedition. V8


look for the large ac line/hose coming from the ac compressor and follow it untill u come to the ac service port , it is the small port.

Jul 05, 2009 | 1999 Ford Expedition

3 Answers

What is the tire size for a 99 ford xlt expedition


Your truck has 2 wheel sizes availiable 16" and 17"
here are the sizes for whatever wheel size u have.
255/70-16

265/70-17

Apr 16, 2009 | 1999 Ford Expedition

Not finding what you are looking for?
1999 Ford Expedition Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...