Question about Ford Van

Open Question

Gearbox oil level on ford rear wheel drive transit

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 151 Answers

SOURCE: 1989 ford escort cabriolet gearbox oil

is it manual tranny? if so u do so under the car by removing the fill up plug which is located on the side of the tranny on driver side of the car if i remember. The plug under the tranny is to drain it.

If u drain it, when u fill it back up, u do so until oil slightly spills out by way of that side plug.

Posted on Sep 09, 2008

  • 102 Answers

SOURCE: checking gearbox oil level on 92 Suzuki Swift manual

'92 Swift - LH side of diff housing, rearwards of the LH drive shaft. Has to be filled to this plug's level.

Posted on Sep 21, 2009

  • 1 Answer

SOURCE: there is for my gearbox oil level. How di i check

how many liters oil go into mersedes c220 auto 2005 gear box

Posted on Jan 19, 2010

agent91
  • 2100 Answers

SOURCE: 03 transit front wheel bearing

That doesn't mean you have to go out and buy a 37 mm wrench, the nut should be finger tight, if not a pair of channelock pliers will do. The nut just snugs up the bearing, too tight and it will cook. Pull the lock pin, spin off the nut, bump the rotor with a rubber hammer and the bearing should pop out in your hand, you have to replace the seal when you pull the rotor off. Sometimes the race on the inside gets stuck, sometimes it welds itself to the spindle, depends on how hot you got it, you should be able to tap it off with a hammer and a drive pin from the rear. If you can't get it to move, take a dremel to it and cut the thing in half. I hope this is what you are asking.

Posted on Feb 26, 2010

alicantecoli
  • 22156 Answers

SOURCE: ford transit diesel, clanking noise from gearbox,

an auto transit ,in europe thats sacrilage ,the best white van mans van around reduced to be being a granny wagon,have you no pride in its heritage ??? the fastest getaway bank hold up van in the business in 60s reduced to being tied up in a autobox ,tell me what engine you have and i have a manual gearbox shipped forewith ,The shame of it a macho mans white van turned into a granny wagon -----

Posted on Nov 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Gearbox oil grade for ford transit 2004 reg just go some ep80 -90 gl-4 will that be okay


sae 80 or 90 is usually good for everything unless EXTREME HOT AN HARD DRIVING (LIKE RACING)

Aug 08, 2015 | Ford Cars & Trucks

1 Answer

Grinding noise when driving no noise when parked jacked up and spun wheels no noise but found oil all round engine sump its a ford focus 03 tdci


Forget the oil leak thats just the rear end oil seal but the grinding noise is a wheel bearing for sure and as you go around a bend one way the noise lessens ,these cars are bulltet proof and the gearbox is stout so suspect a wheel bearing or ask a local mechanic to have a drive and get his opinion

Mar 08, 2014 | Ford Focus Cars & Trucks

1 Answer

2010 Peugeot 207 gearbox drain/filler/level bungs


The drain plug is situated on the final drive casing at the rear of the transmission (plug may need a square or hex drive wrench).

There is no level plug - the correct qty of oil must be measured and then poured in.
If Petrol 1.9 ltrs, diesel 2.0.

The oil is 75/80w.

Jan 19, 2014 | 2008 Peugeot 207 CC

1 Answer

Kia sportage transmission


MANUAL well their is only one in my eyes and that is EP90 front or rear wheel drive type manual gearbox although some older cars from the 50s specified engine oil like the morris /austin ranges even the old ford consuls could have this before the gears started to have syncromesh and helical cut gears ,showing my age here i think ?cars with no syncomesh ?? rod brakes and worm and wheel diff units .

May 26, 2013 | Cars & Trucks

1 Answer

96 ford wont go into park, drive, or reverse unless in 4 wheel low


Is this a auto or Manual I ask as you say flywheel and all gears. tall us a little more. what is the gearbox ?. have you looked at the oil level and under it at the rear tail shaft, crosses. in 2 wheel drive and running can you get it into park. DON'T try to hard at this as it can damage the auto. If you can drive in 4 wheel low in all gears then it sounds like you may have a problem in the drive line. Tall us more

Jan 07, 2013 | 1996 Ford Explorer

1 Answer

Ford transit diesel, clanking noise from gearbox, drives perfect noise is there in 1st 2nd 3rd gear but not in 4th. changed oil but no difference?


an auto transit ,in europe thats sacrilage ,the best white van mans van around reduced to be being a granny wagon,have you no pride in its heritage ??? the fastest getaway bank hold up van in the business in 60s reduced to being tied up in a autobox ,tell me what engine you have and i have a manual gearbox shipped forewith ,The shame of it a macho mans white van turned into a granny wagon -----

Nov 20, 2010 | Ford Transit Connect Cars & Trucks

1 Answer

Leaking transmission oil from the back of the gearbox and front axel on ford falcon 1991 eb wagon,post diagram of auto transmission box


YOU carnt have a transmission oil leak from the front axle on a Falcon as they are Rear wheel drive but could be the hose going to the radiator over the front end leaking But the rear end of G/Box should be only the OIL SEAL.

Sep 19, 2009 | Ford F Cars & Trucks

1 Answer

Automatic gearbox for a vw caravelle tdi 2000


check gearbox oil level ,,,,start engine and put in reverse with handbrake on and a couple of big bricks behind wheels and check level .Have a spare manual box in garden

Apr 08, 2009 | 1986 Volkswagen Wagon Camper

1 Answer

How do u check fluid level on a manual transmission


This has to be done form under the vehicle for a rear wheel drive vehicle. I am not too certain what is the setup for a front wheel drive, but from experience, there is ususally a bung that has to be slacked, and if fluid comes out, it means the level is ok. Or u can use ur finger to c how far from the ********* the oil level is at. The level should be somewhere around there. If not add oil. this bung is commonly located at about half way up the gearbox (manual transmission)

Jan 28, 2009 | 1995 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

498 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...