Question about 1988 Toyota MR2

1 Answer

Hard to change gears

Hello

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 119 Answers

Hard to chenge gear it can be clutch problem or you need clutch adjustment.

Posted on Oct 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a problem with my golf 4 gti 1.8t....when it's cold it doesn't change gears I always have to wait and warm it up.... Once it's hot it will change the gears normal.


Hello Bongs,

Not an uncommon complaint...varied VW models (and German cars in general) are known to be hard to shift when cold.

Less-than-stellar 1-2 syncros? Zero tolerance build specs?

Some people have reported double clutching helps..some have suggested moly additives..others have suggested changing the gear oil to synthetic. Give your local VW dealer a call and inquire about any additives they recommend for your hard shifting GTi.

Jul 21, 2016 | Cars & Trucks

1 Answer

Gear shifting problems in Honda Prelude with Automatic transmission only when gearbox is cold


While just change ATF oil or CVT oil in transmission & old filter too. your car problem will be solve....

Nov 21, 2013 | 1998 Honda Prelude

2 Answers

Automatic Transmition Shifting Problem when Engine is cold


The auto was notorious for clutch pack failure. Tolerances were tight in the inner workings and this caused inadequate oil flow and poor cooling. Sooner or later the auto transmissions fail. You could have the transmission rebuilt but that will cost a bit to do it so it wont break again. I might recomend going back to honda atf and changing the fluid again. If that does not work try an additive oil for the transmission. I had some sucess with the recomend product.

last resort, have it swapped to a manual transmission. This is a cheap alternative as f series transmissions from the accord can bolt up to the h22 and can be found cheap at the expense of higher gear ratios.

Nov 21, 2013 | 1998 Honda Prelude

1 Answer

Hello, this mornign when i take the car i find out when i try to change the gear its comme really hard,,,,speacially in gear one and the backup one, i think its the clutch cable but im not sure,,,and im...


it might be adjustment on your cable or your clutch could be worn
all the other gears will be easy cause there synchromesh
should get you home use second gear starting off will go in easier
goodluck

Mar 02, 2011 | 2003 Kia Rio

1 Answer

HELLO FRIENDS, I HAVE PROBLEMS WITH MY 2002 EXPLORER LIMITED, THE CHANGE OF THE THIRD SPEED DOES IT TAKE TO DO IT FOR THE FOURTH AND WHEN DOES IT HIT HARD. Scan showed THE CODES P0733 AND P0745. WHAT...


CODE PO733 INCORRECT THIRD GEAR RATIO.POSSIBLE CAUSES.THE THIRD GEAR SOLENOID HARNESS CONNECTOR NOT SEATED.THIRD GEAR SOLENOID SIGNAL SHORT TO GROUND OR OPEN.THIRD GEAR SOLENOID WIRING HARNESS CONNECTOR DAMAGED.THIRD GEAR SOLENOID DAMAGED NOT SEATED PROPER IN PLACE. CODE PO745 TRANSMISSION FLUID PRESSURE SOLENOID CIRCUIT MALFUNCTION.

Feb 15, 2011 | 2002 Ford Explorer

1 Answer

Gear getting stuck hard to change gears


Hello your looking at a clutch most likely if your gears are not enjoying this means clutch is at adjustment end these clutches are self adjusting and hydraulic and the clutch slave cylinder is internal on the transmission spleen.So you will eventually not be able to get your vehicle to go in gear,Also your clutch master cylinder the fluid level should be checked most times these leak internal causing the clutch plate to become wet ounce that happens time to change it.The best advise would be to take it in to a transmission shop hoist it up you will need a hoist to further inspect quotes are free and maybe get two separate quotes on the job this is a big job even for a qualified mechanic.

Jan 24, 2011 | 1995 Isuzu Pickup

1 Answer

BMW 523 Auto gerbox when cold change from 1 to 2 gear is hard


hello there

The problem is with the gear oil. To keep ahead of the rest BMW started what they call life time oil for their gear boxes, though that sounds great it doesn't really work in reality, they have now gone back to recommending a gear oil change every 60k miles.

In short you need to change your gear oil and soon, the oil in your gear box is no longer effective and will damage the gear box. You'll need about 5 litres for your car and costs around £15 a litre, expensive stuff!! I had the same problem with my 328i auto, the dealer was clueless and kept quoting the lifetime oil, I changed the oil and the problem has gone and it's so much smoother.

Hope this helps, please don't forget to rate me.

Apr 30, 2009 | 2001 BMW 5 Series

Not finding what you are looking for?
1988 Toyota MR2 Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...