Question about 2004 Chevrolet Malibu

Open Question

How do I remove/replace starter in my 2004 Chevy Malibu?

Starter needs replacing.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3640 Answers

SOURCE: starter replacement in 2003 chevy malibu

disconnect negative battery terminal, raise vehicle,remove splash sheild, if equipped. take wires off of solenoid on starter, remove starter mounting bolts, remember not to mix up wires!! --to install--put starter back in vehicle put in bolts,hook up wires, then replace cable back on battery.

Posted on Aug 27, 2009

nvannoy
  • 234 Answers

SOURCE: How do I replace my starter?

Open hood.
Disconnect negative (-) batter cable
Locate the starter (under vehicle).
Remove electrical connections. (be sure to remember/take a picture/ make a drawing/ or mark which wires go to what posts)
Remove mounting bolts.
Remove starter, replace with new starter
Install mounting bolts
Install electrical connections

Posted on Jan 06, 2010

  • 701 Answers

SOURCE: Removing fuel filter to replace it

Hello thor74: My name is Roger and I can help. I enclosed a picture of the filter location for you. Also a explanation of what tools are needed. Please rate the quality of the information. This tracks you received the correct information you requested. Should you need further help please just ask.Thank You for using FixYa. Roger698d306.jpg

Posted on May 05, 2009

dmsr63
  • 2050 Answers

SOURCE: Wiring Diagram 1998 Chevy S-10 starter replacement

The starter has one large cable from the battery positive, and a wire that goes to the solenoid (Part of the starter) that becomes hot when the key ignition is turned to start. This also passes through the neutral safety switch. (So it wont start in gear) Not sure if this is what you need, a little vague.

Posted on Jul 06, 2009

  • 1986 Answers

SOURCE: Need to replace passenger side mirror of 2004 Chevy Malibu max

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Smoking starter


when mounting a chevy starter you must shim it down so it wont lock up when the bendix hits the flywheel..if it binds up it will burn up..there are different thicknesses of shims that fit between the block and the starter nose cone..use one or a combination of these to shim down enough that it wont drag..shim too far and it will spin out..I have owned chevys for years and have yet to see one that did not need shimmed down..these shims fit over the mounting bolts on the starter..

Dec 27, 2013 | 2004 Chevrolet Malibu

1 Answer

HI, I HAVE CHEVY MALIBU 2005, IT HAS THE FOLLOWING PROBLEM: IT DOESN'T START THE ENGINE WHEN YOU TURN ON THE KEY


you do not get an clicking sounds from your starter at all when you turn the key ? You might have to replace the starter because they do go bad on you. I just had the same problem myself and had to replace the starter so fun job for me because I had to get underneath my Daewoo car to even get to the starter and replace it.

Jun 18, 2011 | 2005 Chevrolet Malibu

1 Answer

1999 chevy Malibu... Battery is fine and dash lights are fine when key is turned on but starter will not even attempt to engage.


Remove the power wires to the starter, turn the key to start to check for power, should have 13.6 volts, or what the capacity of you batteery is at the time, check it with a volt meter. If got power, replace starter or unbolt it from engine, it may be stuck in the flywheel,you'll see it release if just stuck,then replace on car and try to start before buying a starter.

Oct 19, 2010 | 1999 Chevrolet Malibu

1 Answer

HOW DO I FIX/REPLACE STARTER ON 1999 MALIBU?


Starter Solenoid needs to be replaced.
Remove starter and install new solenoid

May 05, 2010 | 1999 Chevrolet Malibu

2 Answers

Where is the starter located on a 1999 chevy


Follow the positive battery cable down to the starter.

Dec 27, 2009 | 1999 Chevrolet Malibu

1 Answer

Starter replacement in 2003 chevy malibu


disconnect negative battery terminal, raise vehicle,remove splash sheild, if equipped. take wires off of solenoid on starter, remove starter mounting bolts, remember not to mix up wires!! --to install--put starter back in vehicle put in bolts,hook up wires, then replace cable back on battery.

Aug 08, 2009 | 2003 Chevrolet Malibu

1 Answer

HOW DO HOME TEST A STARTER ON 2002 CHEVY MALIBU


Remove the starter and jump the connections to a Battery to see if it spins. Make sure you connect positive to the positve end and the neg to the neg end. Hope this helps.

Jul 02, 2009 | 2002 Chevrolet Malibu

1 Answer

Chevy Malibu starting problems.


It sounds like you have a short in the solenoid... You will have to replace it in the near future and is sold with the starter/or without I would suggest purchasing starter and solenoid....Good Luck

Jan 10, 2009 | 2004 Chevrolet Malibu

1 Answer

How do you replace the starter in 1998 chevy malibu


The starter is very simple to replace, 1st always disconnect the battery, the wires at the starter are hot with 12 volts always present, remove the 2 attaching bolts for the starter to the engine block, then remove the wiring, one heavy cable and a bunch of smaller wires, one of those goes to the starter solenoid, mark it, the others are what are called fuse links and provide power to the rest of the car, clean up everything and then re-install in reverse order.

Dec 01, 2008 | 1998 Chevrolet Malibu

Not finding what you are looking for?
2004 Chevrolet Malibu Logo

Related Topics:

1,980 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...